Determine the rms value of the unit sawtooth wave of period T.

Q: A signal has a single-sided bandwidth of W = 10 kHz. If this signal is sampled at the Nyquist rate…

A: Given: A signal has bandwidth, W=10 kHz Nyquist rate, fs=2W samples/sec Bits, n=3

Q: 2. In the following differential equations, the linear stationary system is represented by ( ) A.…

A: Types of system  Linear and Non linear Time variant and time invariant  Causal and noncausal…

Q: Design a counter which simultaneously satisfies all of the following requirements: • Have no input •…

A: We need to design a counter circuit for the given state diagram :…

Q: OV 50 Ω Μ 20 Ω Μ 80 Ω 15 Ω 30 Ω Μ ig 20 Ω Μ is ) 20 V Μ 12 V '60 Ω

A: Kirchhoff's Current Law- This law states that the sum of all incoming current is equal to all the…

Q: 60 /0° # 591- 14 Q + + -14 0 V2 214 0 22

A:

Q: find the steady-state response,

A:

Q: A plane wave propagating through a medium with er = 8, μr = -2 has E = 0.5 e-z/3 sin(108t - βz) ax…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: EXAMPLE To illustrate calculations with the unit impulse function, consider evaluation of the…

A: As per our guidelines we are supposed to be the first three questions only. Kindly repost the other…

Q: 9.10 The loss formula coefficient matrix for a two-pla system is given by 0.001 -0.0001 -0.0001…

A: Given, The loss formula coefficient matrix for a two plant system, B=0.001-0.0001-0.00010.0013 MW-1…

Q: Figure 3.1 shows an RLC circuit at t> 0 s. Assume a current source of 5A is applied to the circuit.…

A: The Given is a Parallel RLC circuit for t>0 sec The Given circuit is  The Given Source current…

Q: Questions 4 For the following circuit, the current I is: R= 5 kn www 12 V Select one: Ⓒa. 1mA b. 0.8…

A: Given data,

Q: If the skin temperature is 310 K and area of the human surface is approximately 1.8m2 then the power…

A:

Q: When the transistor works as a switch, it represents: 1. Amplifier 2. NOT Gate 3. Buffer

A:

Q: For a 20 KVA, 480/220 V, 60 Hz, single phase transformer. Calculate the phasor load current if the…

A: Given, A single phase transformer with, S=20 KVAV1V2=480220f=60 HzPL=12.6 kWcosϕ=0.881 laggingVL=220…

Q: Q3:- Determine the value of voltage (V1) and (V2) in figure (2-31) by using voltage divider rule. 45…

A: Given data : The given circuit is shown below,

Q: disadvantages of a Fixed bias circuit is that: 1. it is very complex. 2. it is too ß dependent. 3.…

A: The disadvantages of a fixed bias circuit is that: A. It is very complex. B. It is too beta…

Q: Inverse Laplace Y(5) 2 4(+) (S+5) 5 (50+35+7) (5+4 ) с

A: given             Ys=ss+5s2+3s+2s2+4 by partial fraction Ys=ss+5s2+3s+2s2+4=As+2+Bs+1+Cs+Ds2+4…

Q: Q2:- A 3-phase, 4 pole, 50 Hz, slip ring I.M it is full load speed is 1440 rpm if the rotor…

A: Given data, Number of poles (P)=4 Rotor Resistance (Rr)=0.25ohm Full load speed (Nr)=1440rpm After…

Q: A 25 kVA, 13,800/240 V distribution transformer has full load efficiency of 97% at unity power…

A:

Q: A A 200-KVA, 480-V, 50-Hz, Y-connected synchronous generator with a rated field current of 5 A was…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: If in CE transistor amplifier, Ic = 40 mA, IE = 41mA, calculate the value of ß.

A: Given data, In CE amplifier Ic=40 mAIE=41 mA

Q: Find the Vrms of 5 ohm resistor 2/30° A 352 502 j4Q -j2Q * 6Q

A:

Q: If you wanted to measure the voltage of a resistor with a voltmeter, would you introduce the…

A: While we are measuring the voltage across resistor , we place the Voltmeter in parallel with the…

Q: L=4 cm, f-3GH: v₂ = c Z-500 2x Bl= L- 2 a) Z₁ = 7502, b) Z, 75+j4202) = 2π f V ⇒find L=0.8-144" [r,…

A:

Q: Ex. 3) a 3-phase, 50Hz generator running at 1500 rpm, the stator inside diameter is (0.5m) and its…

A: It is given that: F=50 Hzn=1500 rpmD=0.5 mL=1.2mBm=0.62T

Q: balanced delta connected load has one phase current Ibc=2 angle -90 degree A.  Find the other phase…

A:

Q: If a 10 V battery, 8 μF capacitor and 500,000 ohm resistor are connected in series, please calculate…

A:

Q: A "T" type thermocouple has linear calibration between 0 "C and 400 °C with voltage at maximum…

A: Given a  "T" type thermocouple has linear calibration between 0 "C and 400 °C with voltage at…

Q: ider an npn transistor with VBE = 0.7 V at iċ = 1 mA. Find VBE at ic = 0.1 mA and 10 n

A:

Q: Consider the circuit below with i(t) = 2-2 e^(-6t) A [e is the exponential] for t> 0 and i(t) = 0…

A:

Q: Ex. 3) a 3-phase, 50Hz generator running at 1500 rpm, the stator inside diameter is (0.5m) and its…

A: Given data, Frequency (f)=50Hz N=1500rpm D=0.5m L=1.2m Bm=0.62T

Q: Write and verify: A behavioral HDL model of the BCD ripple counter described in Problem 6.13.

A: BCD ripple counter:- It is digital serial counter which counts ten digits. It is reset for the every…

Q: Solve using nodal analysis and mesh analysis

A: It is given that:

Q: Consider a unity feedback system with a forward transfer function, G(s) = = K s(s+ 2)(s + 10) (a)…

A:

Q: What exactly is a motion sensor for fitness purposes?

A: A motion sensor, sometimes known as a motion detector, is a piece of technology that use a sensor to…

Q: Find the equivalent inductance between terminals A and B in the following figure. Assume no mutual…

A: If three inductors of inductance L are connected in parallel then equivalent inductance is L/3. If…

Q: Q1:- A 3-phase induction motor has an output a 37KW at this load the stator copper loss and rotor…

A: Output power=37 kW⇒η=outputinput=0.9⇒input=370.9=41.111 kWLosses=input-output=41.111-37=4111 WStator…

Q: EXAMPLE To illustrate calculations with the unit impulse function, consider evaluation of the…

A: As per our guidelines we are supposed to be the first three questions only. Kindly repost the other…

Q: Design an excess-3-to-binary decoder using the unused combinations of the code as don’t-care…

A: EXCESS-3-TO-BINARY DECODER USING THE UNUSED COMBINATION: The table for excess-3 to binary is shown…

Q: 3.15P) The excess electron concentration and Electic field is plotted in a bar of an n-type…

A: The given plot is shown below:

Q: 5 Find the average power delivered to the 3- resistor in the circuit shown in Fig. 11-12. (4 130 m…

A:

Q: Choose the correct answer: a) The reason of high input resistance of the MOSFET is: 1. The insulator…

A: The reason of high input resistance of the MOSFET is  1. The insulation layer. 2. The reverse…

Q: Find the drain currents in the transistors in the latch and the power dissipated by the sense…

A: Given: For NMOS transistors: Kn'=60 μAV2,VT0=0.7 V,γ=0.5, WL=4 and 2φF=0.6 V            For PMOS…

Q: Write the logical equation of the CMOS circuit shown below: +2.5 V 3 A B C D PMOS switch network (2)…

A:

Q: For A DC motor with speed regulation SR-5 %-(0.05), the full load speed :N.fl=1500 r.p.m, the no…

A: Given: A DC motor with Speed regulation, SR=5%=0.05 Full load speed, Nfl=1500 rpm

Q: For the following circuit, find the current 11 and 1. GIVEN: V = 6 V and Vo = 4.5 V. ing. 302. 1202…

A: Given circuit, Here,  V= 6 VV0=4.5 V

Q: Determine the rms value of the ware form W+XV) 1 2 Į 2 3 4 5 t(s)

A: The given signal is periodic with period 4 sec. The formula and calculation is shown in the next…

Q: Diode turns OFF if the applied voltage polarity is Select one: O a. None of the answers b. opposite…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: In the circuit shown, switch S₁ is closed at t = 0 and switch S₂ is opened at t = 0.2 second. Find…

A:

Q: What is the output F of the following circuit? +2.5 V OVO 1₁. Mp1 MNI +2.5 V Mp2 F MN2 Hi

A:

Speed control of motor

Speed control by DC motor-speed controller is required to realize variable speed drive. Whenever a motor drives a particular load, it is called drive, and variable speed drive refers to a load requiring variable speed. All this is obtained by a DC motor speed controller.