Determine the Anode to cathode voltage of a certain 4- layer diode which is biased in the forward- blocking region. The anode current is 2.5 uA and the resistance of the diode is 6MΩ

Q: Using ideal diode model, the current I passing through the diode is equal to lov lov - 1.46mA 1.6mA…

A:

Q: Determine the current through the diode. Use practical diode model, Vf=0/7V. Express your answer in…

A:

Q: R, = 5 kn R, = 5 kn ER, = 5 ka -10V -5V If the cut-in voltage of all the diodes equal to 0.7 V on…

A: Considering all the diodes are conducting that means in ON state, the circuit is drawn as:

Q: For the following circuit, as we increase the load resistance R, the diode current Ip increases.…

A: In this question , we will find relation between load current and load resistance ..

Q: D1 +5 V +1 Vo +2 Vo OV 2 kn D2 2 kn +1 Vo- 本 +2 Vo- -5 V 2

A: Given 1)

Q: Determine the current through 480, use silicon for the diodes and forward resistance of each diode…

A:

Q: Problem No.2. Two parallel Diodes (both are Si) is connected in series with a1 kilo Ohm resistor. A…

A:

Q: Q5. The diode is considered shorted when both anode and cathode has a) Low resistance b) High…

A: A short-circuit represents very low resistance(ideally zero). When the voltage across both the…

Q: In a circuit that composed of a single diode that connects an AC source to a load. the diode acts as…

A: 1)  We know Diodes conduct only when they are forward biased.  In reverse bias diodes are treated as…

Q: 3. Find the current in the Silicon diode in the following circuit. Diode's I-V curve is given below.…

A:

Q: 2. Determine Vo for the network shown for the input indicated when: (a) Ideal diode , (b) Silicon…

A:

Q: 27. A series circuit is composed of a 9 V battery, a diode, and a 1000-ohm resistor for a forward…

A:

Q: How many capacitors are used in a diode-capacitor half- wave voltage doubler? 2 An improvement of a…

A:

Q: Quèstion 8 Using ideal diode model, the current I passing through the diode is equal to 00v- lov 2V…

A:

Q: What is the output voltage across a load resistor if it is paralleled with a forward biased silicon…

A: Diode will forward bias . So output voltage for load will cut in voltage .

Q: R, = 5 kn R, = 5 kn R, = 5 ka -10V -5V If the cut-in voltage of all the diodes equal to 0.7 V on…

A: Assuming all the diodes in the ON condition, then the circuit is redrawn as:

Q: What is the current through the diode? IDEAL_ DIODE R 12 kn 12 V Select the correct response: 0.942…

A:

Q: A silicon diode is in series with a 1 Kilo ohms resistor and a 5V battery. If the anode is connected…

A: The solution can be achieved as follows.

Q: For the circuit shown find the maximum and minimum values of zener diode current. 5kQ2 IL I 80-120 V…

A:

Q: Please fill the table below. Vp = 0.7V for both diodes. 1. State which diode is on. 2. Replace the…

A: Given diode voltage Find out the Output voltage and current

Q: 3 Series Diode Configurations 5. Determine the current I for each of the configurations of Fig. 155…

A: Since you have posted the multiple questions so we are supposed to answer first one.

Q: 2. Sketch Vo and IR for the following circuit. 10k2 VIA 10V ideal diodes +. Vo 2V -10V please answer…

A:

Q: 5/ Repeat Problem infig, if the diode is Si Cuse Constant Voltage drof model). 4,6kn ID tHove No 2.2…

A: The diode is ON when the voltage across anode is more than the cathode voltage. It is known as…

Q: The process that breaks some of the covalent bounds is called: valence doping thermal generation…

A: Doping is the process of adding impurity in intrinsic semiconductor . For example trivalent impurity…

Q: Vo and the required PIV Tating of each maximum curent through 12. Determine diode and also determine…

A: In reverse bias, PIV is the maximum voltage that should be provided to the diode. Because the diode…

Q: A silicon diode has a forward voltage drop of 1.2V for a forward DC current of 100mA. It has a…

A:

Q: Which of the following Special Purpose Diodes is used to convert solar energy to electrical energy:…

A: Special purpose diode

Q: Find the voltage across the resistor R if VA = -3V and VB = -5V. Use ideal diode model assumption.…

A: The solution is given below

Q: Which of the following Special Purpose Diodes is used to convert solar energy to electrical A)…

A: The explanation is as follows.

Q: 50. A series circuit is composed of a 9 V battery, a diode, and a 1000-ohm resistor for a forward…

A:

Q: If the diode is open in the figure shown, the anode-cathode voltage of the diode is * -12.7V R1…

A:

Q: the minimum value of RL to ensure that the Zener diode is in the "ON" state 20 V IR 0.18 ΚΩ 0.47 ΚΩ…

A:

Q: •Vss =5 V and R=0.5 km ,For the shown circuit Vss 文 vp :The diode current is A 1.5 mA 8,5 mA 20

A: Fig: Given circuit  In the given circuit diode is forward bias  Assume that voltage drop…

Q: The diode shown in the below circuit is a short circuit. Ge 5V a 2.2ks2

A: TRUE

Q: 2. A diode has Iş = 10 pA. At Vp = 0.625 V and T= 300 °K, what is Ip? %3D

A: Given data, Is=10 pAVD=0.625T=3000K

Q: d) In the circuit shown below, VD 0.3V for Ge diode D2 only, D1 is Ideal Diode. 1. Find output…

A: A diode is a two terminal PN junction device, the two terminals of a diode are anode and cathode.…

Q: If the diode for the given circuit below is a Silicon diode, how much is the maximum positive…

A:

Q: For the circuit below Junction voltage is 0.7V the +ve and -ve peak of the output waveform is +10V…

A:

Q: A Germanium p-n junction diode has a reverse saturation current of 3.97 x 10-19 A at room…

A: The p-n junction diodes produced using silicon semiconductors works at high temperature than the…

Q: Draw for the networks shown below, th (1) Ri 1.0k2 +10V Vi 0- 5V -10 V Diodes are IN914.

A: Given : The forward drop voltage of the silicon diode is  Vd= 0.7V.   In the question they have…

Q: 2. A silicon diode is in series with 1K2 resistor and a 5V battery. If the anode is connected to the…

A: In this question,  We. Need to determine the voltage across the cathode terminal w.r.t of the…

Q: Q. The Diod (semiconductor) has Is (saturation) Current= 0.01A 0,0 and VD = lov find the In wahen…

A: we need to find out diode current.

Q: (b) Find the inductor current, I(t), when t > 0 in the following circuit. The switch is initially…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: In the voltage regulator the Zener diode current is to be limited to the range 5 <i, 100 mA. 120 V,…

A: Zener diode is heavily doped semiconductor that conduct in forward and reverse direction In forward…

Q: D1 1 kQ ww D2 1.5 k2 ww. 150 2 www

A:

Q: The output for the following clamping circuit is shown below assuming ideal diode calculate the…

A: Ideal diode- A diode is said to be ideal when it behaves as a conductor if it connects in forward…

Q: If the diode for the given circuit below is a Silicon diode, how much is the maximum positive…

A: solve for output voltage

Q: 1. Calculate the current through 48 Qresistor in the circuit. Assume the diodes to be of silicon and…

A: Given  Voltage V = 10 V R1 = 48 ohm Forward resistance of each diode is 1 ohm

Q: If the diode is open in the figure shown, the anode-cathode voltage of the diode is * -12.7 V R1…

A: For the given diode circuit we need anode to cathode voltage of the diode.

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.