Determine the time constant for the circuit

Q: Q3: Find the frequency response to solve this equation? X[n]=10 sin [320 t], fs=1200

A: Given: x[n]=10sin [320 t],fs=1200, To find: the frequency response.

Q: Compared with a wired system, what are the advantages of the radio system?

A: 1. When the number of devices involved in the communication system increases, to connect all the…

Q: Question 7 In the collector to base bias circuit shown in figure, the value of the Rc for Vcc= 15V,…

A: Given- Collector to base bias circuit- Vcc=15 V,Ic=5 mA,hFE=100,VCE=5 V,VBE=0.7 V, To Find- The…

Q: 1 If the load (R) in the common emitter amplifier is increased, then the voltage gain will decrease…

A: “Since you have posted multiple questions, we will provide the solutiononly to the first five…

Q: Compute the DFT of the following sequence using the matrix form. x(n) = {0, 1, 2, 3} Then compute…

A:

Q: 5. An ideal 2kVA, 240V/24V, single-phase transformer has 50 turns at its secondary winding. If the…

A: Given: An ideal 2kVA single phase transformer,  with, primary voltage = 240V with 50 Hz frequency,…

Q: in a using 2. Find the economic dispatch for a total demand of 500MW system with three thermal units…

A: Initial loading , P1=P3=100MW and P2=300MW Total load demand, P1+P2+P3=500MW To find: Economic…

Q: and If the unit impulse response of a linear system is httl= te ult), the input is filtl=etult),…

A: We need to find out output in frequency domain.

Q: Consider that you have the following state representation system, Determine the Transfer function by…

A: Given: x1˙x2˙x3˙=-5-30200010x1x2x3+200u, y=016x1x2x3

Q: b) ii) Find the Thevenin equivalent circuit at terminal a-b; 10V 20 Ω + 50 Ω 30 Ω 50 Ω Ω 8 Ω Figure…

A: When more than one source is present in the electrical network, the Superposition theorem is used.…

Q: Design an Ayrton Shunt that can measure up to1A, 2A, 3A and 4A if the meter movement has aresistance…

A: Given: In this question, the given details are, To design an Ayrton Shunt that can measure up to 1A,…

Q: 3. In a 5 hp, 230 volt 1500 rpm shunt motor the resistance of armature is including brushes is 0.175…

A:

Q: A 11 kV, 500 MVA alternator is connected to a slow C.B. through a bus-bar. Determine the three…

A: Basic Equipment used in High voltage transmission Circuit Breaker Lightning Arrester Current…

Q: 3 j1.25 (4) j0.2 j0.4 (3) 2 j1.0.25 Reference j0.25 (2) 1 j1.25 (1)

A:

Q: (b) AC circuit analysis is the process of determining the currents and voltages in a network of…

A: Given: A network, where, Z=(3+j6) Ω, To find: a) Current flow through Z, using source…

Q: 3. For the circuit shown below. a. Determine the open circuit voltage. b. Determine the short…

A:

Q: 11) A unity feedback system has the following feed-forward transfer function G(s) = Find the…

A:

Q: 24) Which of the following is the root locus graph of the closed loop system whose block diagram is…

A:

Q: 3. In the following circuit, it is measured that v₁ = 12 V and ₂ = 8 V. Given that R3 = 120, find…

A: Given data, v1=12 V, v2=8 V, R3=12 Ω. Circuit diagram is given as,

Q: CONTROL SYSTEMS Do not use MatLab please

A:

Q: The output of the bandpass filter is the input of the envelope detector. If I connect the band pass…

A: We know that, At resonance condition, the above band pass filter LC parallel network offers very…

Q: 10. GIVEN 1552 3 vas ww B 3012 € wh 2552 C 82 14-2 M M 1022 ≤4--22

A:

Q: let k be the number of times. a messag it need to be transmited untit auwives Courtly at its…

A: Given: "k" is the number of times a message signal needs to be transmitted such that it arrives…

Q: As an assignment for antenna course work, you are asked to design a mobile phone antenna which is…

A: Design a mobile phone antenna which is suitable for a 4G LTE mobile cellular radio system, Centre…

Q: Figure Q2 shows a single line diagram of a power system and the associated data of this system are…

A: GIven Base MVA  S b=100 MVA Base voltage at all generators =11 kV Base voltage for both lines =132…

Q: The unit impulse response of a linear system is é cosit)u(t). Find the response due to the unit step…

A: Given data Impulse response, ht=e-tcost ut Input function, xt=ut We need to find out the response…

Q: battery having an (e.m.f) of 110v and an internal resistance of 0.2 ohms is connected in parallel…

A: We need to find find out current and voltage and power for given circuit.

Q: For the network with CE in placed, determine A, (using appropriate approximations). 3.14 wrong V 90…

A:

Q: 500MVA, 21KV, star connected, 3ph 50Hz synchronous generator is operating at the rated voltage, a…

A: Rating of generator= 500MVA,21KV, star connected, 3ph 50Hz Its reactance in p.u. are 1.5 of…

Q: A digital signal is defined as x[n] = cos(n47/5) a. Is this sequence periodic b. Find the first 6…

A: We need to check whether the given signal is periodic and we need to find out the first 6 elements…

Q: )Apply the principles of circuit theory to the circuit illustrated in Figure 1 with constant…

A: In this question We need to determine the voltage across the load resistance RL  We are solving this…

Q: 2.50. Find Io in the network in Figure P2.50.1 $₁ V₁ TV 2 mA 1 ΚΩ ΣΙΚΩ ΙΚΩ ΣΙΚΩ FIGURE P2.50 12V

A: We need to find out the current for given circuit.

Q: VOL VOH: VBE = 0.7V VCE sat Vi o = 0.2V 10 ΚΩ www B 18 V E 1900 Ω - Vo B = 60 (Suggested solving…

A: VOL= output low voltage VOH= output high voltage VIH= input high voltage VIL = input low voltage…

Q: An antenna whose radiation resistance is 100 Ω operates at a frequency of 2.4 GHz and with a current…

A: In this question We need to determine the radiated power ?  We know Power P= I2 R

Q: The current in a conductor is 0.5 A. How many coulombs of charge pass any point in a time interval…

A: Given data: The current is i=0.5 A The time is t=1.5 minutes=1.5×60s=90 s

Q: For the below circuit: 1. Sketch the output vo. 2. Determine the DC level of the output voltage…

A: It is given that:

Q: 2. Boolean Circuits. Consider a circuit that has three inputs (x, y, and 2) and produces an output…

A: Draw the logic circuit for the condition that output is true (1) iff exactly one input is true(1).

Q: H-W Agiven FM Signal is e(t) FM lo Cos [lont+ 8 Sin (1877-+)] Petermine 1) The Carrier frequency 2)…

A: We need to find out the modulation index , carrier frequency and deviation for given FM signal .

Q: Figure below shows a DFT coefficients of a sinewave. 600 500 400 X300 200 100 0 0 DFT of a Sinewave…

A: We need to find out the message signal frequency for given DFT .

Q: 4- Name several important components of building electrical system that are used or get connected by…

A: An electronic component is any essential discrete device or physical item in an electronic system…

Q: QUESTION 4 Determine ICQ = RB ww 100 kn Vcc +20 V 8c 4.7 ΚΩ RE 10 kn EE -20 V and VCEQ= of the…

A:

Q: 1- Derivations of the formula for the lumped circuit model of a coaxial cable.

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: Question 10 Refer to the figure below. e(t) = 200 sin(314t) V R = 400 www VR 40-j24 Q2 40-j48 Q 40+…

A:

Q: A) Determine a discrete state space model by selecting a sample period B) State whether the system…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: For the network with CE in placed, determine Rin in ks (using appropriate approximations). V₁ HH 1₁…

A: We need to find out the input impedance for given circuit , first we will do DC analysis then small…

Q: A 3-phase 6-pulse converter is operated from a three-phase delta- connected 230 V, 50 Hz supply to…

A:

Q: Exorcise 1 9) How b) What working c) What is d) What diodes. losses are in CL a Thyristor Conditions…

A: a) The thyristor, it is also called as silicon controlled rectifier, it is basically a 4 layer 3…

Q: Waveform Generator RED CLIP BLACK CLIP R1 C1 1kΩ 100μF GND Figure 3: Breadboard circuit. Wave I Gen…

A: Note Time constant τ of RC Circuit=RCTime constant τ of RL Circuit=LR

Q: For the network with CE unconnected, determine Rin in kn (using appropriate approximations). k 90…

A: We need to find out the input impedance for given circuit.

Q: (16) option Vs (t) Vs (t)= Vs Sin wt V₁ (t) = vc sin (wt + c) 1= RC R . V₁ = Vs · Vc = 0·573 v . 7²…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…