Ex (5):-. A compact disc (CD) records audio signal digitally by using PCM. Assume the audio signal bandwidth to be 15 kHz. (a) What is the Nyquist rate? (b) If the Nyquist samples are quantized into L = 65536 levels and then binary coded, determine the number of binary digits required to encode a sample. (c) Determine the number of binary digits per second (bit/s) required to encode the audio signal. (d) For practical reasons, signals are sampled at a rate well above the Nyquist rate. Practical CDs use 44,100 samples per second. If L 65536, determine the number of bits per second required to encode the signal.

Ex (5):-. A compact disc (CD) records audio signal digitally by using PCM. Assume the audio signal bandwidth to be 15 kHz. (a) What is the Nyquist rate? (b) If the Nyquist samples are quantized into L = 65536 levels and then binary coded, determine the number of binary digits required to encode a sample. (c) Determine the number of binary digits per second (bit/s) required to encode the audio signal. (d) For practical reasons, signals are sampled at a rate well above the Nyquist rate. Practical CDs use 44,100 samples per second. If L 65536, determine the number of bits per second required to encode the signal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What is the "Nyquist-Shannon sampling theorem," and how does it impact digital data transmission?
In the figure below, an x(t) signal varying between +- 1.6 V is split into 8 quanta levels and converted to a digital signal. being converted. a) Calculate the quantization gap voltage (step)? b) Draw the PAM, PCM and ASK outputs in this conversion process? c) Calculate bit transmission rate if sampling pulse frequency ?? = 2kHz.
Q4. a) Consider a bandlimited message signal of 6kHz bandwidth. It is sampled at the rate of 55% higher than the Nyquist rate. The maximum quantization error of the sample amplitude is 0.5% of the peak amplitude? . Assume binary encoding. Calculate the minimum bandwidth ? of the channel to transmit the encoded binary signal.
Question 1(Nyquist-Shannon sampling theorem.) Give detailed information about the Nyquist-Shannon sampling theorem. Explain what Aliasing is in the sampling theorem.
)A compact disc (CD) records audio signals digitally by using PCM. Assume the audio signal bandwidth to be 15 KHz, and the Quiantization level is 65536 a. What is the Nyquist rate? b. lf the Nyquist samples are quantized into L-65,536 levels and then binary coded, determine the number of binary digits required to encode a sample. c.Determine the number of binary digits per second (bits/s) required to encode the audio signal.
A PCM system is used to transmit base4 signal of 512 level, the input signal works in the range between (30 to 70) MHz. Find the bit rate and signal to noise ratio in dB? Note that: the step size is considered to be double of system levels? *
Consider the analog signalx(t) = 3cos2000pit + 5sin6000pit + 10cos12000pit(a) What is the Nyquist rate for this signal?(b) Assume now that we sample this signal using a sampling rate Fs = 5000 samples/s. What is the discrete time signal obtained after sampling?
If you are concerned about sampling frequency and bit numbers for your data, which should you be more concerned about? In other words which will impact the replication of your signal more?
draw the spectrum ideal Sampling and Natured Sampling??
Consider a digital radio that uses a digital modulation scheme of the 128 QAM type, the width of the allowed radio channel is 40Mhz, determine the maximum speed that could be used in this modulator to meet the bandwidth requirement of the radio channel. RF
What is a minimum number of sampling frequency required to have distortion free reconstruction of a digital signal from its samples?
A PCM binary stream is produced using an 8,000 samples/s rate and 7-bit encoding. 32 synchronization bits are inserted into the binary stream for every 224 data bits. The resulting binary stream is then transmitted in two-level pulses over a baseband channel, with r = 0.2. This is followed by digital band-pass modulation before the transmission. a. What is the bandwidth of the baseband transmission? b. Determine the bandwidth of the pass-band transmission under the following digital modulation schemes: c. BPSK. d. QPSK. e. BASK.