Answered: Equation (1) represents the…

Equation (1) represents the characteristic equation of a digital control system. By using Jury test, Is the system stable or unstable? Q(z) = z' - 1.25z - 1.375z -0.25

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.6MCQ

See similar textbooks

Related questions

Q: (A) Create a hypothetical ROC curve based on Yonelinas's dual process signal detection theory…

A: (A) The figure below shows the graph for recollection equals 37% and d' equal 0.89,

Q: 2. What is pseudo-differential configuration?

A: Pseudo differential inputs are comparable to fully differential inputs in that they isolate signal…

Q: How is stability qualitatively defined for a closed-loop system? An unbounded input produces an…

A: In this question we will answer questions related to control system....

Q: Transmission degradation is caused by attenuation, distortion, and noise. What would be the remedy,…

Q: For a given 3R Planar manipulator, derive the transformation matrices and calculate the coordinates…

Q: h. Describe the classitication of control systems based on manipulated variables and controlled…

A: As per our policy, i am attempting first question, Classification of control systems based on…

Q: 1- The main steps of communication system are 2- The Armstrong's method convert the 3- The main step…

A: Communication system is the system which define the information exchange between two points. the…

Q: Explain difference between SNR and BER. Subject is Communication system

Q: Which of the following is false for the control system whose block diagram is given? I. Speed error…

Q: SRAM uses RAS and CAS control lines. True False

A: The statement is false because the DRAM is associated with RAS and CAS and both help in refreshing…

Q: For a given 3R Planar manipulator, derive the transformation matrices and calculate the coordinates…

A: It is given that: θ=30l1=l2=10 cml3=5 cm

Q: Question.2(a): If the analog signal travels over a transmission medium and its input voltage is 5.5…

A: Attenuation of signal: In the networking cables or connections, the attenuation is defined as the…

Q: 2. Consider the characteristic equation of a closed-loop control system, s'+3KS² +(K+2)s+4=0 Using…

A: s³+3Ks²+(K+2)s+4=0 For the range of k for system stable using Routh Hurwitz criterion .

Q: The role of air traffic control systems is increasing as airplane traffic increases at busy…

A: Global Positioning System (GPS) - The Navstar Global Positioning System is the official name for the…

Q: a) There should be a half-line difference between odd and even fields in a TV system using…

A: In the given question it is mentioned 27/a which means that only part(a) is to be solved. Kindly…

Q: System Stability What are the criteria for determining the stability of a system?

A: A system is said to be stable if it can regain its original state even after experiencing a…

Q: Using a ZN stability margin approach, provide the "proportional only" controller gain for the…

A: We need to find the proportional controller gain for the discrete-time process g(z)=z3z-1.

Q: Question 3 (A) Create a hypothetical ROC curve based on Yonelinas's dual process signal detection…

A: Solution (a) When recollection equals 37% and d equals 0.89

Q: For the given Sate diagram, design the state table? Syl (Sy0

A: STATE TABLE present state next state w= 0 w =1 output S0 SO S1 0 S1 S0…

Q: 1. (40) For a given 3R Planar manipulator, derive the transformation matrices and calculate the…

Q: 16.a. Which cable specification should you check before burying an outdoor fiber optic cable? A.…

Q: Which of the following is false for the control system whose block diagram is given? I. Speed error…

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: Question.2(a): If the analog signal travels over a transmission medium and its input voltage is 6.5…

A: Given, output voltage : Vo = 3V Input voltage: Vi = 6.5V

Q: The root-locus of a digital control system has an entry point at z=-2, breakaway point at z=0.4 and…

A: Given: The root locus of a digital control system has Starting point: z=0.3, 1, Breakaway point:…

Q: Question.2(a): If the analog signal travels over a transmission medium and its input voltage is 9…

A: Input voltage V1= 9vOutput voltage V2=3.5 VAttenuation in dB =10 log P1P2…

Q: Consider a home heating system consisting of a natural gas-fired furnace and a ther- mostat. In this…

A: A home heating system is a mechanism with the help of which house temperature is maintained at an…

Q: Why we use the modulation ?

A: The explanation is as follows.

Q: Is it possible to implement realtime face mask detection in Ryze Tello Drone?

A: Yes, It is possible to implement real-time face mask detection in Ryze Tello Drone. YOLO is the…

Q: DAS AL, BL is a valid instruction Select one: True False

A: DAS stands for Decimal adjust subtraction. it performs decimal adjust after subtraction.

Q: function is given by, G(s) = 90(S+9) / S2(S+2)(S+6) Determine the following:

A: Here i have solved it using the information provided.

Q: explain project scope management process completely and their techniques.

A: Find the answer below. The complete amount of work required to achieve a good, service, or outcome…

Q: Consider a sampled data system y(k) 5 U(t)- ZOH By choosing a sampling interval of T=0.2s, obtain…

A: Given :

Q: What are the features of RAID systems?

A: => RAID system splits data across any number of disks allowing higher data throughput. =>…

Q: . Briefly discuss the main differences between Butterworth and Chebychev Type 1 filters.

A: The main difference between them is the fast transition in chebyshev filter.

Q: Consider an audio recording system where the microphone generates a continuous voltage in the range…

Q: Compare and analyze between GPS and differential GPS in aircraft highlighting safety factors and…

A: S.No. GPS Differential GPS 1. Only one receiver is used Two receivers are used 2. Accurate…

Q: Why FT-IR instrumentation is superior over IR instrumentation? Please shortly answer at your own

A: The explanation is as follows.

Q: a. For what range of values of the parameters K and p is the system stable? b. Plot the stability…

A: (a). The two blocks, G1(s) and G2(s) are in series.

Q: 1. The closed-loop transfer function of a control system has a denominator polynomial equals to s +…

Q: 'shows the block diagram representation of a control system. Simplify the following block diagram…

Q: Using Routh-Hurwitz criterion, determine the relationship between KE edback control system whose…

Q: 20)What is the velocity error constant K, of the compensated system? V

Q: Consider the pole-zero plots shown below. Without doing any calculations and using only the…

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: 2. The role of air traffic control systems is increasing as airplane traffic increases at busy…

A: Global positioning system navigation satellites are used to determine the actual position of flight.…

Q: Q.12: For the circuit shown, Find the transmission parameters (A-Parameters)?

A: Given:

Q: Q.Explain sources of noise and its type(electrical amd static noise) in detail?Explain magnetic…

Q: 2. The role of air traffic control systems is increasing as airplane traffic increases at busy…

A: The block diagram for the air traffic controller using GPS for the aircraft collision avoidance by…

Concept explainers

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.

Question

Equation (1) represents the
characteristic equation of a digital
control system. By using Jury test, Is
the system stable or unstable?
Q(z) = z' - 1.25z - 1.375z -0.25
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q / Consider a cellular system with 500 total allocated voice channel frequencies. Calculate the mean S/I ratio for cell reuse factor equal to 4,7, and 12. Assume omnidirectional antennas with six interferers in the first tier and a slope for path loss (γ = 4). Discuss the results
Consider a garden house where the radio channel TRT Radyo 4 is constantly open has an installed power of 450 Watt. There will be an average of 10 hours of energy consumption. How many solar panels and batteries are needed?
Four received power measurements were taken at distances of 100 m, 200 m, 1 km, and 3 km from a transmitter. These measured values are given in the following table. It is assumed that the path loss for these measurements follows the model in Equation (4.69.a), where do = 100 m: find the minimum mean square error (MMSE) estimate for the path loss exponent, n
a. Between a GEO and a +65⁰ HEO satellite, explain which one would provide a better satellite communication service for a ship in the Arctic Ocean and why? Assume that the ship is within both the satellites’ footprints. b. Would the same +65⁰ HEO satellite provide a good satellite communication service for an Antarctic polar station and why?
Find the basic path loss for a communication link from Moon to Earth operating at 4000 MHz. The distance between Moon and Earth is 384000 km.
Determine the fade margin for the following conditions: distance between sites, D = 40 km; frequency, f = 1.8 GHz; smooth terrain; humid climate; and a reliability objective 99.99%
Determine the systems stability using the Routh Hurwitz Criterion for Stability. 1. Number of Poles in the Left-Half Plane?2. Number of Poles in the jw-axis? 3. Number of Poles in the Right-Half Plane? 4. What is the stability condition of the given system? (stable, unstable, or maginally stable)
Why we use FT-IR instrumentation? Please shortly answer at your own words.
Satellite orbits are classified by their distance from the Earth’s surface: LEO (low earth orbit, 160–2000 km), MEO (medium earth orbit, 2000–20000 km), and GEO (geostationary earth orbit, 35786 km). Find the round-trip delay of data sent between a satellite and the earth for LEO, MEO, and GEO satellites, assuming the speed of light is 3 × 10^8 m/s. If the maximum acceptable delay for a voice system is 30ms, which of these satellite systems would be acceptable for two-way voice communication?
2. Explain the following (a) sensitivity of a receiver (b) selectivity of a receiver. Why are these important characteristics? In what units are they usually expressed?
Which row represent the most stable system and why? nyquist and root locus plot attached.
The following problems refer to grounding requirements. Give the source of yourresponses. 1. If they are present, what items are required to be bonded together to form a groundingelectrode system?