Determine the amplitude of the voltage at the output Vout(t), giventhe following:R₁ = 72, R₂ = 82, C = 6mF, and Vin(t) = 6 sin(96t)V(Give your answer as a positive number)40CVin(t)40R₁R₂+Vout(t)

Answered: Image /qna-images/answer/2c7c6605-aa7d-450c-ba2e-e6c495eb185e.jpg

Determine the amplitude of the voltage at the output Vout(t), given the following: R₁ = 72, R₂ = 80, C = 6mF, and Vin(t) = 6 sin(96t)V (Give your answer as a positive number) 40 C Vin(t) 40 R₁ R₂ + Vout(t)

Determine the amplitude of the voltage at the output Vout(t), given the following: R₁ = 72, R₂ = 80, C = 6mF, and Vin(t) = 6 sin(96t)V (Give your answer as a positive number) 40 C Vin(t) 40 R₁ R₂ + Vout(t)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter16: Inductance In Ac Circuits

Section: Chapter Questions

Problem 1PP: Inductive Circuits Fill in all the missing values. Refer to the following formulas:...

See similar textbooks

Related questions

Q: Place your final answers for this problem in the correct boxes at the bottom of this page. Use the…

A: The circuit diagram,The value of resistor,The inductance, The supply voltage,

Q: Apply source transformation to determine the output voltage Vo: 3ΚΩ 2ΚΩ 3ΚΩ www ww www δηλαδή το +…

A: Given:Required: We need to use source transformation to find the output voltage V0.

Q: 3. Find the inverse z-transform of each of the following z-transforms. Determine the poles and zeros…

A: Given:Required:We need to find inverse z-transform for each of the given signals.

Q: What is the Boolean expression for the given circuit shown in the figure below? A-D B-D C-D Z

Q: 2.2 A three-phase synchronous generator has a reactance of 1.5 p.. and negligible resistance. It…

A: Solution of question (2.2):The given information about a three-phase synchronous generator is given…

Q: 20V 10 5 30 50 20 30 10 Solve P, I, & V for each resistor

A: Given circuit,Asked to find solve power(P), current(I) and voltage(v) in each resistor?Note: since…

Q: P9.77. A certain diode has IDQ = 4 mA and id (t) = 0.5 cos (200πt) mA. Find an expression for ip…

A: A certain diode hasIDQ=4 mA.id(t)=0.5 cos(200πt) mA.We need to find and sketch iD(t).

Q: b. Draw input and output wave form for the circuit in (fig. 2). Note: (D₁ and D₂ are ideal).

Q: + 10 Ω ww 20 V a 10 Ω 6 Ω Ix b 5Ω 12 A Find the Thevenin equivalent looking into terminals a-b of…

A: Thevdnines equivalent circuit consists of a voltage source in series with the resistance. The…

Q: A: Define the amplitude modulation (AM), state the types of AM. For the circuit-diagram given below:…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: 1.1 A three-phase synchronous generator with negligible armature resistance has synchronous…

A: The synchronous reactance, The terminal voltage, The current supplied,The power factor,

Q: Use Norton's theorem to find Vo in the circuit of the figure. Take R= 4 kQ. 36 V 12 ΚΩ www 24 ΚΩ The…

A: Given:1Required:Using Norton's theorem we need to find the output voltage V0.

Q: a) A distance relay measures the distance of the line and compares it to a pre-set value. b) A…

A: Distance Relay:It is also known as impedance relays, are a type of protective relay used in power…

Q: QUESTION 3: Figure 13.10 shows AC equivalent circuit for 741 Input Stage. Given that = 200, V=50 V,…

Q: Match the circuit on the left to a magnitude response on the right. Drag (inside the square) the…

Q: A 0.360-m-long metal bar is pulled to the left by an applied force F. The bar rides on parallel…

Q: The maximum electric field in a reverse-biased GaAs pn junction at T = 300 K is to be limited to…

Q: The electrical power (P) dissipated by an incandescent lamp is directly proportional to the square…

Q: Find the Vo value for the circuit given.

A: Given:An op-amp circuit,To find:The value of output voltage.

Q: In the circuit shown i(0) = 10A. Find v(t) & i. (t) for t≥ 0. 0.1 H a 4, 452 www 292 b + -13

A: Given:A network, with, To find:

Q: 3. Below is a circuit with four branches. The currents I₁ and I2, and the emf &₁ are unknown. The…

A: The circuit diagram,

Q: Consider the unity feedback system shown below. Determine the range of values of K for which the…

A: In this question, we need to determine the range of the K for stable and oscillation frequency and…

Q: For circuit in Figure Q4(b), (i) (ii) calculate 1₁, 12, V₁and V₂. determine the power dissipated in…

Q: Three message signal each bandlimited to 5KHz are multiplexed using FDM. Guard band is 1KHz. Find…

Q: Question 2. A closed loop feedback system is used to control the altitude of a spacecraft. Create…

Q: The advancement of smart antenna technology has been observed?

A: Smart antenna technology has already made significant advancements, and it is reasonable to expect…

Q: TRANSCRIBE THE FOLLOWING TEXT IN DIGITAL FORMAT

A: We need to transcribe the given text into digital format.

Q: Determine the R2 value for the summing amplifier given below so that the output voltage is -6V.…

Q: 3- v3100 mH If the current i (t) = 100e-10 A, the voltage across the inductor at t = 0 is

Q: A linear time-invariant system has the following sys- tem function 1 H(2)= 1- 4 1-2z¹ (1) The system…

A: It is given that:

Q: इ. Find the value of the voltage I for the circuit of Fig. 5. ZA A 2.J & Ux m 2 - 2√x Fig. 5.

A: In this question we need to determine the voltage V as shown the circuit.we are solving this problem…

Q: Please explain the working of this circuit.

A: The circuit provided is shown below:

Q: If 6 (t) is a unit impulse function, then the value of integral e¯¹8 (2t − 2) dt equals to

A: It is given that:

Q: (RL-Circuit). Model the RL-circuit in Fig. 66. Find a general solution when R, L, E are any…

Q: In the circuit below find the expression for the current in the secondary (in phasor form) by…

Q: ontage. Vs, (+10 V 11 = 0 www 10 KS2 a -O + Voc 2.2 KS2 b 2.2 ΚΩ -1.7 KS2 m 3,3 ΚΩ VS-₂ 1 + 6 V ww 1…

Q: 454 - ↑ Vi { Imr мл покл Find a) Vo/Vi b) Ro' c) Vo if Vi=10mVp-p D (27 900 € n R= 15K us I не…

A: To find the following questions,a) ,b) ,c) .Refer the diagram in the given question.

Q: 4) Sketch the speed current characteristic for a common DC motor and describe the motor performance.

A: We have to sketch the speed current characteristic for a common DC motor and describe the motor…

Q: Find f when: i. A = 0, B =1, C=1: F = ... ...

A: According to the question, for the given mux circuit as shown belowWe need to find the output under…

Q: A planar LED is fabricated from gallium arsenide which has a refractive index of 3.6. Calculate the…

Q: Calculate the phase (in degrees) of the equivalent impedance seen by the source. Given w = 4rad/s,…

A: For the given circuit the phase of the equivalent impedance looking from the input source needs to…

Q: Determine Io.

Q: 2. Lines of the magnetic field produced by along straight wire carrying a current are: a. in direct…

Q: DA- DB N Given the above full bridge convertor operates in Bipolar Mode, V-156V, E-22V, 1= 5.1A (NB.…

A: The full bridge converter circuit is shown below,The above circuit is operating in bipolar mode.

Q: What is the main line current of this circuit in amps? 7 8 15 25 E=120 volts I Click questi R1 = 40…

A: We use Ohm's Law: V= IR. Voltage (V) across an electrical circuit is proportional to the current (I)…

Q: Q3 A self-blas circuit configuration of a depletion n-channel MOSFET is shown in Figure Q3. (e)…

A: For the given circuit the value of input impedance, output impedance and voltage gain needs to be…

Q: V = 21 V, R1 = 200 Ω, R2 = 1,000 Ω, R3 = 1,400 Ω, R4 = 1,750 Ω. What is iR4 and iR2 and thus What…

A: The circuit diagram,The resistor,

Q: Ra • 100 ΜΩ + 20 V • = ' RD = 2 kΩ ID = 6 mA R, = ΙΚΩ

A: Given Data:A JFET amplifier with,Drain currentDrain resistance Source resistance Gate resistance…

Q: Determine the power delivered (in W) by the AC voltage source in the circuit below? The AC voltage…

A: It is given that:

Q: frequency of 1kHz. The system samples the signals at a rate of 20,000 samples per second, What is…

A: Given Data:A digital communication system with,Maximum frequency Minimum frequency Sampling rate…

Question

100%

Determine the amplitude of the voltage at the output Vout(t), given
the following:
R₁ = 72, R₂ = 82, C = 6mF, and Vin(t) = 6 sin(96t)V
(Give your answer as a positive number)
40
C
Vin(t)
40
R₁
R₂
+
Vout(t)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the circuit

VIEW

Step 2: Calculate the value of Amplitude

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Capacitive Circuits Fill in all the missing values. Refer to the formulas that follow. XC=12fCC=12fXCf=12CXc Capacitance XC Frequency 38 F 60 Hz 78.8 400 Hz 250 pF 4.5 k 234 F 10 kHZ 240 50 Hz 10 F 36.8 560 nF 2 MHz 15 k 60 Hz 75 nF 560 470 pF 200 kHz 6.8 k 400 Hz 34 F 450
Select all correct statement(s):1, The equivalent resistance for resistors in parallel is the harmonic mean of all resistors;2, The equivalent capacitance for capacitors in series is the sum of all capacitors;3, The equivalent inductance for inductors in series is the sum of all resistors.32None of them is correct1
The following circuit is at steady state before the switch closes. Find the inductor current after the switch closes. -2t Ans: i(t) = 0. 3 – 0. 2e t20 - SW1 16 Q 10 Q 12 V 20 H
#2. Express the following sin function in positive amplitude cosine form: (i) 408 sin (wt-60°) (ii) -200 sin (6t)
A voltage of 10V RMS 520Hz is applied across a 20mH inductor. Calculate the RMS current through the inductor. 78.2mA RMS 153mA RMS 108mA RMS 221mA RMS
A-coil has a resistance of 60Ω and an inductance of 0.75H. If the current flowing through the coil is 4amps. What will be the rms value of the supply voltage if its frequency is 60Hz.
3. For a sinusoidal input of 20 Vpe to the given circuit, what is the peak value of the output waveform? V-5V a) 20 V b) 25 V c) 0 V d) -25 V
In the following figure, the switch is left in position a for a long time interval and is then quickly thrown to position b. Find and rank the magnitudes of the voltages (V, VL, VRI, Vr2) across the four circuit elements a short time thereafter from the largest to the smallest. Vs 12.0 V 2.00 H 1 200 0 VRI 12.0 0 Vr2
Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz
Determine and Sketch the output waveform for the sinusoidal input 3 V v; o 2.2 k2 + +8 V + I k2 Si Si -8 V (a) (b)
a student is doing work on circuit in which he employs a voltage af 60 sin(314t+60) by observing the peak voltage determine following below calculate the form factor of the circuit a=1.87 b=1.59 c=1.11 d=1.48
what is the DTFT of sin(n)/n