e the right answer and fill space of the following: -bits at a time Using 32 different phase angle, It is possible to transmit C) 4 bits B bits b) 2 bits d) 5 bits L pignal the bit rate is bps
Q: Bit length can be defined in terms of a. high and low frequency b. Propagation Speed c. Bit duration…
A: Complete the statement given, Bit length can be defined in terms of Using one word from the…
Q: 3. If the 5-bit 2's complement of X is equal to 10110, then without converting X to decimal, answer…
A: Given:
Q: The bit sequence 10110000110000000011 is transmitted using the following formats: a. B8ZS b. HDB3 c.…
A: Since you are asking multipart questions, we are doing first part for you. If you want solution of…
Q: Calculate the theoretical highest bit rate of a regular telephone line. The signal-to-noise ratio is…
A: Please find the answer below :
Q: 3. Draw the QAM analog signal that transmits the following bit stream: 0 1010010 1 0 0 1 1 0 1 1 1 1…
A: The Answer is
Q: Question 2: An even parity bit is a bit that is equal to 1, if the number of 1's in the input is odd…
A: 2 (a).
Q: nultiplexed, Find (a) the input bit duration, (b) the output bit duration, (c) 1 1 1 1 1 rame rate.…
A: Solution a. The input bit duration is the inverse of the bit rate: 1/1 Mbps = 1 μs. b. The output…
Q: In _____, the level of the voltage determines the value of the bit. a. NRZ-I b. NRZ-L c. both (a)…
A: In NRZ-L (NRZ-Level), the level of the voltage determines the value of the bit. In NRZ-I…
Q: Find the Bitwise AND, OR, XOR of the following bit strings: 01 1011 0101 11 0011 1101
A: Bitwise AND 01 1011 010111 0011 1101 01 0011 0101 Bitwise OR 01 1011 010111 0011 1101 11 1011…
Q: In_coding, signal is present in the first half of the bit duration , and it is zero in the second…
A: Note : the solution to the above question is discussed below Hope it helps you understand!
Q: Ten sources, two with a bit rate of 8 Mbps, four with a bit rate of 2 Mbps and four with a bit rate…
A: Given : Ten sources, two with a bit rate of 8 Mbps, four with a bit rate of 2 Mbps and four with a…
Q: 80) = (0, 1, 0, 1, 1, 0) and tâp Po) = (0, 1,0, 1, 0, 0). 2 bits output by this LFSR? nswer in the…
A: Lets see the solution.
Q: For a ______ channel, the Nyquist bit rate formula defines the theoretical maximum bit rate. a.…
A: Answer :- ( b ). noiseless
Q: block of bits with n rows and k columns uses horizontal and vertical parity bits for error…
A: According to the question, we have given block of bits with rows and columns uses parity bits for…
Q: 4. Given a location with 7 bits what is the minimum and maximum value that it can hold A) As an…
A:
Q: Match the given baud rate and the number of bits carried by each signal unit (baud rate, bits) with…
A: 1) bit rate=baud rate x no of bits per signal =1200*3 =3600 (Answer 1) 2)…
Q: Show, with the help of timing diagrams, how the binary data 101101 will be transmitted using the…
A: Timing Diagram A timing diagram is a special form of a sequence diagram. The differences between…
Q: Assume that the channel introduces an error pattern…
A: an error pattern “110100000110111011110111010100000001110100011010111011001000011”
Q: A device is sending out data at the rate of 1000 bps. How long does it take to send out (a)10 bits,…
A: We can calculate this by dividing the data rate by the amount of data we want to send. Below is the…
Q: "Assuming we are using 2's compliment system that is 1 byte wide (i.e. we can use a maximum of 8…
A: Let's find the Tmin and Tmax for 8 bits wide
Q: c) Calculate how many bits will be affected if we are sending data at 1 Mbps with noise of second.…
A:
Q: XYC.A5. What is the number of. bits per baud for the following. techniques? a. ASK with two…
A: Given: network
Q: In transmission, the medium carries signals in both directions at the same time. O a. both full…
A: In simplex transmission mode, Sender can send signals but that sender can’t receive the signal. In…
Q: Usually, it takes 10-bits to transmit one character. How many characters can be transmitted at a…
A: The correct answer is: (c) 120
Q: x[n]= x, (nT)= sin 27en -00 <n<0 Where F, = 1/T is the sampling frequency. (a) Plot the signal x[n],…
A: Requirements :- b(1) part using matlab and discreate signal ploting Approach :-…
Q: Q. 552 Bits are equals to how many Bytes?
A: This question is based on computer memory structure.
Q: 83. In ______, the change or lack of change in the level of the voltage determines the value of the…
A: In _NRZ-I_____, the change or lack of change in the level of the voltage determines the value of the…
Q: Cn =2 H log2 V Cs = H log2 (1 + S/N) Suppose we are sending a signal using 3 bits over a 8 kHz…
A: Signal to Noise ratio is the measure of signals strength relative to the Background Noise So,…
Q: How many characters per second can be transmitted over a 1400 -baud line in each of the following…
A: Answer Option B = > Asynchronous serial transmission with two stop bits and no parity
Q: in the communication channel every 0.0125 ms and no, communication errors are taken into account,…
A: The analog signal is sampled at a sampling frequency of 20O0 Hz using a 256 sampling level.a) How…
Q: The maximum data rate that a medium of 10 KHz and S/N ratio of 30 dB is roughly: Select one: О а.…
A: The maximum data rate that a medium of 10 Khz and S/N ratio of 30 dB is roughly
Q: In Return to Zero (RZ), the signal changes not between bits but a. before the bit
A: In Return to Zero (RZ), the signal changes not between bits but
Q: the change or lack of change in the level of the voltage determines the value of the bit.
A: In ---, the change or lack of change in the level of the voltage determines the value of the bit.
Q: ________ provides synchronization without increasing the number of bits.
A: In this answer I will be discussing about the method which provides synchronization without…
Q: 288. The inverse of the sampling interval is called the a. sampling rate b. delta rate c. baud rate.…
A:
Q: Assuming A and B are 32-bit signed integers, which of the following arithmetic operations can NEVER…
A: Overflow will occurs in the following cases: Addition of operands with same signs.(i.e., for both…
Q: 3. For a (7,4) code, the parity matrix is given following 0 1 1 1 1 1. For an incoming information…
A: U columns corresponding to the removed symbols are removed from the parity check matrix of the…
Q: How many characters per second can be transmitted o ch of the following modes? (Assume a character…
A: a. character transmitted per second =baud line/character code…
Q: In _________ transmission, we send bits one after another without start or stop bits or gaps. It is…
A: In synchronous mode is transmission we send a bit in sequence. That is one after another Without any…
Q: In 8 bit data transmission system the transmitted data X, Y and Z after adding an EVEN Parity. The…
A: Given 8 bit transmission system the transmitted data X,Y,Z after adding an EVEN parity and we need…
Q: YC.A6. Calculate the bit rate. for the given baud rate and. type of modulation. a. 5000 baud, FSK b.…
A: NOTE: ACCORDING TO COMPANY POLICY WE CANNOT SOLVE MORE THAN THIS. YOU CAN RESUBMIT THE QUESTION…
Q: 259. The relationship between data rate and signal rate depends on the value of a. data rate (N) b.…
A: Data Rate is the number of data elements that can be transmitted per second and represented by N…
Q: Consider an odd parity checking mechanism that is used between two devices. Assume that one error…
A: Error is a condition when the output information does not match with the input information. During…
Q: We want to transmit 600 characters/s, where each character is represented by its 6-bit ASCII…
A: Effective transmission rate is the rate at which information is processed by a transmission…
Q: A person want to transmit the data 1100110 to his friend using hamming code technique. Calculate (i)…
A: (1) The position of the bits 1,2,4,6,8 are power of 2 and they are called as Parity Bits. So these…
Q: A common measure of transmission for digital data is the baud rate, defined as the number of bits…
A: Summary:In this question, we are going to calculate the time taken to transmit a 640 x 480-pixel…
Q: Using the De-multiplexing technique, what is the results of processing 0 and 0 and 0 ? O a. 0 O b. 3…
A: In de multiplexing signal from one source is converted into multiple output signal.which means de…
Q: Make three problems regarding calculations of bit rate, baud or M-ary encoding.
A: The bit rate is calculated using the formula: bit rate=Frequency× channels × bit depth Problem1:…
Step by step
Solved in 2 steps
- 1-A system has received 2 bytes of transmission, with the first bit being an extra odd parity bit: 100001111, 001010101. Is there detectable error? 2- A digital recording of audio file is 120 seconds, with bitrate 44 Kbps. Write down the exact number of KB needed for this recording. 3-Write down the smallest number in decimal, that can be represented by 11bit signed binary98. Usually, it takes 10-bits to represent one character. How many characters can be transmitted at a speed of 1200 BPS? a. 12 b. 120 c. 1200 d. 1200072. In ______ transmission, we send 1 start bit (0) at the beginning and 1 or more stop bits (1s) at the end of each byte. a. synchronous b. asynchronous c. isochronous d. none of the above
- 107. In _________, the frequency of the carrier signal is varied to represent data. Both peak amplitude and phase remain constant. a. ASK b. PSK c. FSK d. QAMWhat is the bit rate for each of the following signals? A signal in which 1 bit lasts 0.001 s A signal in which 1 bit lasts 2 ms A signal in which 10 bits last 20 µsQ3: The bit stream 01101001, draw the sequence using following digital data formats : a)Unipolar NRZ , b) Polar NRZ ,c) Unipolar RZ , d) Bipolar RZ, e) Split Phase Manchester. * Note (that the question relates to communication materials)
- Assume that 150 characters with each character encoded as 8 bits will be sent out between two workstations 1(A).Find the number of transmitted bits for synchronous transmission. Your answer: 1.(B).Find the number of transmitted bits for asynchronous transmission.Kindly answer the following questions. (a) In digital systems, why are 1 's complement and 2's complement commonly used to represent negative numbers instead of sign and magnitude? (b) State two different ways of forming the 1's complement of an n-bit binary number.15. If a digital system uses a quantization of 16 bits and a sampling frequency of 1KHz, then what is total number of bytes stored in 1 second? a) 2000 bytes b) 2000 bits c) 16 bytes d) 16,000 bits e) 160 bytes