Determine the change in the elevation of the mercury in the left leg of the manometer of Figure below as a result of an increase in pressure of 5 psi in pipe A while the pressure in pipe B remains constant. 7. ,Water Oil (SG = 0.9) to 6 in. 12 in. 18'in. in. diameter 30 in. Mercury diameter

Determine the change in the elevation of the mercury in the left leg of the manometer of Figure below as a result of an increase in pressure of 5 psi in pipe A while the pressure in pipe B remains constant. 7. ,Water Oil (SG = 0.9) to 6 in. 12 in. 18'in. in. diameter 30 in. Mercury diameter

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 23. The surface lenson of water in contact with air is given as 0.0725 N/m. The pressure outside the…

A: Difference in pressure Inside and Outside of droplet is given by

Q: Q 1: A piezometer was connected to a pipe to measure the pressure of water. The rise of water level…

Q: Water is flowing through a venturimeter shown. The difference in pressure between Point 1 (D = 4cm)…

Q: а. Explain the law of hydrostatic pressure that most comprehensively describes the operation of a…

A: Given data Hydrostatic law Manometer Specific gravity Water Oil Depth

Q: Water is flowing through a venturimeter shown. The difference in pressure between A (D = 5cm) and B…

A: Given data in question Diameter Head loss To find out Velocity head at A

Q: identify the type of manometer and then solve. Determine the difference in 02 pressure between A and…

A: The given data is: h1=0.2 m h=0.15 m h2=0.3 m SGoil=0.862

Q: liquid d=0.7 water 260 mm %3D 1.0 m

Q: 25. If the capillary rise of water in 1 mm diameter tube is 3 cm, the height of capillary rise of…

Q: a. Given that: Barometer reading = 740 mm of mercury Specific gravity of mercury = 16.6; Intensity…

A: Answer (a) SI unit of pressure is Pa or N/m2 We are given gauge pressure Pgauge = 40 Kpa gauge…

Q: Water is flowing through a venturimeter shown. The difference in pressure between Point 1 (D = 4cm)…

Q: Q: A Mercury manometer is attached to a pipe having suction pressure. the right limb is open to the…

Q: Based on the provided differential-type manometer, calculate the difference in the pressure between…

Q: Air (p = 1.2 kg/m3) flows through an orifice plate set in a pipe of 400 mm diameter. A water…

A: Given Data: The density of air is ρ=1.2 kg/m3 The diameter of pipe is d1=400 mm. The area of the…

Q: r per second through a pipe. A horizontal venturi meter with throat diameter of 150-mm was used to…

A: We know the formulaQ=A1A2A12-A222ghh=x(SmSw-1)h=1.2(1.61-1)=0.72m

Q: Topics: Fundamental of fluid flow A venturi meter with a throat diameter of 6 cm is fitted in a…

Q: 1. The right limb of a simple U-tube manometer containing mercury is open to the atmosphere while…

Q: Two water tanks are connected to each other through a mercury manometer with (b) below. If the…

Q: 2. A U-tube manometer is connected to a closed tank as shown in Fig. below. The air pressure in the…

Q: Convert the following pressure readings from millimeters of mercury to pascal:a. 28.5 mm Hgb. 30.5…

Q: Water is flowing through a venturimeter shown. The difference in pressure between A (D = 5cm) and B…

Q: Water is flowing through a venturimeter shown. The difference in pressure between Point 1 (D = 4cm)…

A: APPLYING BERNOULLI'S EQUATION IN FIRST STEP HAVING TWO UNKNOWNS V1 AND V2 THEN APPLY CONTINIUITY…

Q: Water is flowing through a venturimeter shown. The difference in pressure between A (D = 5cm) and B…

A: Given data in question Diameter Head loss To find out Discharge

Q: 10. Which device is popularly used for measuring difference of low pressure? a) Inverted U-tube…

A: Fluid mechanics is the discipline of physics that studies the mechanics of fluids (liquids, gases,…

Q: B- A manometer with u-tube shape is connected to a closed tank. The air pressure in the tank is 7…

A: PA = 13KPa Pair = 7KPa γo = 8.95KNm3 γw = 9.8KNm3

Q: A horizontal venturimeter with inlet and throat area as 706.858 cm2 and 176.715 cm2 respectively is…

A: We have to determine the value of rate of flow of the horizontal venturimeter with inlet and troat…

Q: 3.64 For the manometer shown in Fig. 3.28, calculate (pA - PR). Oil (sg = 0.85) 8 in Water 33 in 12…

Q: C.6 (a) A manometer shown in Fig. C.6a is used to measure the pressure difference between two points…

Q: Problem 2-30 A closed cylindrical tank contains 2 m of water, 3 m of oil (s = 0.82) and the air…

Q: Problem 3 The pressures Pa and Pg in the differential manometer gage are 154.415kPag and 150 kPag…

Q: For the shown inverted manometer, all fluids are at 20°C. If P, - P = 130 kPa, what must the height…

Q: The Pitot tube and a wall piezometer tube are connected to a water-mercury manometer which registers…

A: Asked: To determine the pressure head difference (meters of water) and the velocity approaching the…

Q: 1.28 Calculate the capillary rise in a glass tube of 2.5 mm diameter when immersed vertically in (a)…

Q: Determine the flow of oil through the pipe if the difference in height of the water column in the…

Q: Find the depth of the water in the tank, H, and the manometer reading, h, if the hydrostatic force…

Q: Q1: Calculate the pressure at point A in a water flow. If the pressure at B is 87 kPa. Assume all…

Q: For the differential manometer shown. (a.) Find the H (in inches) if pressures at A is 9psi and Bis…

Q: 4. The open tank shown in the figure have 2 piezometers attached on one side, containing two…

Q: GA manometer is made of a tube of uniform bore of 0.5 cm2 cross-sectional area, with one limb…

Q: 2.46 Determine the change in the elevation of the mercury in the left leg of the manometer of Fig.…

Q: Pressure gage A reads 75kPa, while pressure gage B reads 82kPa in a pitot tube. Find the actual…

A: vTheoretical=2gh

Q: Problem #09 A manometer consists of an inclined glass tube which is connected to a metal cylinder…

Q: What is the pressure difference (Pa - PB) measured by the U-tube manometer shown in the figure…

A: Let PA and PB be the pressure at A and B Consider the datum line along A, The upper portion above…

Q: Fill in the blank: The elevation of point A in the right-hand column of the manometer liquid is…

A: The diagram is shown below, To determine the manometer liquid is.....?

Q: 7) For the manometer setup shown, determine the difference in pressure between A and B. Ho1l, s =…

Q: 9. A simple manometer is used to measure the pressure of oil (sp. gr. = 0.8) flowing in a pipe line.…

A: Step 1

Q: B4. An orifice meter with orifice area 1060 mm2 is inserted in a pipe of area 2120 mm² .The pressure…

A: there is typing mistake in question so i am taking oil instead of water

Q: Water is flowing through a venturimeter shown. The difference in pressure between Point 1 (D = 4cm)…

A: Given: The diameter at point 1 is 4 cm. The diameter at point 2 is 2 cm. The value of h is 50 cm.

Q: For the fo type of manometer an Determine the difference in pressure between A and B in kPa if h =…

A: Given Data: h=0.15 and SG of oil =0.662 To Calculate: Pressure difference in pipe using…

Q: The inclined-tube manometer shown in the figure below is used to measure smal pressure changes.…

A: Given data Unit weight of mercury, γ=846 lb/ft3Unit weight of water, γw=62.43 lb/ft3

Concept explainers

Thermal Processes

Some of the key areas where thermal processes find their application are:

Question

7.
Determine the change in the elevation of the mercury in the left leg of the manometer of Figure below as
a result of an increase in pressure of 5 psi in pipe A while the pressure in pipe B remains constant.
Water
Oil (SG = 0.9)
6 in.
18 in.
12 in.
in. diameter
30
in.
diameter
Mercury

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3) A differential manometer is connected at two points A and B of two pipes. The pressure at A and B are 1 bar and 2 bar respectively. Find the difference in mercury level in the diffrential manometer. (12
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?). SG of oil is 0.8 . Provide solution in finding the height.
Calculate the pressure difference between points A and B for the differential manometer below.
For a Gage Reading of 25.3 Kpa, determine the following: (a). Elevations of the liquids in the open piezometer columns E, F and G. (b). The deflections of Mercury in the U-tube manometer neglecting the weight of air.
Calculate the pressure difference between points A and 13 in the differential manometer shoon."
A vertical conduit is carrying oil (S = 0.95). A differential mercury manometer is tapped into the conduit atpoints A and B. Determine the difference in pressure between A and B when h = 3 in. What is thedifference in piezometric head between A and B?
Based on the provided differential-type manometer, calculate the difference in the pressure between points A and B (as in Δp = pA - pB = ?). SG of oil is 0.8
Convert the following readings of pressure to kPa absolute, assuming that the barometer reads 760 mm Hg: (a) 90 cm Hg gage; (b) 40 cm Hg vacuum; (c) 100 psig; (d) 8 in. Hg vacuum, and (e) 76 in. Hg gage.
Q/ Compute the prassure at point B in the Pipe of water if heigt h is: 0.3 m. and the difference heigh mercury In manometer is z = 0.4m
(a) Determine the height water at 70F will rise due to capillary action in a clean, 1/4-in.-diameter tube. (b) What will be the height if the diameter is reduced to 0.01 in.? At this temperature, water = 0.00497 lb/ft and water = 62.3 lb/ft3 . Use  = 0degrees
A pipe carrying oil of sp gr 0 877 changes in A pipe carrying oil of sp gr 0.877 changes in size from 150mm at section E to 450mm at section R Section E is 3 66m lower than R section R. Section E is 3.66m lower than R and the pressures are 91.0kPa and 60.3kPa, respectively. If the discharge is 0.146m3 respectively. If the discharge is 0.146m /s, determine the lost head and the direction of flow.
oil (SG = 0.88) dischargesfrom a pipe (D = 13 in.) through a sharp-crested, round orifice (diameter = 5 in.), as shown. the coefficients of contraction and velocity are 0.619 and 0.967, respectively. find the actual velocity (in ft/s) in the jet. Point (1) is a point collinear with the orifice at point (2). Point (3) is the free surface of the manometer containing mercury. use h = 2.84 ft., and y = 7.42 in.