Discuss the determination of discharge in closed conduit by direct measurement method. In determining discharge on closed conduit using Venturi meter, will there be an effect of the installation of the Venturi meter (i.e., inclined, horizontal, or vertical) in the value of the discharge computed? Explain your answer.

Discuss the determination of discharge in closed conduit by direct measurement method. In determining discharge on closed conduit using Venturi meter, will there be an effect of the installation of the Venturi meter (i.e., inclined, horizontal, or vertical) in the value of the discharge computed? Explain your answer.

Solid Waste Engineering

3rd Edition

ISBN:9781305635203

Author:Worrell, William A.

Publisher:Worrell, William A.

Chapter8: Landfills

Section: Chapter Questions

Problem 8.10P

See similar textbooks

Similar questions

In determining discharge on closed conduit using Venturi meter, will there be an effect of the installation of the Venturi meter (i.e. inclined, horizontal, or vertical) in the value of the discharge computed?
Other than current Meter method what other method can be used to measure Discharge. Explain the method
How to measure coefficient of Discharge with the help of venturimeter? Explain in Detail.
Given the 2-Hour Unit Hydrograph shown below, construct a 3-Hour Unit Hydrograph using the S-Hydrograph procedure.
A 200mm diameter venturi meter is installed in a 400mm diameter vertical main pipe as shown. If the deflection of mercury (SG = 13.6) at the manometer reads 300mm and the vertical distance between point 1 and point 2 is 690mm, determine the discharge in the system assuming no head loss.
The sluice gate shown is in a channel that is 4 feet wide. The depth of y, is 6 feet and the depth of y, is 1 feet. Assume no loss of energy. a. What are the velocities V, and V, (in ft/s)? b. What is the discharge Q (in cfs)?
The data pertaining to a stream-gauging site are given below. The rating equation of the current meter is v = 0.35Ns + 0.02 m/s where Ns =revolutions per second. Calculate the following: Round off your final answers to two decimal places, a. Discharge of the second segment? b. Velocity of the third segment? c. Discharge of the fourth segment? d. Velocity of the fifth segment? e. Discharge of the sixth segment? f. Total discharge?
Using f = 0.02 for all pipes, determine the discharge in pipe 3 in L/sec and total head loss in meters.PROVIDE COMPLETE SOLUTION FOR ME TO FOLLOW!
A 200mm nonstandard orifice is installed in 250mm pipe carrying water. When the flow is 165lit/sec, the mercury differential gauge reads 50mm. Compute the value of coefficient for the orifice meter.
Calculate the discharge of each pipe. Take f = 0.02 for all pipes. Use a trial and error solution method and flow away from the junction is taken as negative.
Three pipes 1, 2, 3 are connected as shown. If the total discharge forthe system is 610 L/s and the friction factor f is equal for all pipes,then:What is the flow rate (in L/s) in pipe 3?
Is there a significant difference between the discharge coefficient derived from the experiment with that of coefficient of discharge from Bazin’s formula? Discuss the possible reason for such discrepancy