Determine the required battery voltage, VB, when C = 1/8F. If VB increase, what will happen to the flash voltage v(0+)?

Q: An NRZ polar code is using the following function to represent the 1 P() = sinc(rt /T,) a) Find (wit...

A: Given the PSD of polar line code : Sy(f)=P(f)2Tb An NRZ polar code is using the following function t...

Q: 7. Given the device characteristic, determine VCC, RB and Rc for the fixed- bias configuration Vex l...

A: In this question,  The fixed bias configuration is given.  Determine the value of Vcc, RB  and Rc   

Q: design a combinational circuit that accepts a 2-bit integer as input and generates a 4-bit integer a...

A:

Q: Based from the number 1 precaution of our experiment, what is the main reason why while doing the ex...

A: Diodes are very sensitive instruments even the slightest change of parameters will affect its functi...

Q: -12 V 10 kQ 2.7 kn. Si B = 75 3.3 kn 1 kn

A:

Q: I need handwritten only or dislike (a) Using the Routh stability criterion, determine the range of v...

A: The solution is given below 

Q: 33 Ω 12 A ( 10Ω 10Ω 134 Ω 134 Ω

A:

Q: Solve the differential equation mä(t) + cx(t) + kx(t) = kf (t) By means of a Fourier analysis, where...

A: Given the differential equation as given below : mx¨(t)+cx˙(t)+kx(t)=kf(t) By means of a Fourier ana...

Q: Assume a digital to analog conversion system uses a 10-bit integer to represent an analog temperatur...

A:

Q: For a self biased circuit shown in figure, calculate voltage gain, input and output resistances and ...

A:

Q: You wish to build a time delay circuit using an RL circuit, and the resistance in the circuit is 110...

A:

Q: The actual impedance of a system is 300 Ω.  The base kVA is 300 kVA, and the base voltage is 11 kV. ...

A:

Q: A voltmeter has an internal resistance of 500 kilo-ohm. Determine the voltage drop across the voltme...

A:

Q: For the given system transfer function below, find the value of the rise time. 10 G(s) = a+4.4

A:

Q: raw the output waveform for the zener limiting circuit. Show your analysis. NS. Will limit the volta...

A:

Q: 20. For the transistor circuit shown below IB = 35 HA and VBE = 0.7V The value of RB would be 12V A....

A:

Q: 51 A Current has an internal resistance of 782 is used to measure the Current through Rc in the belo...

A: If ideal ammeter is present then current supplied by battery is given as: I=31+1∥1mA=2mA The current...

Q: A sine wave with 2 VP will have Vrms as

A:

Q: 3. For the circuit shown in the following figure, find the Thévenin equivalent circuit for the part ...

A:

Q: A WBFM system has a carrier frequency of 2 kHz with 3 volts amplitude. Let the message signal be a s...

A: Given data, Carrier frequency fc=2 kHz Amplitude Ac=3 V Message signal, mt=4.95cos18×103πt kf=4 kV

Q: 3) FIND UOLTACE ACROR & CURRENT THROUGH R BY GEMN( THE EQ- THE UENIN CIRCUT +) izv 100 个)5A loa

A:

Q: 1. A magnetic circuit with a single air gap is shown in Figure below. The core dimensions are: Cross...

A: In this given question we will find reluctance of core and air gap....Also find flux , flux density ...

Q: R1 R3 b d a R2 RA

A: It can be done in many ways Voltage across any element is the current times it's resistance So here ...

Q: a) Draw the lagic diagram for the follawing Boolean expression. The diagram Should Correspond excact...

A: We need to find out logic diagram for given Boolean expression

Q: A 5 hp motor with a 0.60 lagging power factor and efficiency of 92% is connected to 208V, 60HZ suppl...

A:

Q: 13 Simplify the Boolean expression described below yields which of the following results? * AB + ABC...

A:

Q: 10Ω 10 Ω 15 N Rea 30 N 40 2 8Ω 20 2

A:

Q: Given: Half-wave rectifier; transformer secondary voltage = 32 V; Capacitance 4700 μF; average load ...

A: Given:Vs=32VC=4700μFVdc=18V

Q: the equationof alternating voltage is given by v=325.22 sin314t. find(i) RMS value (ii) frequency (i...

A:  

Q: the Current I equal in network | lon loA (^

A: Current through the series connected elements are same.

Q: 1. Compute voltage peak 2. Explain why their peaks are not of the same value? What is the difference...

A: A rectifier circuit is used to rectify the AC power generated by this source to the DC  power that i...

Q: An 8-pole duplex lap winding will have .parallel paths. ..... ...

A: Given a duplex lap winding with, Number of poles, P = 8 For duplex winding, n = 2

Q: 1. For the circuit shown below, the values are Vab = 20020°, Vbc = 2002120° and Vea = 2004240° V, Z4...

A: The circuit diagram is shown below, Where,Z4=Z5=Z6=25∠30°ΩZ1=Z2=Z3=50∠-60°ΩandVab=200∠0° VVbc=200∠1...

Q: 3-The firing pulse of the thyristor must be: (a) Synchronized with any phase voltage of the main sup...

A: A variable width pulse with a voltage level sufficient to cause the SCR to conduct will be applied t...

Q: Project Topic Design a device to measure frequencies from I Hz to 9999 Hz. The display can be either...

A:

Q: A B CD + ACD tB CD + ABCÑ

A: Above can be solved using different methods but  Traditional method to find using kmaps is using the...

Q: 3.0k2 430k2 Si B=50 2.0k2

A: Given  

Q: Find the Laplace transform of the following: 1) te-tu(-t)

A:

Q: B) Find the Reg. At point A&B in the network in fig.(1)

A:

Q: Find I, in the network in fig.(3) using superposition YA 52 552 2023 YoV 2A (IX) Fig.3

A: Superposition theorem states that When circuit having multiple sources  The response at any element ...

Q: Addition of pentavalent impurity to a semiconductor creates many a. Free electrons b. Holes c. Valen...

A: Introduction:- An intrinsic semiconductor (such as pure Si or Ge) , has only four electrons in the o...

Q: Determine the voltage gain, input and output resistances with feedback for voltage series feedback h...

A:

Q: bulb is rated 120v, 0.75A   Find current at 80 ohm resistor, 40 ohm resistor. Find Voltage to make...

A: The solution is given below 

Q: Confirm that for the singlet state, E(a, b) = -a - b. Calculate E(a, b) for each of the other three ...

A: Bell states- It is the four specific quantum state. It is a superposition of combination of two line...

Q: 2n 2n cos (t 3. Find LT of F(t) 2n 0, t <-

A: Given   

Q: Consider the N = 4 Butterworth filter in the previous problem. Plot the RLC circuit that has the tra...

A: Butterworth Filter- It is a signal processing filter which is designed to have frequency response wh...

Q: For the circuit shown in Figure a) name the circuit and explain how it works b) Vcc = 12 V, coil res...

A: a) This circuit will work as a thermal sensor.  As temperature will rise then the resistance of the ...

Q: Hw MANY MODES, LOOP, MEH IN THE FIEURE

A:

Q: What characteristics do Unified Communications Systems possess? What are the benefits of using them ...

A: Communication is the exchange of information. Information can be imparted to either individuals or a...

Q: In a few concise sentences, answer the following question: What causes "Fan-out" issues in CMOS circ...

A: CMOS logic gate- CMOS logic always gives output as inverting logic i.e., only NAND , NOR , XNOR . To...

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.