Determine whether a short circuit fault will occur if lightning with a peak value of 18 kA on an overhead power transmission line with line characteristic impedance 350 ohm, protection line characteristic impedance 450 ohm, direct earthing resistance 150 ohm and insulator surge voltage 1000 kV. I would be very happy if you could be quick.

Determine whether a short circuit fault will occur if lightning with a peak value of 18 kA on an overhead power transmission line with line characteristic impedance 350 ohm, protection line characteristic impedance 450 ohm, direct earthing resistance 150 ohm and insulator surge voltage 1000 kV. I would be very happy if you could be quick.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter13: Transmission Lines: Transient Operation

Section: Chapter Questions

Problem 13.24P

See similar textbooks

Similar questions

Calculate the clearing time of a 5 cycle duty power circuit breaker for a 138 kVolts, 60 Hz switchyard.
Investigate the principles of predictive maintenance in power substations and how it can prevent costly failures.
2. What's the primary instrument for locating a break in a cable during emergency maintenance?A. OSAB. OTDRC. MultimeterD. Power meter
recommended the testing of wiring installations for domestic load
Line characteristic impedance 350 ohm, shield characteristic impedance 450 ohm, pole ground resistance 150 ohm, and an insulator with a pulse jump voltage of 1000 kV. to the overhead power transmission line with a peak value of 18 kA If lightning strikes the phase conductor, a short. Determine whether there will be a circuit failure
A 3-phase, 33-MVA, 44-kV alternator has a substransient reactance of 7%. A 3-phase short circuit occurs at its terminals. Determine the fault current. Use the alternator rating as base values. Round your answer to 2 decimal places.
quetion: Automatic circuit breaker - explain principle of operation, desing and protective characteristic that they have.
Explain the purpose of a circuit breaker in a power distribution system.
Supposed a 5000 kva, 13.8 volt, 60 hz, 3-phase capacitor bank with grounded neutral is being switched through a circuit breaker, through a source of 1 millihenry. what is the peak current at restrike voltage?
How does a circuit breaker work in a power system, and what is its role in protecting the system from faults?
c.1. Which of the following is one of the three essential functions of an equipment grounding conductor?A. Provide an arc-fault current pathB. Establish groundingC. Establish bondingD. Ensure the system is groundedc.2. What's another name for the three-point method of Earth resistance testing?A. Fall-of-potentialB. Line surgeC. Spatial shieldingD. Leakage current c.3. If the National Electrical Code provides a requirement to ground equipment, it generally implies thatthere will be a direct connection to the Earth of a connection through a/anA. grounding electrode conductor.B. equipment grounding conductor.C. equipotential bonding conductor.D. bonding conductor.
A generator-transformer unit is connected to a line through a circuit breaker. The unit ratings are: Generator: 10 MVA, 6.6 kV; , and Transformer: 10MVA, 6.9133kV, reactance0.08pu The system is operating no load at a line voltage of 30 kV, when a three phase fault occurs on the line just beyond the circuit breaker' Find (a) the initial symmetrical rms current in the breaker’(b) The maximum possible DC off-set current in the breaker, (c) The momentary current rating of the breaker’ (d) The current to be interrupted by the breaker and the interrupting kVA and (e) The sustained short circuit current in the breaker