distributed load of 7 kN/m and the sag of the cable measured from the higher end is 6 m. Calculate apart with one end 5 m above the other (as shown in figure below). The cable is loaded with uniformly A cable of uniform cross-sectional area is stretched between two supports 80 m horizontal tension in the cable and maximum tension in the cable. 7 kNm 80 m d = 5 m

distributed load of 7 kN/m and the sag of the cable measured from the higher end is 6 m. Calculate apart with one end 5 m above the other (as shown in figure below). The cable is loaded with uniformly A cable of uniform cross-sectional area is stretched between two supports 80 m horizontal tension in the cable and maximum tension in the cable. 7 kNm 80 m d = 5 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The cable in Figure P6.2 supports four sim-ply supported girders uniformly loaded with 6 kips/ft.(a) Determine the minimum required area of the maincable ABCDE if the allowable stress is 60 kips/in.2.(b) Determine the cable sag at point B.
The left support of the cable shown is located 10 m below the right support. The lowest point on the cable is 13 m below the right support. If the maximum tension in the cable resulting from a uniformly distributed load w along the horizontal is 400 kN, determine:a the angle betwee the cable and the horizontal at the right supportb the magnitude of the distributed load wc. The length of the cable
The power transmission cable weighs 150 N>m. Ifthe resultant horizontal force on tower BD is required to bezero, determine the sag h of cable BC.
The left support of the cable shown is located 10 m below the right support. The lowest point on the cable is 13 m below the right support. If the maximum tension in the cable resulting from a uniformly distributed load w along the horizontal is 300 kN, determine:a. The angle between the cable and the horizontal at the right support;b. The magnitude of the distributed load wc. The length of the cable.
Determine the magnitude of the projected component of the force F = {400i - 200j + 500k} N acting along the cable CA.
Problem Number 1: In the given cable carrying a horizontal uniform load of 9.5 KN/m , and point C is the lowest point inthe cable. (a) determine the maximum tension (Tmax) on the cable , (b) the cable diameter if the allowabletensile force is 750 MPa (c) Length of the cables considering the given sag.
A cable subiected to uniform load of 240N/m is suspended between two hinge supports at the same level 20m apart, If the cable has central sag of 4m, determine the following:The horizontal reactions at the cable.The maximum tension in the cable.Total length of the cable.
The cable shown carries weights (W1 = 16 kN, W2 = 22 kN) at points C and D. Determine the value of the REACTION (kN) at D. Use x1 = 4 m., x2 = 10 m., x3 = 6 m., y = 5 m., θ = 39°.
Consider that the catenary cable in the figure is anchored between supports A and B and issupporting only its own weight, which is w = 50 N/m.Determine the cable length, the minimum pulling force on the cable and the pulling force maximum without cable.
A small suspension bridge for a walkway spans 150.9876 m between supports on the same level. Each of the two cables carries a uniform load of 28.1234 Kg/meter of horizontal walkway. If the maximum tension on the cable is found to be 20.4321 KN, compute the tension To = ___________________KN at mid-span, the sag h =______________meters and the angle θ= _________________degrees made by the cable with the horizontal at the supports.
Can you solve reaction forces Dy, Ay, Ax, Dx, and the sag in the cable at point B,Yb
7 Given the Cable as shown below that weighs 15 N/m with the tensile force at Point B that is found to be 500 N.Determine the following:a.) The Tension at Point A.b.) The Minimum Tension in the Cable.c.) The Span of the Cable L.