Does the NEC make suggestions about how to wire a house that will be occupied by handicapped persons?

Q: Type UF cable shall not be used where subject to physical damage. A. True B. False

A: Generated power needs to be distributed to different loads. Cables are used for transferring power…

Q: Explain this diagram for dummy

A: The given circuit is as shown below,

Q: Explain this diagram for a dummy

A: The given circuit is as shown below,

Q: List down the different types of Cables.

A: Dependig on the purpose of use cables are classified in to five types1)Shielded cables2)Fibre optic…

Q: Can I use the 66-block in telephone wire distribution to its outlets? How is it distributed?

A: According to the question, we need to explain the 66-block in telephone wire distribution.

Q: 9.a. What should be done with the connector ferrule once a connector is attached to a fiber optic…

A:

Q: What should be done with light sources that are connected at each end of a cable while it's being…

A: For proper safety, we should always take care of certain measures and steps needed to be taken while…

Q: Give me about ten examples of electrical code violations in maintenance and repair. Hopefully the…

A: Choose the wrong Circuit breaker There is a need to follow the national electric code. 1. Standard…

Q: 2. What fault occurs when Line and Neutral wires come with each other? Which device is actuated?

A: According to the given question, it is required to describe the fault which occurs when a line and a…

Q: How can you calculate the maximum short-circuit current that can pass when the A-B ends of an outlet…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Which of the following systems of wiring has poor durability? O TRS Wiring O CTS wiring O Lead…

A: There is the table for some wiring system with its durability:   Wiring system Durability…

Q: Does compliance with the NEC always result in an electrical installation that is adequate, safe, and…

A: NEC stand for National electrical code which is basic standard code and it sets the standards for…

Q: What is the mean of wiring

A: Wiring is the term used for the supply system design, connection, and protection schemes employed…

Q: Please answer the question full sentence 5. Identify the minimum distance requirements between…

A: The minimum distance between the network cable and power sources is 50 millimeter or 2 inches.

Q: Table 314.16(A) of the Code shows the maximum number of conductors permitted in a given size box. In…

A: When setting a job, an electrician often makes a circuit, thinking of the best way to use wires…

Q: In a set of construction drawings, where would an electrician find information about the location…

A: Construction drawings are called site plans.

Q: 15. What does a grounding symbol on a construction drawing convey? A. A single ground rod B. A…

A: Choose the correct option What does a grounding symbol on a construction drawing convey?

Q: Identify and explain the safety procedures and precautions that should be followed for fire…

A: Safety precautions for fire  prevention - Always Get Ready with the emergency plan Training of…

Q: In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A: we need to explain the molded case circuit breaker

Q: IS it a requirement to have a light ixture outside the garage door for a vehicle? O No Yes For two…

A:

Q: How can you calculate the maximum short-circuit current that can pass when the A-B ends of an outlet…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A:

Q: What device can determine how far a cable damage is

A: Cable faults are defined as an unacceptable characteristic or performance of the cable utilized in…

Q: analyse the rating of wires/ cables and mcb used for different types of loads

A: A small circuit breaker called an MCB is used to trip when home appliances experience overcurrent…

Q: Explain the bus in a few words

A: In this question we will write about bus in micro processor....

Q: Differentiate cable tester with multi meter.

A: A cable tester is an electronic device used to check the electrical connections in a signal cable or…

Q: What is bus bar in electrical?

A: The bus bar in the electrical system is known as the conductor or the bunch of conductor which is…

Q: Explain why the risk of electric shock is greater with a.c. portable appliances than with fixed…

A: Electricity hazard is the most dangerous one as it do not provide advance warning od danger. Dealing…

Q: 15. Why is it necessary to have a good grounding system for the building?

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Receptacles that provide power for a spa or hot tub shall be ________. Select one: a.…

A: According to ARTICLE 680  of National electricity code (NEC), any outlet that supplies a hot tub or…

Q: NO. 3 In your own words and from your own understanding, avoid plagiarism or copying from the Course…

A: We have to describe the OIL CIRCUIT BREAKER with proper schematic diagram. First we can discuss…

Q: Discuss the mechanism of a short circuit and how it can lead to accident

A: Short circuit- Electrical current always try to flow least resistive path. Hence in case if…

Q: Define and differentiate accidents, unsafe acts and unsafe conditions. essay at least 30 words

A: Electrical Hazards: Hazards are always there with Electricity. it causes damage to equipment on…

Q: Identify and describe the step-by-step process used to pull cable and the step-by-step process used…

A: 1. The first step is to to lay electrical conduction of 2mm thick and 25 mm in size for the PVC…

Q: Explain the Wiring Diagram of Direct On Line Starter based on your understanding in a minimum of 100…

A: Direct online starter is used to start a three phase induction motor In this method starter is used…

Q: What is the total number of systems?

A:

Q: Is it correct?

A:

Q: Does the NEC provides maximum standard or minimum standards

A: In the following section, it has been discussed whether the NEC (National Electrical Code) provides…

Q: Who has the responsibility for Code interpretations? When are rules in the PEC mandatory and when…

A: 1. Who has the responsibility for Code interpretations? Answer :  As per NEC, section 90.4 and…

Q: 8. All conductors of a multiwire branch circuit must originate from ____

A: A multi-wire branch circuit is circuit which has two or more ungrounded and one grounded conductors

Q: Is it okay to use a cable tray for the horizontal path of telephone lines to their specific outlets?…

A: EMT conduit size (inch) Number of cable 1  4 1-1/4 6 1-1/2 8 2 14 2-1/2 17

Q: Describe the various methods of laying underground cables. What are the relative advantages and…

A: Proper laying and attachment of fittings decide the reliability of underground cables. The fittings…

Q: Explain how LVDT can be used for the measurement of displacement.

A: LVDT can be used for the measurement of displacement.

Q: Changing faulty or worn-out electrical parts, such as motors and repairing loose connects or damaged…

A: TRUE

Q: Terminals of switches and receptacles marked CO/ALR are suitable for use with _______________,…

A: The term CO/ALR is abbreviated as Copper Aluminium Revised.  The switches are rated as 15 A and…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.