Determine result

Q: QUESTION 2 circuit as question 1, what is the impulse response, h(t)? Hint: Find the inverse Fourier…

A:

Q: If the electric field in the region is given as E = 2 (z ax - y ay + x az) V/m. Determine the…

A: Electric field is force per unit charge.  No net work is done in moving charge in closed path in…

Q: For a periodic signal v(t) = 30 sin 100t + 10 cos 300t +6 sin (500t + π/4), fundamental frequency in…

A: It is given that: V(t)=30sin100t+10cos300t+6sin(500t+π/4) V

Q: Exercise 2.9 Match each block diagram shown below with the corresponding fault tree.

A: The block diagram consists of three components 1, 2 and 3 connected in series. If there is fault…

Q: VIN R V= 34,11 V, RL = 2,59 k2 and VZ= 16 V PDmax=1,5 W Find Rmin? Vz 1,5W 6 P₁₂ VOUT

A: V=VIN=34.11 V VZ=16 V RL=2.59 kΩ PD max=1.5 W To find out We have to determine the Rmin value.

Q: Calculate the voltages at nodes 1 and 2 in the circuit given below using nodal analysis, where Is =…

A:

Q: Do you have any other suggestions for what Apple may do to address their heating, storage, and…

A: Heating, storage and battery problems are very common now-a-days. There is always some room for…

Q: 1. using Thevenin's Theorem, find the current through the 52 resistor ? Ans 202 in Vth 5√2 mu 3n 2√2…

A:

Q: The potential difference between two points in an electric field is 800,000 mV, and has done…

A: Given, The potential difference between two points in an electric field is Vab = 800,000 mV;…

Q: x [V] 1₂ y [ohm] ww z[ohm] The following circuit is given. a) Calculate the ia b) Calculate the io…

A:

Q: In a MOSFET operating in the saturation region, the channel length modulation effect causes (A) an…

A: We need to select correct option channel length modulation in MOSFET.

Q: A 100 kVA, 380 V, 50 Hz, Y-connected synchronmous generator was tested with a rated field crent…

A: In this question we need to find the internal generated voltage (Ea=?), stator resistance (Ra=?) and…

Q: The average value of V (1) will be -o+ KH Vmsin ot ww Vo(t) I

A: It is given that:

Q: 16 V -16 V 12 V For the given input waveform to the given circuit, what is the peak value of the…

A:

Q: 3.15 Simplify the following Boolean function F, together with the don't-care conditions d, and then…

A:

Q: Q10. The circuit below is subjected to both DC and AC excitation. Assume ideal op amp. Find Vo(t). 2…

A:

Q: 2. What is the total energy of the discrete time signal x(n) which takes the value of unity at n=…

A: xn=1,1,1

Q: Question 2 An electric circuit consists of a battery (voltage source) connected to a resistor and…

A: C=0.001 F=11000F V0=Vin=9 V R=100 Ω Rt=100+2t

Q: A)Draw the speed-moment characteristic of the induction motor.

A: Speed- moment characteristics of Induction Motor:

Q: What oscilloscope can replace the Hewlett Packard oscilloscope

A: We need to tell about oscilloscope those  can replace the Hewlett Packard oscilloscope.

Q: Vin ✈ + G₁ C₁ RL Vout Fier above drives a 320-02 load with a peak voltage of 3.25V. For a 250-μF…

A:

Q: In the circuit of Figure 2, the switch moves from position A to position B at t = 0. Determine v(t)…

A: In this question we need to find the voltage v(t) and current i(t) shown in the circuit for t>0

Q: Problem 2 Given the Din and select line inputs in the timing diagram below, sketch the output for D3…

A: For the given timing diagram the valud of output D3 of the demux needs to be drawn.

Q: Design a notch filter that meets both following specifications: (a) it eliminates 100 Hz, and (b)…

A: According to the question, we need to find the transfer function of a notch filter which meets both…

Q: The ac schematic of an NMOS common-source stage is shown in the figure below, where part of the…

A: We need to find out the lower cut off frequency for given MOSFET circuit.

Q: (4) Determine the region of operation of Q₁ in each of the circuits shown below. Assume Is = 5 x…

A: Saturation current; Is=5×10-16 Current gain; β=100 To find out We have to determine the status of…

Q: Shouldn't answer be in volts/degree?

A: The question was based on the calculation of the sensitivity of a potentiometer.

Q: 1. The characteristic equation for a teleoperated system is S+205³ + K₁S² + 4S + K₂ = 0, where K₁…

A:

Q: 1. Consider a continuous-time response_h(t) = e¯tu(t+1). x(t) = u(t + 2) - u(t-1). linear time…

A:

Q: For the circuit below, given Vcc (a) Choose component values such that the transresistance gain has…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: 5ΚΩ e + I L 10kΩ -15V 15V >5.6ΚΩ 4.7k 10nF

A:

Q: 3. A stepper motor has a step angle of 1.8° and is driven at 4000 pps. Determine (a) resolution (b)…

A: Given data:- The step angle is β=1.8° The stepping frequency is f=4000 pps

Q: 2/ Consider a CMOS inverter biased at VDD = 8v with transistor parameters of KN=Kp and VTN=- VTP =…

A: For the above given question we need to calculate the critical voltage on the voltage transfer curve…

Q: 4. (a) Sketch the magnitude and phase spectra of x[n] = {...,0, 3, 1, 2n-0, -1, 0, 3, 1, 2, -1, 0,…

A: Given: A discrete time periodic sequence,  x[n]=. . . . , 0, 3, 1, 2n=0, -1, 0, 3, 1, 2, -1, 0, 3,…

Q: kindly answer What are the two types of power supply voltage regulator circuits. Draw the block…

A:

Q: In the circuit in the figure Vcc= 25 V, Vi= 40 mV, RB = 470 kg. RC = 3.3 kg, RE1 = 470 G, RE2 = 1.2…

A: The output voltage Vo can be calculated by using the DC and AC analysis of the given amplifier…

Q: 3.3 The characteristic equation of a closed loop control system is s³ + 3Ks² + (K+2)s + 4 = 0. Find…

A: The characteristic equation is given as, s3+3Ks2+K+2s+4=0

Q: Consider the open loop transfer function k -2 -4 s+6 (s+3)(s+5)* In the root locus diagram the…

A: Transfer function is given as, G(S)=k(s+6)(s+3)(s+5)

Q: VIN R V= 43,68 V, RL = 2,77 k2 and VZ= 10,68 V PDmax=1,5 W Find Rmin? Vz 1,5W VOUT 4

A:

Q: 10) To wire a windlass on the bow of a 26' Duckworth Offshore, it is necessary to run 34' of wire…

A: The length of the wire, l=34 feet=10.36 m The current drawn by a windlass, I=70 A The resistivity of…

Q: A) What is the absolute potential for each of the following distances, measured from a charge of 2µC…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: (Example 4.9) Determine all node voltages and branch currents assuming B≥ 30. Start with assuming…

A: Determine all node voltages and branch currents of the given BJT circuit.

Q: Please find the admittance matrix of the circuit given below

A: In the given questions we need to calculate the Admittance Matrix of the given system.

Q: How do you design to 2-4 active low decoder?

A: The 2 to 4 active decoder circuit needs to be designed. The truth table can be derived and with the…

Q: Vs 10 Ro 12 R₁ R₂ ww R3 ww 6A a) Identify all nodes in the circuit including redundant nodes, join…

A: In this question,  We need to determine the number of nodes and all unknown currents.  We are…

Q: Describe three instances where digital instruments may be beneficial. Was careful consideration…

A: Digital instruments, or electronic instruments, have many potential benefits compared to their…

Q: What is the voltage across 4 0 resistor in the given circuit? 492 ww 3 V O 12 V O -1.2V O-0.8 V O…

A: Circuit diagram is given as,

Q: For the Feedback system below find: open loop gain, Input and output impedances (Rin, and Rout) O…

A: According to the question, for the given common gate circuit as shown below We need to calculate,…

Q: Solve the initial value problem below using the method of Laplace transforms.…

A:

Q: In the circuit in the figure, ai and Bv, are dependent sources. What are the units of a and ß?…

A: