Example 10: Using Kirchoff's law, find the currents and the voltages and Calculate power dissipated in each resistor in the circuit shown I1 8 2 + v1 - I2 I3 30v 3 2v2 v3

Q: Given the circuit diagram below: V2 Va If v1 = 3V, v2 = 3V, v3 = 9V, v4 = 1V, i1 = 6A, i2 = 1A, and…

A: Given V1=3vV2=3vV3=9vV4=1vi1=6Ai2=1Ai3=8A

Q: Q2: For the circuit in figure shown, determine the current in the neutral line. A ww 880/0 V 25-j102…

A: In a three phase system there are two ways to connect a three phase load. Star/Wye Connection Delta…

Q: 1. Find the power delivered to the 82 resistor, using Kirchhoff's Law. R1 R3 402 I=V1/16 R2 }7A

A:

Q: (ii) A power station supplies the following loads to the consumers: Time in hours 0-6 6-10 10-12…

A: (a): The load curve can be drawn as:

Q: Q3) For the circuit shown, find the condition for maximum power transfer to the load. Then, find the…

A:

Q: 9. Determine the currents I1, I2, and 13 USING KIRCHHOFF'S LAWS 2 ohm 3 ohm 3 ohm I1 12 13 6 V 6 V 3…

A: Find currents I1, I2, I3 using kirchoff's law?

Q: Obtain the power at Rg. If R1 through Rg is 10 ohms. V1 = 20 V,V2 = 30 V, V3 = 45 V, V4 = 100 V.

A:

Q: H.W:- Write the nodal equaious K find the Voltage across the 22 resislor Sor net. shown? 2 65 240v

A: Given circuit shown

Q: For the figure shown below: a) Use repeated source transformations to find the value of v̟ b)…

A: Given circuit,

Q: For the Circuit shown in fig iT = I1 Sin (1004+10") +13 (sin 300++20²) + Id sin (yoot if I +36)A In…

A: Capacitive reactance is inversely proportional to frequency  Inductive reactance is directly…

Q: Example : Determine the voltages V, Vg1 and V for the cct. shown. R, 2 ka R2 5 kn R33 V3 8 kn

A: Need to find all voltages

Q: 2. Find the current flow at 10 2 resistor using Kirchhoff's Law. R1 R3 10 ΩR 10 ΩξR4 (1) 2A 12 V

A: In this question,  Find the current flow at 10 ohms resistor using Kirchhoff's Law We know I= V/R

Q: 3. Solve for the branch currents using any method. 50 ww 10V 122 www 102 102 12V 150 ww

A:

Q: R,$42 12V R 82 32 Example 8: Determine the unknown currents and voltages R=62 R=62 ww R-22 24V R.80…

A:

Q: Using Mesh analysis, find the power consumed by each resistor and the voltages at eac resistor. 9Ω 2…

A:

Q: Q2) For the circuit shown, find the condition for maximum power transfer to the load. Then, find the…

A:

Q: 10V 5 4 12 V 8 1 Determine the value of the current passing through a resistance of 8 2 in the…

A:

Q: HwiDuse Thevenin theorem te Find the current flowing through 6 resistor

A: For Thevenin's Equivalent circuit, remove the target element 6Ω Find Thevenin's resistance RTH For…

Q: Q3: For the network shown in figure (2), determine the power factor and what can be done to improve…

A: In the circuit What is power factor of the circuit How to improve the power factor?

Q: Don't handwritten please

A: Let us consider  The current flowing in mesh (01) is I1 and current flowing in mesh (02) is I2  So,…

Q: D.) Using Norton's Theorem. Compute IL (Current flowing through Load). RL =6 Ohms R1 = 22 R2 = 62…

A:

Q: Q.1) By using Nodal theorem find (i,) and the power in 4 OHM resistor. 42 ww 80 ww 21 3A ww

A:

Q: Use nodal analysis to determine the voltage across 5 ohm resistance and the current in the 12 V…

A: Solution !!

Q: How do I calculate the currents Is, I1, I2, and I3? Given the RT 2.967 kOhms

A: The solution can be achieved as follows.

Q: If the voltage V, = 800 mv, then the current flowing in the load Is is: %3D 1:8 -j20n ell

A:

Q: Use a Y-to-A transformation to find (a) i,; (b) i̟; (c) iz; and (d) the power delivered by the ideal…

A: The solution can be achieved as follows.

Q: For the power system shown below, find the short circuit level and short circuit current at F. Take…

A: In this question we need to find a short circuit level and short circuit current.

Q: 15 V 12 Ω www + ή - Μ 6Ω 10 Ω www i 40 Ω Also calculate i1 and i2 in mA and the power dissipated in…

A:

Q: Q.38: For the circuit shown in figure beside, if the supply =5+20sin 1000t+10sin3000t+5sin5000t A…

A:

Q: For the circuit shown, Use Norton's Theorem 1) Calculate the current in the load connected across…

A: Given 1)

Q: R- 0.3 ohm R0.5 ohm 0.15 ohm R, Ea = 240V 3 ohms RA 4.1 ohms Rg Eb = 260.4V If

A:

Q: R₁ E₁ 40 10 V R₂ 30 E₂12 V R3 12 02

A: By using kvl method find current i in 3ohm resistance kvl states that in a closed loop algebric sum…

Q: For the circuit shown, Use Norton's Theorem 1) Calculate the current in the load connected across…

A: Given

Q: Question 1: (3 Marks) If the complex power delivered by the voltage source is S=18 + j9 VA. Find…

A:

Q: 0.003 VA 20V 200MA 0.4Va t. 2502 io 1002 S0052 2002

A:

Q: In the circuit shown below V =-1 V +3 V Find B 500 kn 4.8 kn 3 V

A: Bipolar Junction Transistor (BJT) is three terminal device and three terminal are Emitter ,Base and…

Q: Q2: For the circuit in figure shown, determine the current in the neutral line. A ww 880/0° V 25-j10…

A: We will apply KVL in three loops to find phase currents. Applying KCL at nautral to find current in…

Q: Example 10: Using Kirchoff's law, find the currents and the voltages and Calculate power dissipated…

A:

Q: 20x ix 10 Ω 8 A VB 82 12 VA Vc Vx f 1A assume the following node voltages were obtained for the…

A:

Q: Solve for the currents in various branches of the circuit shown in the figure below: V1= 25 V; V2=…

A: Given circuit, V1=25 VV2=10 V

Q: 1. Find the power delivered to the 80 resistor, using Kirchhoff's Law. R1 R3 402 I=V1/16 R2 7A

A: First we will find out voltage across 8 ohm then we will find power delivered to 8 ohm's .

Q: P1: Calculate current I, using Thevenin method. Assume i(t)=2√2 sin (wt-45°), e(t)=4√2 sin 3wt,…

A: Note: Since units are not mentioned, we will take the units of current sources as 'A', for voltage…

Q: Use Kirchhoff's laws to determine the value of the current i 60 2s Pa ЗА

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 2 ohm 3 ohm 3 ohm I1 12 13 6 V 6 V 3 V

A:

Q: Given the circuit below to model the power needs of EB1 and EB2: EBI: 14 kW, power factor = 0.35…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Example 2: If V2 = 30V, find the following: %3| R1 60 I3 + V2 R2 V3 R3 V, = 75 V 20Ω a) V1 and V3 b)…

A: In this question,  Find the voltage V1 and V3 as shown in the circuit, current in the circuit, power…

Q: 5 kN ww 10 V 20 V 4 mA 12 V 10 k2

A: The given circuit is:

Q: For the circuit shown in Figure, find the following: a. The magnitude of current in the circuit, I.…

A: The solution can be achieved as follows.

Q: Use ohm's and kirchhoff's law to find Vx, I input (Ient), and the power delivered by the dependent…

A: Given- Current source = 6 A Voltage across 2 ohm at node a = 2V Voltage across 2 ohm = 8 V To find-…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.