Answered: Draw the charging and discharging…

Draw the charging and discharging waveform if the switch changed position precisely when the capacitor reached 5 time constants when charging and discharging

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter17: Commercial And Industrial Air-conditioning Control Systems

Section: Chapter Questions

Problem 22RQ

See similar textbooks

Related questions

Q: Steady state stability is always.............. than transient stability

A: In the question, Fill the blank Steady state stability is always.............. than transient…

Q: The function of the moderator in a nuclear reactor is to Stop chain reaction Reduce the speedof…

Q: Input waveform Input waveform Output waveform Output waveform The following oscilloscope traces are…

A: We have given The following oscilloscope traces are examples of what? 1) Slew rate distortion 2)…

Q: Question 2 1. Discussthe Seebeck effect. 2. When the cold junction of a thermocouple thermometer is…

A: Seebeck effect

Q: A copper-oxide rectifier and a non-inductive resistance of 20 Ω are connected in series across a…

Q: (a)duty cycle (c) inductor peak current (d) output ripple voltage (b) inductor ripple current

A: Given, A boost converter has , Input voltage (Vin) = 5 volts Output voltage (Vo) = 15 volts Average…

Q: What is the effect of unsymmetrical spacing of con

Q: Q3: Single phase full wave convertor, connected to high inductive load 120 If the Input voltage 208V…

A: The solution can be achieved as follows.

Q: 01: A gas bubble from an explosion under water, oscillates with a period T proportional to pad"E…

Q: In the circuit shown in the figure, the switch is operated at a duty cycle of 0.5. A large capacitor…

A: A DC chopper is a permanently installed device that converts a fixed dc input voltage to a variable…

Q: Q2: Determine the maximum output voltage and 50% voltage and its time for 16-stage impulse generator…

A: The given data's are, Stages n=16, The generator capacitance C1=320×10-916=20×10-9 F, The load…

Q: a. Determine at time t by how much the oscillating charge is reduced to 50% of the initial charge?…

Q: A capacitor is a device that: O A. Transforms electrical energy into heat energy O B. Stores energy…

A: We need to select correct option for capacitor

Q: The capacitor in the existence of short circuit condition can be bypassed or short-circuited by…

A: In this question, Choose the correct option Which device is used to bypass the existence capacitor…

Q: 3. A firing angle controlled triac is feeding a R-L load with L=16 mH and R=12 ohm.The triac input…

A: as the triac is suppling R-L load hence triac conducts atωt=α=firing angle during 0 to π triac…

Q: (b) Describe, with the aid of a diagram, a capacitive type pressure detection circuit that can…

Q: Q3: A 3-phase half wave-controlled rectifier is fed from 3-phase 400V, 50Hz source and is connected…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: Question 2: In the single phase full bridge rectifier shown below: a) Sketch the output voltages at…

Q: Sketch the electronic symbol (schematic) for the following components/ devices. Briefly describe the…

A: According to the question, Sketch the electronic symbol (schematic) for the following components/…

Q: B)Unijunction oscillator usually produces A.Mexican waveform B.Pulse waveform C.Triangular…

Q: Develop capacitor sensor and explain the operation. a water level measurement system using LVDT /…

A: So, here i have proposed a design which uses a LVDT to measure the water level in a tank.

Q: Vhen a 60 Hz sinusoidal voltage is applied to the input of a half-wave rectifier ut frequency is 50…

Q: I a thyristor - controlled reactor, the conduction angle is: A. Directly proportional to twice…

A: To determine : The conduction angle of Thyristor - controlled reactor,

Q: The single-phase halt wave rectifier has a L= 6.5 mH, R = 0.5 2, and E = 10 V. The input voltage is…

A: It's given that : L=6.5mHR=0.5ΩE=10VVs=120VVm=1202f=60Hzα=60 or 1.047radian

Q: Briefly state the difference between them capacitive proximity sensor inductive proximity sensor

A: The explanation is as follows.

Q: When a 92.83 Hz sinusoidal voltage is applied to the input of a full wave rectifier, the output…

A: Given, Input frequency for half wave rectifier, fiHWR=92.83 Hz Input frequency for full wave…

Q: Which one of the following circuit elements consists of P and N materials and passes current in one…

Q: Voltage Doubler Multiplier Solve manually the voltage and current in each capacitor and diode,…

A: If the diodes are ideal then Let take the negative half cycle 1st then D1 will conduct and D2 will…

Q: 200 ohms and the parallel resistance of the coil 200 ohms, the maximum current rating is 1 milliamp,…

Q: diode whose internal resistance is 17 ohm is to supply power to a 2,008 ohm load from a 110V RMS…

A: In this question we will find dc load voltage in given half wave rectifier circuit....

Q: A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input signal…

Q: 1) A certain full-wave rectifier has a peak output voltage of 30 V. A 50 μF capacitor-input filter…

A: It is given that: Vo=30 VC=50μFRL=600Ω

Q: Q2: Determine the maximum output voltage and 50% voltage and its time for 16-stage impulse generator…

A: Given n=16C2=4×10-9R1=80 ΩR2=3100 ΩVoltage=100 kV

Q: 6. The controls the output voltage of the AC generator, based on charging system demands, by…

A: As per the honor code I will do only first three questions. Kindly repost the other questions again.…

Q: Explain working of a capacitive accelerometer

A: A capacitive accelerometer is also known as a Capacitive Vibration Sensor. This accelerometer will…

Q: Combining of the small nucleus into a larger nucleus occurs in which of the following nuclear…

A: Choose the correct option If small nucleus into a larger nucleus, which of the following nuclear…

Q: A three phase fiall wave fully-controlled rectifier is operated from 208 V. 50HZ, Y connected…

A: Given data : Line voltage, Vrms=208 V f=50 HzRa=10 Ω

Q: 3. A firing angle controlled triac is feeding a R-L load with L=16 mH and R=12 ohm.The triac input…

A: Given data, R=12ΩL=16mHV=220Vf=50Hz

Q: For the circuit shown in Figure 2: a) find the mathematical expression for the transient behavior of…

Q: 10. The figure below shows a circuit for charging a 12-V battery. If V, is a sinusoid with 24-V peak…

A: To find the duration of the diode conduction in a circuit that contains a diode, it is important to…

Q: Refer to the circuit shown in Figure 14–21. Assume that the inductor has a wire resistance of 0.2 Ω…

Q: The voltmeter has an amplitude value rectifier, the scale is graduated to root mean square…

A: we need to find out the absolute and relative error.

Q: diode generator is required to produce 11 mV of noise in a receiver with an input impedance of 65 W…

A: In this question we will find find Diode current to produce required noise voltage....

Q: Which statement(s) is(are) true for photomultiplier tubes? I Photomultiplier tubes are very…

A: Photomultiplier tubes belong to the class of vacuum phototubes. They are extremely sensitive…

Q: Calculate the ripple voltage for a full-wave rectifier @120 Hz with a 45.03 uF filter capacitor…

A: In this question we will find ripple voltage for full wave rectifier....

Q: 2.Describe the voltage across and the current through the capacitor combination in both charging and…

Q: Refrigerant-134a is throttled from the saturated liquid state at 800 kPa to a temperature of -20°C.…

A: Given Inlet pressure Inlet temperature Exit temperature Throttling valves are usually small…

Q: 220 V, 1 kW heater is fed from a single phase ac voltage controller using a thyristor in…

A: The solution to all subparts can be achieved as follows.

Q: Sketch and explain the output for the circuit of given parameters. The generator signal is a sine…

A: In this question, We need to Sketch the output voltage waveform Using Third Diode Approximation?…

Question

Draw the charging and discharging waveform if the switch changed position precisely
when the capacitor reached 5 time constants when charging and discharging.

ww
A
B
R1 470 k2
R2
10 k2
0 - 20 v
C
FIGURE 4

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

To study the input and output characteristics of a BJT in Common Emitter(CE) Configuration and plot it on graph.lab report Input Characteristics: V CE = 5V V CE = 10V V BB (volts) V BE (volts) I B (µA) V BE (volts) I B (µA) Output Characteristics: I B = 431μA (VBB=5V) I B = 930μA (VBB=10V) V CC (volts) V CE (volts) I C (mA)
Calculate the input resistance,for Igss= 50nA at Vgs=20V
KVLLoop abfea: __________________________________________________Loop cdhgc: __________________________________________________Loop bcgfb: ___________________________________________________
16 - What is TA in this eqaution? TJ = TA + ( R θJA × PD )...Formüldeki TA nın anlamı nedir?A) Ambient temperature for package Paket için ortam sıcaklığı B) Thermal resistanceIsıl direnç C) Junction to ambient thermal resistanceOrtam termal direncine bağlantı D) Power dissipation in packagePakette güç dağılımı E) Boltzmann’s constant Boltzmann sabiti
Given the following values and using the given load line and BJT Circuit. Ic (sat) - 5 ma Vce (cut-off) - 31 V Icq - 2.21 ma Solve for the value of RB in kilo-ohms. Final answer must be in 2 decimal places.
R1=15k ,R2=2k, Vin=20 volt .Determine the value of Vout?
?=120 IC, VE, VCC, VCE, VB, R1 find their value
758. [NEW] A thermocouple has a linear voltage response over a wide temperature range. If the thermocouple voltage is 17 mV when the temperature is 12 deg F & 36 mV at 32 deg F, what is the temperature when the thermocouple output voltage is 40.2120 mV?
Please explain the solution and analysis in detail? For intance, what is id? Why id=-id? What is 250Vbe? Why 250*Vbe? Independent and dependent source? How to solve the question? etc...
Draw the pin diagram of 8051 & 8237 and write down the difference between them.
INFE242 ELECTRONICS lab
Are the following statements correct or wrong? Justify your answer.(a) GTO requires very high current applied to its gate to be turn off.(b) IGBT is a current driven device.(c) IGBT is more efficient than BJT in high power applications.(d) Thyristors are used only for low voltage, low current applications.(e) MOSFETs are used for low frequency applications. (I got the answer in the search but if possible,i want it in a slightly different way)