EX: 0 at what temperature will be The Fermi distribution of electron with energy K₁₂ = 8.6x₁0² cv at home: Determine FCE) for electrons if The energy. gap of Ge is 0.66cv at T= 300 K E-Ef gap E=0.5 Ef is equal to answer > T=1262.24 KⓇ . ا... → at home

Q: Q: Answer the following sentences with (True) or (False) then correct the false sentences: 1- The…

A:

Q: 9. The current I (in amperes) through a section of wire varies with time t (in seconds) given by the…

A: In this question , current through wire is given....We have to find out charge.....

Q: Let the periodic function be f(t) = |t| , -π < t < π . Solve the following points: a) Draw the graph…

A:

Q: According to Coulomb's Law, force between two point charges is a. x (distance)² b. x (distance) c.…

A: According to Coulombs law, F=kq1q2r2 Where, F is electric force q1,q2 are charges k is coulomb…

Q: QI) a straight current segment of 0.5 m length and carry a dc current I in a uniform field of B-40…

A:

Q: Diagram of the problem, necessary formulas, clearance and numerical solution. A steady current of…

A:

Q: Draw the equivalent one flip-flop per state of the given ASM chart.

A: To Follow the steps: 1. Represent each states by state boxes. 2. Put input in decision box after…

Q: 7. Convolve a signal with values x = [3,5,-2] with a system that has the following impulse response…

A:

Q: What is shop drawings, why we use them?

A: Shop drawing : A shop drawing is a unmarried drawing or a sequence of drawings created by using a…

Q: (c.) Determine the core loss when the transformer is connected to a 4700 (primary) volt 60 cycle…

A: Given: A 60 kVA 4800/460 volt, 60 cycles, distribution transformer has the following resistance and…

Q: 5. A motor connected to a 220-V supply line from the power company has a current of 7.6 A. Both the…

A: given that  voltage of single phase motor =230 V                                       Current= 7.6…

Q: Calculate the input voltage if the final output is 10.08 V. 10 kn 5 ΚΩ 5 ΚΩ 5 ΚΩ 100 ΚΩ V₂ O 0.168 V…

A:

Q: QUESTION 6 R www L m + 12 cos 3t V Vo 4 sin 2t A 10 V If we would like to use Superposition to solve…

A: Given here a electrical circuit and asked to find amplitude of Vo by considering only current…

Q: In a series R-L-C circuit, the resistor has a reactance of 2 ohms, the capacitor has a capacitance…

A: Given: Series R-L-C circuitR=2ΩC=0.5FL=9H

Q: In RL series circuit, voltage across resistor is 6V and voltage across inductor is 8V. Power factor…

A: Given: In RL series circuit Voltage across resistor, VR=6 V Voltage across inductor, VL=8 V

Q: Two point charges of 280 statcoulomb and 78 statcoulomb are 4.2 cm apart. if another point charge is…

A: System will be in equilibrium only when force on all the charges will be zero Since magnitude of…

Q: b 800 빠 9.0 V 내가 R ww R₂₂ a

A:

Q: e response of a servomechanism is c(t) = 1 + 0.2e60 - 1.2e 10t when subject to a unit step. Obtain…

A:

Q: What is the SOP function for inputs A=1 B=0 C=1?

A: In the given problem three inputs are given so that eight combinations are possible.

Q: 1- The FNBW is greater than HPBW. 2- The side lobes do not appear in linear wire antennas. 3- The…

A:

Q: Circul brushes. The field current is 1.8 A Determine (full-load line current (ii) full load shaft…

A: In this question , we will find full load line current , shaft torque etc of dc shunt motor....

Q: Derive the operating point ,Q-pt.,  of the BJT voltage-divider bias circuit shown using Exact…

A: Given:IC=βIBIE=(1+β)IBVBE=0.7

Q: For the Δ - Δ circuit of figure below, calculate the phase and line currents. ( A 30 Ω 173/0° V j10…

A:

Q: Unless given, use the: POLAR FORM for voltage and current, RECTANGULAR FORM for impedance. Consider…

A:

Q: In the Y-A system shown in figure below, the source is a positive sequence with Van = 24020° V and…

A:

Q: What is the cut-off frequency of the circuit below if R1 = 3645.24 Ω, R2 = 4039.54 Ω, R3 = 94.63 Ω,…

A:

Q: Length of Director , LD Length of Reflector,LR Spacing from Director to Driven Element, SR-DE

A: Since there are multiple sub-parts, as per the guidelines, in the following section, only the first…

Q: How many op-amps are required to implement this equation? Rf V₂ Vo R3 2 01 3

A: given here a equation and asked to find the number of op amp required to implement the equation.

Q: A carrier signal given by 10 cos 2m x 10°t volt is FM modulated by single tone Hz message 4 cos 2 x…

A: It is given that: ct=10 cos2π×108t Vm(t)=4 cos2π×103t Vkf=1000 Hz/V

Q: Circuit Diagram R1 L1 50Q 10mH V1 220 Vrms C1 10uF ~60 Hz 0° Computed Values Compute the expected…

A: Capacitor: This is an energy storage device that store the energy in the form of the electric field.…

Q: A three-phase motor is connected to 410 V. The motor is located 900 ft from the power source, and…

A: Three-phase motors (also known as 3-phase motors) are widely employed in industry and have…

Q: A balanced negative sequence 3-phase system consist of Y-connected load supplied by a balanced…

A:

Q: X. X ਜ਼ X₂ DoDelay Delay Q₁ N

A: In asynchronous circuits device state change at any time response to change inputs. Digital…

Q: 8. A 200 V d.c. series motor takes line current of 25 A when runs at rpm. The armature resistance is…

A: In this question we will find resistance needed in series with armature to reduce speed...

Q: A series RLC circuit having values of R = 2500, L = 3mH, and C = 4uF is shunted across a sinusoidal…

A: Sinusoidal signal are represented in phasor form.Phasor form is express as its amplitude and phase…

Q: A 240 V, 1000 rpm 100 A, separately-excited d.c. motor has an armature resistance of 0.04 2. The…

A:

Q: Referring to the Figure 1 below, set the value of voltage Vs as: - Vs (rms) = (120+the last 2 digit…

A:

Q: 1+ V1 R1 R2 resistor is an electronic component that determines the amount of electric current in…

A: Given data, R1=461 Ω Current flowing though the circuit i=7.85 mA = 0.00785 A Supply voltage V1=7 V

Q: Q/2/Determine the input impedance (ZT) and current (IT) of the series network consist of (R = 50, X₁…

A: In this question,  We need to determine the equivalent impedance ZT  and total current IT   Also…

Q: The transfer function T(s) of a negative feedback control system is 2s/(s² + s + 2). If the…

A: Given: Closed loop transfer function, Ts=2ss2+s+2 Open loop transfer function, Gs=2s+1

Q: Give the color bands of the following resistors with 10% tolerance:  1. 1k Ohms 2. 220 Ohms 3. 1.5…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: 8) Find the instantaneous voltage across a 8-μF capacitor when the current passing is i = 2sin (60t…

A: In this question,  We need to determine the instantaneous voltage across the 8uF capacitor  If…

Q: Determine vo and I in the circuit shown in the figure below. 4Ω ww 12 V 6Ω www Vo + 25. 4V (1+

A:

Q: 1) There is no initial energy stored in this circuit i(0) = 0. Find i1 (t) fort > 0. 8.4 Η 10 Η +…

A:

Q: List the responsibilities of the project contractor

A:

Q: Question 4 Two single Phase loads have the following characteristics Load 1: 40Kw, pf= 0.8 Lagging,…

A: Transformer is a static device which is used to step up or down the voltage/Current level without…

Q: I need answer in your hand Three-phase bridge controlled rectifier supplies a d.c. resistive load of…

A: Given: Three-phase bridge controlled rectifier supplies a d.c. resistive load of 300 V, 60 A from…

Q: 9- Design equation F(A,B,C,D)={(1,2,5,9,10,11,13,15) using a 8x1 Mux? Inputs F ABCD 0000 0 0001 1…

A: Brief description : In the above given question we need to implement the given list of minterms by…

Q: 1: Choose appropriate letter a, b, c or 1. In a two-port network, the output short-circuit current…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A 250 V, 10 hp series motor is mechanically coupled to a fan and draws 30 A and runs at 500 rpm when…

A: Given data, Terminal voltage V = 220 V Armature current Ia=30 A Armature resistance Ra=0.5 Ω Series…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.