Determine the power absorbed by the resistor in the circuit below,5Ω+j5NSource ASource B20V2/ 0°10V2/ 0°(Insert the numeric value of the power (W) in the box below without unit).

Answered: Image /qna-images/answer/10a0a4b8-ce98-450e-a726-4681ccdd7055.jpg

Answered: Determine the power absorbed by the…

Engineering

Electrical Engineering

Determine the power absorbed by the resistor

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter19: Special-purpose Outlets-water Pump, Water Heater

Section19.2: Water Heater Branch Circuit

Problem 5R: An 80-gallon electric water heater is energized for the first time. Approximately how many hours...

See similar textbooks

Related questions

Q: Given resistor having the following color code Yellow Violet Blue Gold Brown (as read from left to…

A: The given resistor is a 5-band resistor having color as: 1) Yellow: 1st digit (4) 2) Violet: 2nd…

Q: ở: calculate the current at 2kN Ik2 Si 25V ZSi

Q: Given resistor having the following color code Yellow Violet Blue Gold Brown (as read from left to…

Q: 10 30

A: Applying the nodal analysis to the node V as shown below:

Q: R, 25 200 si ww 5 V

A: A diode is nonlinear device. It is used in clippers, clappers, rectifiers, etc. The diode is ON when…

Q: Solve for the value of resistor with the color of green, blue, yellow and silver. Next is, for…

Q: Determine the current flowing in the 5 ? resistor.

A: To solve above problem, one should know about Kirchhoff's law. There are two Kirchhoff's law. KCL:…

Q: :Power absorbed by each of the following attached elements are

A: Power absorbed by the elements can be calculated by multiplying the voltage and current.

Q: Which one of the Folowing is the unit of Energy? a. volts b. Watts c. Calorie d. Kg

A: Energy is given by E = The Power dissipated by the electric element in given time . E = P× T P=…

Q: if the current in a resistor doubles, what happens to the dissipated power? (assume the resistor…

A: The expression for the power is given as, When current is not double then, When current is double…

Q: Question-1: What is the total cost of using all of the following at 9 halala per kWh. A 1000 W…

A: Given, Rate of electricity is 9 halal per kWh. A 1000 W toaster for 45 minutes. Ten 50 W bulbs for 6…

Q: Convert 100 Hp into its equivalent Watts.

A: In this case, 100 Hp of power is to be converted into its equivalent watts.

Q: 1- How much energy does a (200 w) electric lamp consumes in (1 hours) ? a) 710 KJ b) 720 KJ c) 730…

Q: Give the four color bands of 810 kΩ ±5% resistor.

Q: If the 50 Ω resistor is replaced by a variable load resistor, determine the resistance of the load…

Q: Calculate the power dissipated by the element of an electric fire of resistance 30 when a current of…

A: First we will find out power then we will calculate energy then we will find number of unit then we…

Q: 1. Identify the items according to the illustration Controler Process Steam in Hot water out Steam…

A: Given: Consider the following system: To find: Identify the items according to the illustration. a.…

Q: Calculate lo and the power absorbed

Q: Determine the value of the load resistor.

Q: Determine the effective resistance of the resistor network across nodes x and y.

A: In this question we need to find a equivalent resistance between terminal x and y

Q: Calculate the power Delivered by the battery

Q: Calculate the ohmic value of the following resistor color coded as Blue, Orange, Violet, Silver.

Q: Calculate the current through the resistance

Q: Determine the current supplied by each battery in the circuit shown.

Q: Find the power dissipated by the 20 ohms resistor

Q: Calculate the power delivered by the battery

A: we take a ideal battery.having internal resistance zero.

Q: The electrical Energy consumed by a 200 W electric bulb in 3 hours is equal to Watt-Hour

A: In this question we will find energy consumption and current...0

Q: Given resistor having the following color code Brown Green Yellow Silver Red (as read from left to…

A: In five band resistor color code, first 3 band indicates first 3 values , 4th band used as…

Q: motor with an efficiency of 87% is required to deliver 3kW of power for an hour. The electrical…

Q: If 750 µA is flowing through 11 k ohms of resistance, what is the voltage drop across the resistor?

Q: Determine the value of the load resistor

Q: Find the power absorbed by each of the six circuit elements. Solve it

A: Given : In the question they have mentioned electrical circuit having voltage source and…

Q: Given resistor having the following color code Red Gray Black Gold Yellow (as read from left to…

A: Three strips Red=2 Grey=8 Black=0

Q: Given resistor having the following color code Brown Green Yellow Silver Red (as read from left to…

A: Colour coding scheme is a way to find the resistance and tolerance of various resistors used in the…

Q: If 420 J of energy are absorbed by a resistor in 19 min, what is the power to the resistor?

A: Power absorbed by the resistor = Energy absorbed in JTime in seconds. 1 min = 60 sec Given , Energy…

Q: Given resistor having the following color code Red Gray Black Gold Yellow (as read from left to…

A: Color coding of the color Red gray black gold yellow

Q: Calculate each resistor voltage drop using the current found in (B)

Q: Measure the power dissipated/supplied (through voltage and current) by each element Compute the…

A: Let us assume currents to be in the clockwise direction. Since there are 3 closed loops, let us…

Q: Calculate the current and voltage drop in each resistor.

Q: Determine the current supplied by the battery in the circuit.

A: The given diagram can be modified as

Q: Conventional Power plant = Fuel going in is 100%, Electrical power going out is 35%, and Waste is…

A: In this question, We need to determine the efficiency of the conventional power plant? If Fuel…

Q: calculate the power absorbed by a load of

A: DC Shunt Generator Given,Ra=1 ohm,RL=10 ohm Rch=50 ohmNumber of Pole (P)=4Flux per…

Q: Determine the current supplied by the battery in the circuit shown below.

Q: Find the current across 10kohm resistor.

Q: Compare the constant in each of the equations to the resistance of each resistor.

Q: Determine the power required to raise a 100kg load with 100m vertically in 30 seconds.

A: Given Mass of the load =100 kg Height h=100 m Time t=30 s

Q: Calculate the voltage across the 2kΩ and include your calculations

A: In this question we will find voltage across 2 kilo ohm resistance...

Q: Determine the reading of the two wattmeters

A: Active Power- It is power utilized by the load.Reactive power- It is the power which remains within…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

Determine the power absorbed by the resistor in the circuit below,
5Ω
+j5N
Source A
Source B
20V2/ 0°
10V2/ 0°
(Insert the numeric value of the power (W) in the box below without unit).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

TII 8.) 4 – 3 kW, 230 V and 3 – 8.5 kW, 230 V clothes dryers are to be placed in a building, the total VA loading to be used for these in the computation for service entrance conductor is: A. 24375 B. 37500 C. 33750 D. 36000
Use any method to calculate the current I1, if R = 9 and Vs = 3
Calculate the POWER OUTPUT please, thanks
Please explain in detail and show all the solution if there are. Data Gathered during the Experiment Thevenin Voltage (VTH) = 1.618 volts Thevenin Resistance (RTH) = 1211 Ω Load Resistance Load Voltage Dissipated Power 7600Ω 1.511 0.0002 2000Ω 0.915 0.0004 900Ω 0.30 0.0003 1. Analyze the data for a pattern. What is the highest dissipated power in the list? When does this occur? 2. What value of Load Resistance develops a voltage drop across it closest to the value of VTH? 3. What value of Load Resistance draws the largest current from VTH? Please explain how the you arrived in that conclusion.
Given a series circuit comprised of the following element: 88.01-ohm resistor, practical inductor with internal resistance of 0.76 ohm and reactance of 25.96 ohms; and a capacitor with reactance of 9.53 ohms. Compute for the magnitude of its equivalent impedance in ohms. Note: Follow this reminder carefully. Compute to the nearest 4 decimal places. No Scientific notation. Do not round off in the middle of calculation. Use stored values. Write the numerical values only. No units in your final answer. Spaces are not allowed. Excessive number of decimals as compared to the required number of decimals may result to an incorrect answer
Solve the question. options are below. 1. 27 2. 9/11 3. -9/25 4. 6/17
Va = 25V, Vb = 41V, Ic = 15mA. In dc steady state, determine V2. Enter your answer in V rounded to one decimal place.
ques 5 plz provide step by step answer asap
Encircle the letter of the correct answer 1.One kW-Hr is equivalent to _______. (a) 1,414.14 BTU per hour (b) 3,600,000 N.m(c) 1,414.14 Cal. per sec (d) 3,600,000 kJ 2. The voltage across any part of a circuit is equal to the _______ of the current in amperes and the resistance in Ohms.(a) difference (b) product(c) sum (d) quotient 3. In a series circuit the current is the _______ in any part of the circuit and the total emf (source) is equal to the _______ of the voltages across each resistor(a) same, sum (b) same, difference(c) same, total (d) sum, same 4. System efficiency when maximum power is transferred or delivered is ______.(a) 60%. (b) 150%.(c) 50%. (d) 200%. 5. In parallel circuit the emf across each resistor is the _____ and the total current is equal to the _____ of all branch currents(a) sum, same (b) same, product(c) same, difference (d) same, sum 6. 1,200 BTU is equivalent to _______ Joules.(a) 302,500 (b) 1,265,554(c) 302,400 (d) 3,600,000 7. Ohm’s Law states that, for…
Please answer the question in the below image with the full required steps.Any assistance is appreciated. Options for the ques: 1) Y volts 2) 0 volts 3) -X volt 4) X voltWhen selected ans, please explain why
Referring to the Figure 1 below, given the value of frequency, f =50 Hz Determine: - i) The phasor domain equivalent circuit ii) The value of voltage source, Vs iii) The value of voltage, Vo Write your answer in 3 decimal places.
R=10 ohm , Vrms=220 , E=150V , f=50Hz