Electrical EngineeringQ22. Estimate the order of (i) Butterworth, (ii) Chebyshev approximation function needed torealize the filter described in fig. 2Loss dB55Fig. 2021000150020003000rad's

Given- To Find- (i) The order of Butterworth approximation function. (ii) The order of Chebyshey…

Answered: Electrical Engineering Q22. Estimate…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An audio signal has bandwidth of 5.8 MHz encoded by PCM. Given the total number of bits to represent a level are 10 bits, determine a. Total number of levels. b. Bit rate. c. PCM bandwidth. d. SQNR in dB. Assume unity normalized signal power.
Design a Butterworth filter with at least -60dB attenuation at ohm=3000pi rad/s and -4dB attenuation at ohm = 1000 pi rad/s.
Given the signal flow graph, apply Mason’s Rule to acquire the single transfer function, G(s). Express your transfer function in a form where the coefficient of the highest exponent of s in the denominator is equal to 1. If there is a numerical answer that is nonterminating, it should be expressed up to three (3) decimal places only.
For the system defined by the first-order differential equation 100y'(t) + y(t) = x(t). a) Plot the log magnitude (dB)-log frequency graph of H(jw). b) The input is assumed to be suppressed when the magnitude of H(jw) is -40 dB. It is given that the x(t)=coswat signal is suppressed by this system. What is the smallest wa value in this case? Subject: Signals and Systems
A causal LTI filter has the frequency response H(jw) shown in the below Figure.Determine the input-output relationship in time domain. Determine the filtered outputsignal y(t) when the input is given by ?(??) = 1/jw(6+jw).
For the signal x(t) = 12 cos(2π350t + π/4), find the signals y(t) for each sampling frequency which will generate the same samples of x(t) but with the lowest positive frequency. (Hint: Sample at t = nT, fs = 1/T)a) fs = 50 Hertz b) fs = 125 Hertz c) fs = 500 Hertz d) fs = 1000 Hertz
The information signal m(t)=Cos200πt + Sin800πt is modulated DSB with the carrier c(t)=2.Cos4000πt. Then find the expression of the modulated signal since the VSB modulated signal is obtained with the Hv(f) filter given above.
An analog signal is given as x(t) = 5 + 2 cos(20πt) + 3cos(400 πt). a) What is the bandwidth of x(t)? Determine the Nyquist sampling frequency for x(t), both in radian/sec (ws), and in Hz (Fs).b) Formulate Xp (jw), the signal sampled with the Nyquist frequency. c) Plot frequency spectrum of the the sampled signal, Xp (jw). d) Determine the filter to reconstruct the signal x(t). e) Is it possible to reconstruct the signal x(t) for Ts =0.004 [s]? State that if aliasing error occurs or not.
Given x(n) as a complex valued signal, determine the DFT of xR(n). xR(n) = real part of x(n).
Evaluate the discrete-time convolution sums given below. Also, obtain the same result usingDTFT(i.e., DTFT and then inverse DTFT) for both cases. a)y[n]=u[n+3]∗u[n−3] b)x[n]=u[n]−u[n−2], h[n]=(0.5)nu[n] this is a signal systems question
Signals and Systems An analog signal is given as x(t) = 5 + 2 cos(20??) + 3 cos(400??)a) What is the bandwidth of x(t)? Determine the Nyquist sampling frequency for x(t), both in radian/sec (ws), and in Hz (Fs ).b) Formulate ?? (??), the signal sampled with the Nyquist frequency.c) Plot frequency spectrum of the sampled signal, Xp(jw).d) Determine the filter to reconstruct the signal x(t).e) Is it possible to reconstruct the signal x(t) for Ts = 0.004 [s]? State that if aliasing error occurs ornot
Find the V(s) / Vg(s) transfer function for the OPAMP circuit shown in the figure? also, find the forced response if Vg = 5e-10tcost20t volts?

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS

Electrical Engineering Q22. Estimate the order of (1) Butterworth, (ii) Chebyshex approximation function needed to realize the filter described in fig. 2 Loss dB 55 02 1000 1500 2000 3000 I 3 rad/s Fig. 2