十 ↑↓ $1 个 s V
Q: A number of cables are tested for insulation resistance, the highest value is 400 m ohms and the…
A: In this question We need to determine the equivalent resistance of the parallel combined cables. We…
Q: How do we control the speed & torque of electric vehicle?
A: We need to explain how do we control the speed & torque of electric vehicle.
Q: 02 (a) Figure Q2(a) shows a Frequency Modulation (FM) generator circuit which is based on direct FM…
A: Given: Frequency modulation equation, VFM(t)=15 cos 3π×106t+4sin2π×103t, To find: iii) Modulation…
Q: Determine the Ib (base current) in the given circuit if VBB = 15V, Vcc = 15V, RB = 15k ohms, RC = 1k…
A: The given question is a basic one on BJT biasing to find base current Ib for values of VBB, Vcc, RB,…
Q: 1. Find the ammeter current in Fig. by using loop analysis.
A:
Q: FIG. 2.46 Calculate VR2 and compare to the measured value; determine Vs 5V = R₁ 100 Ω www D₂ D₁ R₂…
A: In this question We need to determine the voltage across the resistance R2 We know Forward bias…
Q: Please explain motor drive system in electric vehicle.
A: A Motor Drive System is a combination of electrical and mechanical components used to control and…
Q: Determine the power absorbed by each of the elements in the figures below: a) b) ↓IA W c) μW. Use…
A:
Q: Q: For the following closed loop system below: R(s)- L(s) A (s-B)(s-C) = s(s+3)(s+5) A=8+1, B = 3+2,…
A: Given: A control system, where, L(s)=A(s-B)(s-C)s(s+3)(s+5),where, A=9, B=5, C=12, To find: a)…
Q: A 250V series motor runs at 500 rpm at rated load current of 75 A. The armature circuit has a…
A: It is given that: V=250 VN1=500 rpmIL1=Ia1=75 ARa+Rse=0.2 Ωϕ α Ia
Q: X(f) 8( + 100) 18(+50) 8f-50) 8f-100) -100 -50 0 50 100
A: We need to find out the time domain expression for given frequency domain signal .
Q: From the three-phase transformer circuit in Figure 1, calculate the full load primary current in…
A: Given a 3- phase transformer circuit To calculate the full load primary current in ampere (A) and…
Q: Use the Table and convolution properties to find the zero-state response of a system with an impulse…
A: Given the Impulse response , ht=e-tut . xt=δt-5.xt=e-tut-1
Q: A generator rated 1000 kVA, 13.8 kV 60 hz 3- phase wye connected, 6 poles has 10 ohm synchronous…
A: Synchronous generator:
Q: Multiplexing the frequency should be done independently from the division of time (According to…
A: Multiplexing:
Q: A M3 Removal FC 19 MW 0.8 lag pf Find C so that the system 0.95 aina
A:
Q: Find Vo in the network shown. Answer: Solve 4 mA 12 ΚΩ 12 ΚΩ 12 ΚΩ ¦ 12 ΚΩ 12 ΚΩ Vo
A: I have written this solution as handwritten solution. Hope you find the perfect solution.
Q: Solve for bi 8V0 3.315 + 1605 tovo B = 110 3. ak 12V
A: In the given questions we need to calculate the input impedance offer by the amplifier. input…
Q: loku u 10кл озу O 15.21128 2017 291 t vo 6A (1 200123V Figure 2 (a) alayhon doame long laban la NOW…
A:
Q: For the snubber circuit of Fig. 10-12a, V₁ = 50, IL = 4 A, C = 0.05 µF, R=5 2., and tf = 0.5 μ The…
A: Given the data VS=50,IL=4 AC=0.05 μFR=5 Ωtf=0.5 μsfs=120 kHzduty ratioD=0.4
Q: Consider the figure below which shows the single-line diagram of a small part of a power system. 1…
A: Given the single line diagram of power system,
Q: 2 V NE w 12 Fig. 2.177 04 OB 3 m 9. In the network shown in Fig. 2.177 find the current that would…
A:
Q: 10. State and explain Thevenin's theorem. By applying Thevenin's theorem or otherewise, find the…
A:
Q: logic input 4.7 k www +5 V 470 AA
A:
Q: At a time instant equal to thrice the time constant of a stable first-order LTI system, the ratio of…
A: Answer: To find the ratio of its unit step response to final asymptotic value of its unit step…
Q: Which of the result of two identical waves 140 degrees out-of-phase arriving at the receiver at the…
A: Given the question, Which of the result of two identical waves 140 degrees out-of-phase arriving at…
Q: Present state 3231 Y2Y1 00 10 01 01 10 11 Next state w=0 w = 1 State diagram- State equations -…
A: Given: State assigned table, To do: to draw the state diagram, to derive the state equation, to…
Q: The simplest equation which implements the K-map shown below is: C C AB 0 0 AB 1 1 AB 1 1 AB 0 1
A:
Q: b is close to For the circuit shown below, the maximum power can be delivered to the load at…
A: In this question we need to find the maximum power transfer to load for the given loading condition.
Q: The primary and secondary of a single-phase transformer carry 500 and 100 turns, respectively. The…
A: Given,Primary turns, Npri=500.Secondary turns, Nsec=100.Length of iron core, Liron=200 cm.Length of…
Q: What is the magnitude of the electric force in (N) acts on a +2nC charge enters a region of a…
A: Given data, Charge is given q=2 nC. Electric field E=3-4j×109 N/C.
Q: A 3-phase, 480 V, 60 Hz, 4poles, Y-connected wound-rotor induction motor rotate at 789 rpm rotor…
A: Given data, Number of poles P = 4. Frequency f = 60 Hz. Rotor speed Nr=1789rpm. Rotor copper loss…
Q: Please help with all of them, and show work please Construct a truth table ABC +…
A: Given that Boolean expression are as follows. ABC + A’B’C + AB’C’ (A + B)(A + C)(A’ + B’)(B’ + C)…
Q: 2. Find the inverse Laplace transform f(t) of the following functions F(s): 1 s² +8 (a) F(s) : = (b)…
A: By using inver Laplace formulae and partial fractions and residue theorem f(t) is calculation from…
Q: ㅣㅣㅣㅏ E- D ww R
A:
Q: can you do the remaining ones? (4 and 5)
A: Given that Boolean expression as follows 4)(A + C) (AB + B’C’) 5)(A + C)’(AB)’
Q: 13. For the circuit shown in Fig. 2.181, determine current through R, when it takes values of 5 and…
A:
Q: Find the Norton equivalent current IN that drives R4 when E=14 V, R1=2, R2=12, R3-24 and R4=6. E a…
A: The given circuit diagram is shown below,
Q: Explain the function of La, Ca, Di, CI and Ri in figure q2b
A: According to the question, for the given circuit we need to explain the working of each element.
Q: 2-25 Find the power provided by the source and the current through the 68-k2 resistor in Figure…
A:
Q: Two equal resistances are connected in parallel across a 150 V DC source. What potential difference…
A: It is given that:
Q: Q2 (3) Circuit B Is την www ΖΩ Μ Τ 10Ω 3 Ω ΣΩ 10Ω For the circuit shown above, if Is = 30 A , then…
A: Source transformation The transformation of a current source into a voltage source is shown in the…
Q: The principle of superposition allows the current i in the circuit shown to be determined by summing…
A: The required parameters can be calculated by using the kirchhoff's voltage law, kirchhoff's current…
Q: 4. A single phase circuit consists of three conductors each 5 mm diameter on one side of the line…
A: In the question it is mentioned that other side has two conductors. However, in figure it is showing…
Q: In an a.c. circuit, the instantaneous e.m.f. and current are given by e = 100 sin 30t i = 20 sin(30t…
A: Given- An a.c circuit- Instantaneous e.m.f- e=100 sin 30t, Current- i=20sin30t-π4, To Find- Average…
Q: What is controlled in a cleanroom? What are the limits? What is the difference between a fab and a…
A: Fab and Cleanroom:
Q: 10 cos 2t V R C io L m 6 sin 2t V For the circuit shown above, what is the amplitude of the…
A: In this question we need to find the amplitude of sinusoidal steady state expression of current io
Q: 5. Find Thevenin's equivalent of the circuits shown in Fig. 2.174 between terminals A and B. R₂ R.R₂…
A: Thevenin's Theorem A linear circuits which contain more than one independent or dependent…
Q: 1) For the series-parallel combination circuit shown below in Figure-1, use circuit reduction…
A:
Q: 3.) A 110 - KVA, 2200/110, GO He Has the pollowing cincuit constants: R₁ = 0.2252, R₂ = 0.5 mst. x₁…
A: Given information about a single phase transformer is written below. Rated kVA is S=110 kVA. Induced…
ASSUME ARBITRARY VALUES FOR ALL OR PLUG IN VALUES U CAN USE AS AN EXAMPLE.
Full Wave Rectifier:
a) Find voltage at blue nodes.
b) Find current at yellow arrows.
Step by step
Solved in 6 steps with 6 images
- Where Si = 0.7 and Ge = 0.3Show the complet manual solutionQestion 2 pleaseA copper coil has a resistance of 200 ohms when its mean temperature is 0 degree centigrade. Calculate the resistance of the coil when its mean temperature is 80 degree centigrade. Temperature coefficient of copper is 0.004041 centigrade-1a) 264.65 ohmb) 264.65 kilo-ohmc) 286.65 ohmd) 286.65 kilo-ohm
- CURRENT at t= 0 ,( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).Article 820.100 gives information and requirements on the ____ of television distribution centers. Select one: a. clearances b. grounding c. bonding d. both B and CSee Image R = 320 Ohms; Ro = 100 Ohms 1) Determine io 2) Determine vo