Differential between the high temperature Low Sag Conductors and Convetional converters,

Q: By adopting COSINE as the base function for phasors, what part of the Euler's identity is used? A)…

A: We need to select correct option for given statement.

Q: A three-phase bridge rectifier of Figure below has a purely resistive load of R = 40 2 and is…

A: Given data Load value of the resistance; R=40 Ω RMS Supply voltage; Vs, RMS=280 V Supply frequency;…

Q: Periodic analogue signals and non-periodic digital signals are used in data transmission; why?

A: In this question we will write why in data transmission , both periodic and non periodic signal is…

Q: Question-2 : Consider the following circuit (assuming the ideal diode model): = VI +1 $45.0 D ich…

A: In an ideal half-wave rectifier, the diode conducts current only during the positive half-cycle of…

Q: 3. Consider the discrete system with h(n) = (0.8)" u(n) and the input is x(n) = 6ðn-2) + 3Ån-4). (1)…

A: here we have to find the fourier transform of given signals.

Q: 2. Equivalent inductance: Using your combine the inductors in the circuit below into a single…

A:

Q: Using Ohm's law, find the current I. Using current division, find the current il.

A:

Q: Question 2 [ "J Consider the following circuit and answer the questions below. sa 12V B R1 60 i1 ↓…

A:

Q: Problem #1) Given the time-varying voltage: v)=30-sin(377-1+45°) Express the voltage as its (RMS)…

A: it is asked to express the given sinusoidal voltage in phasor form

Q: With neat block diagram explain the speed measurement system using tacho-generator. 2. Explain the…

A: A tachogenerator is a type of electromechanical device that is commonly used to measure the speed…

Q: Our basis for the construction of line phasors is the COSINE function. A True B False

A: In this question we need to verify the given statement is true or false.

Q: 3-10 An ac voltmeter is to be used to measure the rms voltage across the 15-k resistor in the…

A: Details explanation in below step

Q: 2. A series circuit contains a 20- resistor and a capacitor with a capacitance of 110.5 µF. If the…

A:

Q: stion 1 Given the below circuit, answer the following: R1 40 B i2=0.31A 6V Law A i1 R2 30Ω R3 2002…

A: We need to find out voltage for given circuit by using of KVL and Ohms law .

Q: Consider the circuit in (Figure 1). Suppose that i = 4 A and v = 10 V. Figure 402 {50 10 A 10 m 40…

A:

Q: Question 1 For the Gaussian pulse example, determine the AT using the "full width at 0.1 of the…

A: Answer : Given information written below. For the Gaussian pulse example, it is asked to determine…

Q: Consider the following circuit and answer the questions below. A) B) C) A and B. 12V B I R1 60 i1 ↓…

A:

Q: Question 17 If the current flowing through a 75 mH inductor has the waveform shown in Fig. 7.46, a)…

A: In this question,  We need to determine the voltage waveform if current waveform is given in the…

Q: Simplify the following Boolean expression using Boolean identities: A(B + C) + AB

A:

Q: 1. A magnetic field of 1,000 A/m is applied to an Fe-Si alloy which has a relative permeability of…

A: Given data, Magnetic field intensity H=1000 A/m. Relative permeability μr=30000. Permeability of…

Q: 1. Jason wants to create a motor to spin a mirror ball for the school dance. He has a square 5cm x…

A: Given,Jason wants to create a motor to spin a mirror ball for the school dance.Dimensions of loop…

Q: find: Vbc Vca IAB provide soln ty

A: In this question We need to determine the voltage Vbc  , Vca  and current IAB   We know, using the…

Q: The following signal is periodic with the period of y [n] cos (0.1mm) + 2 sin (0.1) = samples

A:

Q: VZ-240, FIND: Vbn van Van=300/30 VZO Vab VZ-120 b a 2+j3 faz B LAB 2 IBC Z ICA Z 10-js C

A: it is asked to find Vbn, Vcn, Vab for given 3 phase system

Q: If Vin (t) = 5cos(35,000t +45°) V, find Vout (t) in the form of Aout cos (wt+out)- (Hint: H() = out)

A:

Q: Find the voltage Vz across the Zener diode of Fig. 2-20 (a) if iz= 10mA and it is known that Vz= 5.6…

A:

Q: Explain different types of electrical loads with necessary diagram and examples.

A: Electrical loads- The term "electric load" refers to a gadget that uses electricity. In other terms,…

Q: 12V Problem #5) Given the following circuit: Loc 60 80 160 www a) Determine the current Ipc that…

A: Steady state DC  condition we need to find out Idc,Vw,Vx,Vy,VL

Q: Question-2 Consider the following circuit (assuming the ideal diode model): iD V + PI-1c]: Dic↓ ILY…

A:

Q: Question 2: For 20KW motor, if I power = 32A, I reactive=24A and Power factor (PF) = 0.8, then find:…

A: Here we have to find the Iharmonics and distortion factor and Total harmonic disortion.

Q: 9. The two complex numbers V and W represent two reactances connected in series. Calculate the total…

A: V = A = (3 + j4) ohm            W = F = (4 + j1) ohm V and W are connected in series.…

Q: d) Discuss about the principles of electromagnetism used in the simulation

A: Given: Discuss about the principles of electromagnetism used in the simulation.

Q: Assume R₁ = 2450, L₁ = 3.3mH, C₁ = 0.22 µF, and w = 35,000 for the above circuit sec Find the…

A: It is given that: R1=245 ohmL1=3.3 mHC1=0.22 μFω=35000 radsec

Q: 2-3. A dc, separately excited motor has a load torque of 140Nm and a frictional to 1 of 10Nm. The…

A: As per the guidelines of Bartleby we suppose to answer first question only since the remaining…

Q: 4. Why would the built-in potential of a PN junction reduce with temperature even though the…

A:

Q: A load of 130 MW at a power factor of 0.75 lagging can be delivered by a 3-phase transmission line.…

A:

Q: A 25 Hp, 230 Volts, three-phase motor with 85% power factor has a starting current of 5.5 times…

A: In this question We need to determine the starting current after installed star Delta starter.…

Q: In the following circuit, the switch SW was left in position 1 for a long time. At time t = 0, the…

A: In this question we need to draw the circuit in s domain and find the current i(t) for t>0

Q: Question-2 E Consider the following circuit (assuming the ideal diode model): iD VI + # DiciLV R (a)…

A: here we have to find the maximum current through the diode.

Q: D please

A: We use S domain to solve this question

Q: Find the currents through meters A and B in the circuit of Fig. 2-31. Rm = 2 ks R = 10 k E = 1 V -…

A:

Q: 2-11 A voltage reading is to be taken across the 6-k2 resistor in the circuit of Fig. 2-36. A…

A:

Q: A single phase transmission load at 14 kV. Its resistance is 72 and inductive reactance is 6 S. If…

A:

Q: A 3-phase, 50 Hz, 50 km long overhead line supplies 550 kW at 22 kV, 0.9 p.f. lagging. The line…

A:

Q: 2. Consider the following circuit: R₁ ww Vi(t) V₁(t) il(t) MM Assume the switch is closed at t = 0,…

A:

Q: EXERCISE 7.2.20 (a) Findiv(t) for t > 0 in the network shown below. 1 = 0 όμο 12V(+ ww 61 5 12 Ω ww…

A:

Q: The power input to 100 hp, 480 V, 88% efficiency and 75 % power factor 3 phase motor at full load is…

A: it is asked to find the watt meter readings from given data

Q: In the balanced three phase power measurement using two wattmeter method, each wattmeter reads 20…

A: In this question we need to find the reading of wattmeter .

Q: 1. For the symmetrical 3-phase circuit in Figure 1: a) Draw 1-phase equivalent circuit b) Calculate…

A: Given data Line-to-line voltage URS=400∠30° V  LIne Resistance Rline=2 ohms  Load Inductance…

Q: Simplify the following Boolean functions using a K-map F(A,B,C)=A'B'C+B'C'+ABC'

A: