Discuss the equivalence between (x, z, n) and (x, y, a + (1 – a) t) when z = (x, y, t). Can you think of circumstances under which they would not be viewed as equal?
Q: 4 students measure the length of a nail and they obtained the following values: 2.34 cm, 2.33 cm, 2....
A: Precision Precision in measurements is indicate how close the measurement to each others. Accuracy...
Q: A closed system of mass 2 kg undergoes an adiabatic process. The work done on the system is 30 kJ. T...
A: Given: Mass m=2kgWork done =30kJVelocity change from 3m/s to 15m/sheight h=45m To find: The change i...
Q: 1- A 10k2 resistor is made of two strips connected in parallel, each one has 40µm thick, and 6mm lon...
A: Given Length L =6 mm Thickness t = 40 μmμm Width w = 0.5 mm Density ni =2.5×1019 m-3 Electron mobili...
Q: Plz I need the answer of this questions in electronics
A: The working principle for the photodiode is Energy gap=exciting photon energy.............1Here give...
Q: A person is found dead at 5 PM in a room whose temperature is 20 °C. The temperature of the body is ...
A: The Characteristic Length of the person:LC=VA=πro2L2πroL+2πro2LC=12/ro+2/Lwhere, d=30 cmro=d2=302=15...
Q: Diffusion by reflection from a rough surface is described in this chapter. Light can also be diffuse...
A: Diffusion happens when light reflects in different directions upon hitting a rough surface. light ca...
Q: E7BP3
A:
Q: 1. A sphere of surface area 100 m and temperature 500 K radiates 0.2 MW. Calculate: a. The emissivit...
A: As per the guidelines, we are supposed to answer only first three subparts of the given question. Pl...
Q: Question 7.1: Measuring the Distance to the Moon The distance from Earth surface to Moon surface is:...
A: Given : d=1km R=3.8×105km The beam divergence needed for a beam to expand to 1km diam...
Q: 13
A:
Q: Q.2: Calculate the shortest wavelength for electron revolving in the fourth excited gennanium atom, ...
A: energy of Germenium atom,En=−13.6evn2z2 z=Q/e=4.8×10-19C1.6×10-19C=3for 4th excited state, n=5,E5=−1...
Q: Q2c) Listed in the table below is the tensile stress-strain data for different grades of steels. Uti...
A: Given Listed in the table below is the tensile stress-strain data for different grades of steel, as ...
Q: Three charged particles are located on the corner of a square as shown in the figure. Q1=+5 uC, Q2=-...
A: q1=5μCq2=-15μCq3=6μCPB=2LAP=CP=L ABCP is a square so electric field due to second charge will be alo...
Q: F1 - 10 kN F2 = 26 kN 45° e-45 F3 = 8 kN B F4 = 44 kN E e-45 F5 = 8 kN 1] What is the resultant mome...
A: force are resolved in the component as shown in the figure. moment due to a force =Force×perendiicul...
Q: I am looking for answers regarding questions in the attached pic
A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,...
Q: k is equal to 1 to 2.5 passeng
A: Total volume per each 15 minutes is to be computed as below and highest UME cooring in the 15 minu...
Q: (b) A 3.00-kg block is set into motion up an inclined plane with an initial speed of 90.00 cm/s (the...
A: Given: The mass of the block is m = 3 kg The initial speed of the block is u = 90 cm/s The final vel...
Q: Sample Problem 4/I: Compute the force in each member of the loaded cantilever truss by the method of...
A: Here we need to find force at each member of loaded cantilever truss by method of joints . Given i...
Q: Two point sources are in phase and emit a 500 Hz tone. What is the phasedifference at a point that i...
A: A wave propagating in phase generally represented as y=Asinkx-ωt-ϕ Here ϕ is known as the phase of t...
Q: What is the displacement?
A: Coach's resulting displacement and distance travelled.Distance from B to C.Distance from B to D.Dist...
Q: How much must the object on the right weigh if the 200-N block on the frictionless inclined plane is...
A: Given: The weight of block on the inclined plane is W=200 N. The angle of inclination of plane is θ...
Q: A string of length 100.0 cm is fixed at both ends and is kept under a tension of 25.00N. The linear ...
A: We have the following information given Length = L = 100 cm = 1 m Tension = T = 25 N linear mass de...
Q: QI/ A tube contains an oil of specific gravity 0.75 to a depth of 130 cm. Find the absolute pressure...
A: Given: The specific gravity of oil is s=0.75. The depth of oil is h=130 cm. The formula to calcula...
Q: Point charge, q1= 10 μC, is placed at the origin of the cartesian coordinate system. Another point c...
A:
Q: For a spherical surface with radius 0.16 m and is charged by 39 nC, the electric Potential V at r 0....
A:
Q: Q: Consider the section of wall as shown in the figure, assuming one dimensional heat flow, determin...
A: let say area of cross section =A then AA=2A/3, AB=A/3, AC=4A/15, AD=3A/5, AE=A/3, AF=A thermal ...
Q: raw shear and moment diagrams of beam shown below. 10 kN 10 kN/m 3m 2m 1m R1 R2
A:
Q: How can we increase the kinetic energy of electrons emitted from the surface of a metal?
A: Since you have posted multiple different questions, we will solve the first one only (as per QA guid...
Q: similarities and differences between Biot-Savart Law and Ampere’s Law
A: Biot- Savart Law- The Biot-Savart law help us to determine the magnetic field at some position in sp...
Q: HW5 A ship has its turbine engine mounted with its axis of rotation lengthways in the ship. The engi...
A: Solution: Given that, A ship has its turbine engine which rotates with its axis of rotation leng...
Q: 2. Find the group and phase velocity of a guided mode in a hollow waveguide. (i) Show that their pro...
A:
Q: Block A weighting 1000N rests over block B which weights 2000N as shown in the figure. Block A is ti...
A: Given:- Block A-weighting 1000N rests over block B which weights 2000N as shown in the figure. Block...
Q: A tank contains a pool of mercury 0.30 m deep, covered with a layer of water that is 1.2 m deep. The...
A: height of mercury layer and water hHg=0.3mhw=1.2m ρHg=13.6×103kg/m3ρw=103 kg/m3 pressure exerted by ...
Q: HW: Determine the force in each member of the truss shown in Fig. below, Indicate whether the member...
A:
Q: Illustrate and solve the problem A bushwalker walks 15 km east and then 11 km south. Find the bearin...
A: Bearing Angle=tan-1yx=tan-11115 , south to East=36.25°
Q: Advanced Physics Question
A: Given data, Q1 = -4x10-8 C Q2 = 2x10-8 C Q3 = 4x10-8 C Side of rectangle = 4 m Another side of recta...
Q: A NaI(Tl) detector is coupled to a photomultiplier tube having certain stages for electron multipli...
A: Photomultiplier tubes Photomultiplier tubes are a versatile instrument that is used to detect very s...
Q: Physics problem involving Torque and Forces; (Make up an expirement) (Prove the friend wrong; dispro...
A: Measure the masses of different small objects using a mass measuring scale. Now keep the objects on ...
Q: Q.1 A horizontal tube of 60 m lenght is connected to a water vessel at one end discharges freely int...
A: Given data:Length of pipe(L1)=60 mLength of 1st pipe(L1)=35 mDiameter of 1st pipe=120 mm(d1)=0.12 mL...
Q: Need help with parts A and B plsss
A: (a) Introduction: A standing wave is a wave in which each point on the standing wave will oscillate ...
Q: 3. A charge distribution with spherical symmetry has density 0 R SPo (a) Find E everywhere by using ...
A:
Q: When you turn while running, you must lean in the direction of the turn or risk falling over. If you...
A: We will be using the concept of torque and friction to understand this dilemma.
Q: Options for question 1: A, B, C Options for question 2 and 3: 1/2, 1/4, 1, 2, or 4
A: Introduction: System closed at both ends means both ends are rigid boundaries. At both ends, nodes w...
Q: Q3: For the clipper circuit of the figure below, find plot the output waveform, if V1=4 Volts
A: We have to understand the diagram.
Q: Q8// Show that our definition of magnitudes has the following property: If we have three stars with ...
A: Given : m2 - m1 = 2.5 log10 f1 f2 ----(1)m3 - m2 = 2.5 log10 f2 f3 ----(2) Prove that : m3...
Q: A modification to an Atwood's Machine is to put one of the masses on a sloped surface (see diagam be...
A: let assume m2 block moves downward, so mass m1will move up along the inclined plane. from free body ...
Q: He wants to light a corridor with four lamps, 10 meters from the other, at a height of 5 meters from...
A: Given that,A person wants to light a corridor with = 4 lampsDistance between each lamp (d)= 10 mHeig...
Q: see image attached
A:
Q: A woman is 1.6 m tall and has a mass of 55 kg. She moves past an observer with the direction of the ...
A: Given: The height of the woman is 1.6 m. The mass of the women is 55 kg. The v...
Q: F1 = 3 kN F2 = 11 kN e-60 30 F3 2 kN 2 m 7 m F4 = 20 kN a 30° F5 = 2 kN Activate Windows 5] What is ...
A:
![2. Discuss the equivalence between (x, z, 7) and (x, y, n + (1 – T) T) when z = (x, y, t). Can you
-
think of circumstances under which they would not be viewed as equal?](/v2/_next/image?url=https%3A%2F%2Fcontent.bartleby.com%2Fqna-images%2Fquestion%2Fb9767380-f2c6-4d0b-8ea8-b1ab5477724b%2F09730032-683e-41a6-9bd4-eedf1fe681ee%2Flilchpr_processed.jpeg&w=3840&q=75)
![](/static/compass_v2/shared-icons/check-mark.png)
Step by step
Solved in 2 steps with 2 images
![Blurred answer](/static/compass_v2/solution-images/blurred-answer.jpg)