etermine the difference in water surface elevation between tanks (open to the atmosphere) if there are two bends(R/D=2.0) and a fully open gate valve in the pipeline

Q: The water level at the back of a dam across a river is at constant elevation of 100 m. It supplies…

A:

Q: Two open tanks are connected by an orifice having a cross sectional area of 0.004 m^2. Tank A is…

A:

Q: he water surface in reservoir A is 6m. higher than that in reservoir B. A 150-mm diameter pipe 270-m…

A: Bernoulli's equation: Bernoulli's equation is also known as Bernoulli's theorem. Bernoulli's theorem…

Q: The volume of water through 15 second is 315 mL, the diameter of the orifice meter is 6mm, and the…

A:

Q: NOTE (h in ft) h = 8.881 ft Problem II. A proposed elevated tank for a certain community has a…

A: Given  Unit weight of water= 62.4 lb/ft3  Height of tank = 120 inches

Q: -Q.4 MASS FLOW AT A PIPE JUNCTION Consider the steady flow in a water pipe joint shown in the…

A:

Q: Two vertical tanks are connected near the bottom by a short tube having a cross sectional area of…

A:

Q: Two pipes, A and B, are connected to an open water tank having a surface area of 1000 m². The water…

A: (b) is the correct answer.  Make any assumption(either leaving or entering) then apply the…

Q: A commercial solvent at 20°C flows from tank A to tank B through 152 m of new 150-mm asphalt-dipped…

A: We have to solve for value of flow in system.

Q: The pipe connection shown shows a series-parallel connection. The rate of flow in the pipeline 1 is…

A: f = 0.02  Q1 = 300 lit/sec = 0.3 m3/sec

Q: Water is being discharged from a reservoir through a turbine as shown. Determine the elevation of…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: Pipe 1 is 450mm dia. and 1800m long, Pipe 2 is 300mm dia. and 1500m long, and Pipe 3 is 250mm dia.…

A:

Q: A pipeline of 600 mm diameter and 4 km length connects two reservoirs. The difference of water…

A: Given data in question  Diameter of pipe Length of pipe Value of f Difference in water levels of two…

Q: Water discharges through an orifice on the side of a  large tank. The orifice is circular in cross…

A:

Q: Friction loss in pumping oil to pressurized tank an oil having a density of 833 kg/m3 and a…

A: Oil density=833 kg/m3 Viscosity=3.3x103 Ns/m2 Steel pipe nominal size=3 inch Pump efficiency=65%

Q: A submerged gate 1 meter wide has height of water from the bottom and top of the gate as 3.5 and…

A:

Q: A Venturimeter having a throat diameter d2 of 100 mm is fitted into a pipeline which has a diameter…

A: The given data is as follows: Throat diameter, d2=100 mmDiameter of pipeline, d1=250 mmSpecific…

Q: The pipe network shown in the figure represents a sprav rinse system Find the flow in each pipe…

A:

Q: Q1, ( through a filter and then is circulated back to the tanks as shown below. The flowrate is 0.08…

A: Given, Q = 0.08 cfs v = 1.21 x 10-5 ft2/s

Q: Q2-595: Water flows from a reservoir through a series of three pipes. From upstream, first pipe of…

A: Schematic representation:

Q: 2. A nozzle 3 m long has a diameter of 1.3 m at the upstream end and reduces linearly to 0.45 m…

A: Figure is as shown

Q: 5) A 150mm x 50mm venturi meter set up is installed in a vertical pipeline. Determine the flow if…

A:

Q: A circular tank has an 34mm diameter orifice on one of its sides discharging oil with a specific…

A:

Q: If the flow velocity in the 2nd pt. of a pipe is 1.2 m/s, find the a.) minor head loss (mm) between…

A: V = 1.2ms D1 = 700mm D2 = 210mm LD = 27

Q: A small orifice 0.0003 m³ in area is in the vertical side of a rectangular tank. The  horizontal…

A:

Q: A vertical venturi meter 150mm diameter is installed in a 300mm diameter vertical pipe as shown. The…

A: When we neglected the head the discharge is calculated by the following the formula  Q…

Q: A closed cylindrical tank 3m high and 1m in diameter contains 1.2m of oil (SG = 0.8), 1m of water…

A:

Q: Determine the flow in each of the pipes shown in the figure. Assume f= 0.02 or all pipes. EL. 90 m…

A: Flow rate is generally the volume of fluid per unit time passes through a point area. Normally the…

Q: A reservoir discharges a liquid to the atmosphere through a horizontal of pipes. The pipeline…

A:

Q: Two pipes 1 and 2 are connected in series. Pipe 1 is 200 mm in diameter and 300 m long while pipe 2…

A:

Q: 4) A 150m long, 15cm diameter cast iron pipe discharging at elevation 6m higher than the oil surface…

A:

Q: water. A sharp-edged orifice 150mm in diameter with C-0.60 is located at the lowest point. Determine…

A:

Q: 2. A nozzle 3 m long has a diameter of 1.3 m at the upstream end and reduces linearly to 0.45 m…

A: As per Bartleby policy i can answer  only one question at a time. Please upload other questions…

Q: A cylindrical tank with vertical axis contains water. A 50 mm orifice is located at the side 0.60 m…

A: Given: Diameter of the top orifice = 75mm, Diameter of the lower orifice = 50mm, Both orifices have…

Q: EXAMPLE. An open cylindrical tank is 6 ft in diameter and is filled with water to a depth of 10 ft.…

A: There is an orifice within the fluid that passes through it. As compared to its other dimensions, an…

Q: Venturi meter having a throat diameter of 150mm is installed in a 300mm diameter horizontal pipeline…

A:

Q: For the water shooting out of the pipe and nozzle under the condition shown, compute velocity at the…

A: PA=55kPa DA=200mm DN=100mm

Q: Q5) Heavy fuel oil flows through 3 km of cast iron pipe having a diameter of 250 mm. If the…

A:

Q: An orifice meter with orifice diameter 15 cm is inserted in a pipe of 30 cm diameter. The pressure…

A:

Q: Question 3: 150 m long commercial steel pipe is to convey 30 L/s of oil (s=0.9, p=0.038 N.s/m² from…

A: Given values: Length, L = 150 m Q = 30 L/s s=0.9 μ=0.038 N.s/m2 hL = 2 m k = 0.19 for open pipe.

Q: .) A pipe system, connecting two reservoirs whose difference in water surface elevation is 13 m,…

A:

Q: Water at 40°C is flowing from A to B through the system shown in Fig. 11.22. Determine the volume…

A: Given data:- α1=4 in=0.1016 mα2=6 in=0.1524 mPA=PB=101325 PaZA-ZB=10 mρ=1000 kg/m3μ=6.5×10-4 N-sm2

Q: Pa. Assuming that the suction and discharge sides of the pump are at the same elevation, find the…

A: Given data Specific gravity of oil, SG=0.82 Flow rate=0.07 m3/s

Q: An orifice 50 mmø with C= 0.60 is located at lower portion left side as shown. An open mercury…

A: The maximum height at which a pump can transfer fluid against gravity is called head. This is the…

Q: Q=300 liters/sec.1 D-202.7 mm of L₁=300 m D₂=202.7 mm Ø L₂=150 m BY D3=202.7 mm Ø L₁=75 m D-381 mm Ø…

A:

Q: Pipes 1, 2, and 3 are 300 m, 150 m and 250 m long with diameter of 250 mm, 120 mm and 200 mm…

A:

Q: Oil with sp. gr. of 0.87 is being pumped from a lower reservoir to an elevated tank as shown. The…

A:

Q: Pipes 1, 2 and 3 are 300 m., 150 and 250 m. long and 25 cm. 12 cm. and 20 cm. diameter with friction…

A:

Q: Fluid mechanis Read the question carefully, give me right solution The head loss (hf) in a 1200mm…

A: The Head loss of a Non Circular (Rectangle ) duct is Given as:hf=fLv2Dh×2gv=velocity of flow.L=…

Q: L= 800m D = 250mm 2 L= 500m L= 300m L= 350m L= 300m D= 300mm D = 250mm D = 200mm D = 250mm 3

A: Given:- 1:- L=500m,D=300m 2:- L=800m,D=250mm 3:- L-300m,D=250mm 4:- L=300m,D=200mm, 5:-…

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.