Part A The 180-kg spool has a radius of gyration about its mass center of ke = 300 mm. If the couple moment is applied to the spool and the coefficient of kinetic friction between the spool and the ground is 44 = 0.2, determine the angular acceleration of the spool, the acceleration of G and the tension in the cable. (Figure 1) Determine the angular acceleration of the spool. Express your answer to three significant figures and include the appropriate units. HẢ ? Value Units Submit Request Answer Part B Determine the acceleration of G. Express your answer to three significant figures and include the appropriate units. Figure < 1 of 1> ac = Value Units 0.4 m. Submit Request Answer B 0.6 m Part C M = 450 N-m Determine the tension in the cable. Express your answer to three significant figures and include the appropriate units. HA ?

Part A The 180-kg spool has a radius of gyration about its mass center of ke = 300 mm. If the couple moment is applied to the spool and the coefficient of kinetic friction between the spool and the ground is 44 = 0.2, determine the angular acceleration of the spool, the acceleration of G and the tension in the cable. (Figure 1) Determine the angular acceleration of the spool. Express your answer to three significant figures and include the appropriate units. HẢ ? Value Units Submit Request Answer Part B Determine the acceleration of G. Express your answer to three significant figures and include the appropriate units. Figure < 1 of 1> ac = Value Units 0.4 m. Submit Request Answer B 0.6 m Part C M = 450 N-m Determine the tension in the cable. Express your answer to three significant figures and include the appropriate units. HA ?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The Center of gravity of the 850 N man is at G. If the man pulls on the rope with a 388 N force, determine the diatance "b" between man's feet ang G.
A cable is attached to a 2.20 kg block A, is looped over a fixed peg at C, and is attached to plate B.(Figure 1) The coefficient of static friction between the plate and the block is μA= 0.180, the coefficient of static friction between the plate and the inclined plane is μB = 0.380, and the coefficient of static friction between the cable and the peg is μC= 0.450. If the plane's angle is 30.0 degrees, what is the maximum mass that plate B can have such that it does not slide down the plane?
The 4-lb pulley has a diameter of 1 ft and the axle has a diameter of 1 in. If the coefficient of kinetic friction between the axle and the pulley is μk = 0.20, determine the vertical force P is applied horizontally to the left on the rope required to lift the 20-lb block at constant velocity.
This is a Dynamics of Rigid Bodies subject. Thank you:) In the system of weights shown, the 400-N block has a tendency to move up the 36 ° incline due to the pull of the 600-N block. The coefficient of kinetic friction between A and the incline is 0.25. Assume the pulleys are weightless and frictionless. ( Note : The acceleration of Block A is twice the acceleration of Block B ) a. What is the acceleration of Block B?b. What is the tension in the cable?c. What is the velocity of Block A after 4 seconds?
The 4-lb pulley has a diameter of 1 ft and the axle has a diameter of 1 in. If the coefficient of kinetic friction between the axle and the pulley is μk = 0.20, determine the vertical force P on the rope required to lift the 20-lb block at constant velocity.
We have a table that we seek to lift with a pulley. The table is uniform, with a weight of 73 Newtons, it is suspended by means of a cable 2.7 meters long, which is attached to the sides of the table and passes through a small pulley located at O. Determine the tension of the cable if: d1=0.43 m d2= 1.14 m
A supporting rope is loaded with a line load q(x) = q0 between points A and B. The rope shall be stretched such that the slope of the rope at point A is zero. If l = 10 m and h = 2.3 m, determine the (a) horizontal tensile force and (b) the maximum force in the rope. q0 (kN/m) = 20.627
Very urgent. The box in the figure is connected by a cable from point A to point B. If the stress T in the cable is 5kN, calculate the Moment Mo of this force to point C. A(0,0,5m), B(2m,5m,0), C(4m,0,0)
A flat belt connects pulley A to pulley B. The coefficients of friction are ms = 0.25 and mk = 0.20 between both pulleys and the belt. Knowing that the maximum allowable tension in the belt is 600 N, determine the largest torque (in N.m) which can be exerted by the belt on pulley A.
The cargo box as shown weighs W = 1200 lb. The force P = 800 lb is just sufficient to lift the box off the floor. The 2-D concurrent force system of the joint O is shown as well. Using the equilibrium equations: ∑ ???= 0 ; ∑ ???= 0, 1) Determine the tension force in the cable T;2) Determine the corresponding value of β
The cable of the tower crane is subjected to 840 N force, the magnitude of the moment of the force F about A is hint. Determine the moment of the force F in Cartesian vector form,then deduce the magnitude.
The mass of the building crane’s boom in Figure2 is 9000kg. Its weight acts at G. The sum of the moments about P due to the boom’s weight, the force exerted at B by the cable AB, and the force exerted at C by the cable AC is zero. Assuming that the tensions in cables AB and AC are equal, determine the tension in these cables