Draw the output voltage waveform for the circuit in (b), and (c). and include the voltage values. R₁ www 4.7 ΚΩ +25 V +12 V -25 V -12 V (b) (c) (a) R₂ • 4.7 ΚΩ

Q: Silicon R₁=10005² 24 Vp Analyze the circuit using any circuit analysis method to compute for the…

A:

Q: Question (3) In the circuit shown below, e(t) = √2 100 sin 40t volts. Find out: d) The total circuit…

A:

Q: 1. A single-phase transmission line is composed of two solid round conductors having a radius of…

A: Given: Single phase transmission Radius of conductor, r=.45 cm Distance between conductors, d=350 cm

Q: SUBJECT: Industrial Electronics Display the waveforms of the four distinct kinds of time-delay…

A: Time Delay relay: When the coil is either energized or de-energized, certain relays have a "shock…

Q: I. give the expression of the output Q * Ac & & Bc cc & & Do Your answer & ܘܝܡ

A: To give the expression of the output Q for the given logic circuit

Q: What is the equivalent transfer function of the following block diagram? R(S) 1 C(s)

A:

Q: (s + 1) 100 s² + 110s + 1000 A) Find the factors of Bode stander transfer function? B) For each…

A:

Q: 1. The position of a point in cylindrical coordinates is specified by (4,2π/3,3). What is the…

A: given the position of the point in cylindrical coordinates is specified by  4 , 2π3 , 3 generally in…

Q: 1. Referring to Figure 1, design a circuit that will achieve the same output Y by only using NOR…

A: The solution is

Q: 42 cm 16 m 16 m Determine the inductance per meter and the inductive reactance if the size of the…

A:

Q: Calculate the current required to produce a flux of 1.75 mwb in the ring, if the relative…

A:

Q: Compute the reactance of a 0.445 H inductor at frequencies of 61.0 Hz and 570 Hz. Enter your answer…

A:

Q: EX; use phasors and nodal analysis to find U₂ in (2) the circuit that shown below. 3jJz -sjur U2 N₂…

A:

Q: The D latch of Figure 1 is constructed with four NAND gates and an inverter. Consider the following…

A: It is given that:

Q: i need the answer quickly

A: The definition of data acquisition is given below

Q: a. Formulate KVL on input or base loop! b. Calculate and determine IB! c. Calculate and determine…

A: The required parameters can be calculated by using the DC analysis of the amplifier circuit.

Q: Refer to the circuit below. The value of the current I is: OA-1.33 A OB. 3 A OC. 1.33 A OD. 4 A…

A: Given circuit,

Q: Which one of the following descriptions is true? Increasing the n-type dopant concentration will…

A: The objective is to determine the correct option.

Q: A diode is a two terminal device. The application of a voltage across its terminals leaves three…

A: Diode- Diode is an electronic device which has two ports for supply connection. It is made up by the…

Q: . Compute the output impedance of the circuits shown in Figure. Vcc J HKQ₁ Rc Rout *

A: Output impedance is defined as the impedance which is seen from output terminal by considering input…

Q: npn -24 - عند استخدام تـرانـزسـتـور npn transistor was used as a current كمكبـر لـلـتـيـار فـإذا…

A: Given, A NPN transistor is being used as a current amplifier. Base current, IB=1 mA Current gain,…

Q: At what frequency is the reactance of a 0.435 H inductor equal to that of a 2.80 μF capacitor?…

A: Given: Inductance, L=0.435 H Capacitance, C=2.80 μF

Q: List, separately, the various sources of random noise and impulse noise external to a receiver. How…

A: Noise is just a sound that is unpleasant to hear; it can be a variety of sound from the environment,…

Q: ROΣ) ge +81 s(s2 + 100) -OY

A: NOTE- Handwritten answers are not provided on the portal. a) Consider the general form of closed…

Q: t w = 10000, the system H(s) = 10000*((s+100)(s+100))/((s+1000)(s+100000)) has a gain of: O A. None…

A:

Q: 3.17 Let f(t) be a T-periodic signal and let g(t) be the signal given by 8 (t) = ² ft f(u) du. a…

A: It is given that: gt=1a∫t-atfudu       0<a<T

Q: A current of i(t) = 0.49 cos (18 t-57°) A is applied to an inductor L = 4 mH as shown. What is the…

A: The magnitude of phasor always represent in RMS value.

Q: If u(t) is the input to the system H(s) = 1/(s+100), the output of the system would be: O A. None of…

A:

Q: phase bundled transmission line of 200 km length consists of three ACSR  conductors as shown.…

A:

Q: Due to mutual inductance between two coils, there is an induced emf in one coil due to a change in…

A: Answer:True

Q: A uniform line charge of 2 µC/m is located

A:

Q: 1. Compare and comment the two plots you have obtained in Figure 8.5. Which motor has higher torque…

A: The plots show the variation in speed (rpm) of 2 machines against developed electromagnetic torques…

Q: Find the total capacitance in micro farads of the combination of capacitors shown in the figure…

A:

Q: R(S) + K C(s) s(s+7) (A) Find the overall transfer function (B) For what values of K, the system…

A: In this question,  We need to determine the overall transfer function?  We know closer loop transfer…

Q: Reduce to a single transfer function: R(s) G₁(s) G₂(s) 1 -1 -1 1 G₁(s) G₁(s) -1 -1 C(s)

A: The above signal flow graph is solved by using Mason's gain formula. By Mason's gain formula, the…

Q: Differentiate Step-down Transformer and Step-up Transformer

A: The transformer is a device that transfers electric energy from one circuit to another. Based on the…

Q: 50-Ω R and 70-Ω XL are in series with 120V applied. Find the impedance, total current, power factor,…

A:

Q: Problem 3: Find the Norton equivalent circuit external to the load resistor R? R₁ 2.4 02 20 V E + SA…

A:

Q: 6. To make the transistor operating as an amplifier, junction one should be biased, whereas the…

A: 6. Answer: forward, reverse   Explanation: a. It is a valid option. If one junction is forward…

Q: Q2: What is the difference between Half Adder(HA) And Half Subtractor(HS)? Output of HA are SUM and…

A: The output of half adder are sum and carry out. Where as output of half subtractor are difference…

Q: 32. A high power microwave pulse of the order of megawatts can be generated by: a. Magnetron b.…

A: 32) A High power microwave Pulse can be generated by Magnetron. hence, option "a" is correct.  a)…

Q: How many turns are needed in a transformer to step from 18 V to 24 V, if the secondary coil has 250…

A:

Q: 二.简答題 (共1 題33.4分) 1 Find the current phasor through the inductor www 102 -5j2 1040°V -10j2 10260° V

A:

Q: h no load? Fm-2 in-1h s/rad and km-15 in-1h/y (T] =KmVm-Emi) '

A: Solution- Given,Fm = 2 in-lbs/radKm = 15 in-lb/radωs = 150 rad/secinput voltage Vin = FKm ×ωs

Q: 3. The equation P = E²/Z can be used to determine the power delivered to an AC circuit. Is this…

A: The objective is to determine if the statement is true or false.

Q: Discuss the concept of an Electrical fault. How can we prevent such catastrophic incident for such…

A: Electrical Fault in an electrical equipment or apparatus  is a kind of imperfection in electrical…

Q: For the given close-loop system transfer function, determine its stability using Routh-Hurwitz Test…

A: for determine no of sign change  first construct routh table by transfer funtion chartersticts…

Q: Calculate the total resistance between the points A and B. www A 4 ohm (A) 0.48 ohm B) No answer 7…

A:

Q: 76612 (a) Design an Aryton (universal) shunt circuit to convert a basic PMMC meter with an internal…

A:

Q: 3. Sketch the output V for the given network below. 0 Si 20 V -20 V 100 k

A: