Determine the correct classification, including group index (GI) for the following soils using AASHTO classification system and state whether this soil is suitable for pavement use. Percent Passing Soil LL PI No. 10 No. 40 No. 200 1 100 92 66 45 13

Determine the correct classification, including group index (GI) for the following soils using AASHTO classification system and state whether this soil is suitable for pavement use. Percent Passing Soil LL PI No. 10 No. 40 No. 200 1 100 92 66 45 13

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Question 4 Critically evaluate the degree to which soil water washing is an effective method for…

Q: Define the major types of soils and their classification systems.

A: Types of Soils : 1. Alluvial Soil: a. It is water transported soil. b. The type of soil…

Q: What is the purpose of soil classification tests?

A: The aim of a soil classification system is to group soils with similar properties or attributes…

Q: b. Determine the percentages of gravel, sand, silt and clay according to the MIT system. c. Repeat…

A: To Determine: The percentage of gravel, sand, silt and clay according to the MIT system and USDA…

Q: A contactor has compacted the base course for a new road and found that the mean value of the test…

A: Has the contractor complied to with the specifications?(calculate void ratio e )

Q: A grassy drainage area is paved with asphalt. What happens to the time of concentration? 1.…

A: By paving the drainage area with asphalt, the time of concentration will decrease, since the water…

Q: Explain the shape of vma vs asphalt content curve.Also describe dry vma and wet vma

A: The objective of this study is to evaluate the effects of aggregate shape on volumetric properties…

Q: Give a summary of rigid pavement design procedure by AASHTO method (1993), and describe the…

A: 1. Summary of Rigid Pavement Design Method: Design procedure of a rigid pavement as per AASHTO…

Q: What is percentage of gravel of soil A

A: Given,

Q: The sieve analysis data for a granular soil are given below. • % passing 76.2 mm sieve = 98 • %…

A: Look at % passing thorough 0.075 mm=16%<35% so GRANULAR MATERIA

Q: A slab has a dimension of 0.10 meter thick, 6 meters wide and 10 meters long, Considering the slab…

A: Volume = Length * Width * Height = 0.1 x 6 x 10 = 6m3 Determine the concrete mix…

Q: Differentiate between two methods of soil investigation

Q: Choose one country, determine and write the 1. Pavement Management 2. Railway Management

A: INDIA. PAVEMENT MANAGEMENT Road Transportation occupies a very dominant position in the overall…

Q: lassify the soils using the USDA Textural Classification System Soil Sand Silt Clay Gravel (%) A 55…

A: Textural Classification system developed by USDA is given below: (a) Soil A Sand = 55 % Silt = 5 %…

Q: In one road project , for rehabilitation existing pavement by overlay technique , the effective…

A: To find effective structural coefficient number for existing pavement

Q: ighway engineering labartory CBR Test Report Discussion Points 1. Importance of the test. 2.…

A: Importance of the CBR Test California Bearing Ratio test is done for determining the bearing…

Q: Soils having size larger than 75 mm. O Loam O Boulders and Cobbles O Rock Gravel

A: Soils having size larger than 75 mm are called ' boulders & cobbles' Therefore choose 2nd…

Q: A contactor has compacted the base course for a new road and found that the mean value of the test…

Q: A contractor has compacted the base course for a new road and found that the mean value of the test…

A: We will use formula for density.

Q: Describe the purpose of soil stabilization and discuss at least three methods of achieving soil…

A: Soil stabilization is a procedure in which special soil is proportioned/added or removed or some…

Q: Describe the Collapsible soils.

A: When the unsaturated soil can withstand the high pressure without much change in volume but when…

Q: Given soil having particle size distribution of 8% sand, 20% gravel, 48% sit and 24% clay, classify…

A: The USDA classification does not include the gravel So we need to calculate the rest and extrapolate…

Q: Define the main purpose of soil testing?

A: Solution; The main purpose of soil testing are; The purpose of soil testing is to provide an…

Q: Describe briefly how does obtaining samples of soil groundwater and soil gas relate to diagnosing…

A: Any result of soil erosion contamination of soil or soil depletion is generated by the introduction…

Q: Using the given data, design a road pavement for a 4-lane highway based on ATJ 5/85 (2013).…

A: Design of Road Pavement : A road pavement or a highway pavement is a structure which consists of…

Q: The CBR for a given subgrade soil at a pavement project is 10. The modulus of resilience of subgrade…

Q: Define which lime is used for soil stabilization?

A: QUESTION IS BASED ON SOIL STABLIZATION

Q: explain how soil stabilization affects highway construction.

A: The process of highway construction starts either with filling earthwork or excavation of soil.…

Q: A) Being an engineer, what is the role of soil mechanics in highways and bridges? Justify your…

Q: A property developer wants to build a subdivision consisting of 500 residences, a shopping mall,…

A: Any construction project requires safety throughout its service life, and before starting any…

Q: In accordance with the Unified Soils Classification System, a soil grain having a size greater than…

A: Only sand has size less than 4.75 mm Gravel ,cobble and pebble have size greater than 4.75 mm.…

Q: Describe the Consistency and Strength of Cohesive Soils.

A: Soil consistency is defined as the strength that binds soil materials together, or soil resistance…

Q: Determine the percentages of gravel, sand, silt, and clay according to the AASHTO System. 1. Gravel…

A: To Determine the percentages of gravel, sand, silt, and clay according to the AASHTO System.

Q: Describe Collapsible soils as one of the groupings of special soils.

A: Collapsible soils are those soils which can withstand high pressure without any major change in…

Q: In a construction site, the contractor found out that average value of the test samples showed that…

A: Given, water content, w =14.6% specific gravity, Gs=2.81 unit weight,γ = 18.2 KN/m3 Specified…

Q: Describe the purpose of soil stabilization and discuss at east three methods of chieving soil…

A: As per guidelines one need to answer only first question.

Q: What does PG76-28 mean in pavement construction?

A: PG: PG means Performance grade bitumen. This nomenclature is based on the evaluation of the bitumen,…

Q: Classify the following soil using the U.S. Department of Agriculture textural classification.…

A: Reference : USDA - US Department of Agriculture Textural Classification Refer the figure established…

Q: Q#1: (a) Explain the working mechanism of Flexible pavements. (b) What are the main factors that the…

A: Flexible pavements: Flexible pavements are pavements with the bitumen surface on the top layer. The…

Q: Define Drained modulus of cohesive soils

A: Cohesive soil is defined as the soil that has fine-grained, less strength, and low deformable soils.…

Q: 1. For heavy traffic, which compaction test should be conducted on the subgrade? What is the reason…

A: Brief concept introduction- Compaction test- This test is done to determine the optimum water…

Q: section of a two-lane rural highway is to be realigned and replaced by a four-lane highway with a…

A: Consider the given data AADT=1000Construct time=5 yearsDesign life=20 yearsGrowth…

Q: A contractor has compacted the base course for a new road and found that the mean value of the test…

Q: For the following highway pavement information find the performance period if pi = 4.5, pt = 2.5 and…

A: The given data is: Pi=4.5 Pt=2.5 Analysis period=30 yrs Calculating the ΔPSI: ΔPSI=Pi-Loss in PSI

Q: Define Fine-textured soils.

A: Generally, there is no such definition for defining the fine texture soil and coarse texture soil. A…

Q: QS: Select the correct answer for the following multiple-choice questions: 1. Asphalt penetration…

Q: 3. Determine the thickness of a rigid pavement (thickness of concrete slab) by using the data…

A: From the two tables given: CBR2.5 mm=13708.2×103×100CBR2.5 mm=16.71%Also,CBR5 mm=205513×103×100CBR5…

Q: Classify the frost susceptibility of the following soils:a. Sandy gravel (GW) with 3 percent finer…

A: Given data: Types of soils. Forst.

Q: Give one or two possible identifications for each of the following. Provide a group symbol and…

A: Solution to the given scenario:The size of the gravel is larger and the size which is greater than 2…

Q: Define the Correlation between N60 and Relative Densityof Granular Soil ?

A: The uncorrected N value for a safety hammer (cathead and rope) is thought to be N60. An auto hammer…

Concept explainers

Soil engineering for highway design

Soil engineering is a part of geotechnical engineering that deals with the characteristics of soil. It also helps to understand the behavior of the soil in different conditions. The basic concepts of soil are studied to check the strength, compressibility, and porosity of the soil. This makes soil engineering an important topic for civil engineering.

Question

Determine the correct classification, including group index (GI) for the following soils using
AASHTO classification system and state whether this soil is suitable for pavement use.
Percent Passing
Soil
LL
PI
No. 10
No. 40
No. 200
1
100
92
66
45
13

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Classify the soil to be used as a highway subgrade material using AASHTO classification system; Liquid limit for soil passing #40 sieve was determine to be 35% and plasticity index was 20% Sieve No. Size opening (mm) % Finer No. 4 4.75 100 No. 10 2.00 93 No. 20 0.850 87 No. 40 0.425 81 No. 60 0.250 63 No. 140 0.140 49 No. 200 0.075 32
Describe the Collapsible soils.
A grassy drainage area is paved with asphalt. What happens to the time of concentration? 1. increase 2. decrease 3. stays the same 4.not enough information
a)As an engineer and based on information provided, you are required to identify the possible technical cause of theslopefailure. Based on the photo provided and field test, identify the type of slope failure aswell as the possible type of soils.
PLEASE ANSWER THIS QUSTION ASAP!! Classify Soil B using USCS
Discuss five limitations of soil erosion formula(RUSLE)
Define Collapsible soils.
Ground water conditions and the potential for groundwater seepage are fundamental factors in virtually all geotechnical engineering analyses and design studies. Accordingly, the evaluation of groundwater conditions is a basic element of all geotechnical investigation programmes. Discuss the purpose of laboratory investigation to be conducted for a building project in your area.
A property developer wants to build a subdivision consisting of 500 residences, a shopping mall, and five office buildings near your college. Assume that the total area is 50 hectares. The developer hires you to conduct a soils investigation as part of the due diligence process. Describe how you would conduct this investigation
A property developer wants to build a subdivision consisting of 500 residences, a shopping mall, and five office buildings near your institute. Assume that the total area is 50 hectares. The developer hires you to conduct a soils investigation as part of the due diligence process. Describe how you would conduct this investigation.
Classify the following soil by the AASHTO classification system. Percent passing No. 4 sieve = 92Percent passing No. 10 sieve = 87Percent passing No. 40 sieve = 65Percent passing No. 200 sieve = 30Liquid limit = 22Plasticity index = 8
Define the concept of Correlations for N60 in Cohesive Soil ?