Examples For the networks in Fig. 1, determine the current husing branch-current analysis, and then find the voltage Vab. 6V 50 20 R, R,30 E 25 VEE, E, 60 V

Q: The voltage V(t) of a supply at regular intervals of At = 0.01 s, over a half-cycle, found to be {0,…

A: SIMPSON'S RULE : Simpson's rules are a set of approximations for definite integrals named after…

Q: Match the vocabulary terms with the correct statement. - 1. A device that measures the voltage…

A: These are few questions related to the understanding of basic electrical equipments and…

Q: (16) PSK and coherent ASK systems use the same peak pulse amplitudes and Ha the same values of P,…

A:

Q: 3. A 2,200-V, 3-phase, star-connected synchronous motor has a resistance of 0.6 2 and a synchronous…

A: Synchronous Motor is a doubly excited ac machine in which Main winding is excited by a External DC…

Q: Q3) For the circuit shown a) By using approximatę parallel´resoñant circuit find the resonance…

A:

Q: a) Define following terms: - Control system N, Z, P, gain margin, and phase margin b) Write the…

A: Nyquist and bode plot is an important methodology to find the stability of the control system  In…

Q: Thermal question. A system has two thermal layers. The first layer has a Rth 0.5 K/W, and Cth 0.8…

A: Thermal: Thermal refers to something that is caused or affected by heat or temperature. In science,…

Q: Determine the cutoff frequency of an op-amp having specified values B1=4 MHz and AVD= 171 V/mV.

A: Given  Bandwidth and voltage gain of an op amp.we need to determine the cutoff frequency. Please…

Q: 2) It is required to use a capacitor with Vms = 12V. Select a suitable voltage rating capacitor from…

A: Capacitance charges upto Vmax in charging stage Then it discharging from Vmax depending on external…

Q: a) Define following terms: - Control system N, Z, P, gain margin, and phase margin b) Write the…

A: a) In Nyquist plot, A closed Contour is configured in clockwise. A plot is drawn for 0+ <ω<∞,…

Q: An analog receiver system consists of an antenna and three cascaded Radio Frequency (RF) amplifiers…

A: An analog receiver system consists of an antenna and three cascaded radio frequency amplifiers as…

Q: For the circuit shown, find the expression for the output voltage in terms of Vx, Vy and Vz if the…

A:

Q: 8. Find V, for the circuit given below. RF is 10 μΑ, RF 1 ΜΩ V, ν, -?

A:

Q: 1. Two wattmeters are used to measure power input to a 1.5 kV, 50 Hz, 3-phase motor running on…

A: Dear student As per the guidelines of Bartley we supposed to answer first three subpart only for…

Q: Using an AC voltmeter, the potential difference in the electrical line in a house is read to be 234…

A: Given an AC voltmeter with, Potential difference, Vrms=234 V Hence, peak voltage, Vm=2Vrms=331 V…

Q: A waveform Vin ranged from 0 to 3 V needs to be scaled so the signal range is (-3,+3} V without…

A: First input and output relationship is obtained. Using superposition theorem remaining problem is…

Q: It is desired to step down the three phase voltage from 6600V to 460V using wye-delta transformer…

A:

Q: Use KVL, KCL, and Cramer's Rule to determine the second order equation for the inductive current…

A:

Q: . Determine the (a) direction of maximum radiation, (b) directivity, (c) beam solid angle, and (d)…

A: Given data: The given function is   F0,θ=1,  for  0≤ϕ≤60 and 0≤ϕ≤2π0,    elsewhere

Q: Suppose that your car will not start. To determine whether the battery is faulty, you turn on the…

A: Connect your car battery to a friend's car battery in series so that your car receives the maximum…

Q: II. Use the Table of Laplace Transform to find the Laplace Transform of the given function. a. te-3t…

A:

Q: 2. Determine the indicated parameters across terminals a and b. Consider each of the networks…

A: Given: Frequency is 60 Hz. Series combination of impedances is:Z=Z1+Z2parallel combination of…

Q: a) AC equivalent model is derived from the Bipolar Junction Transistor (BJT) modelling. Produce the…

A: "According to the Company's policy we will solve only the first part of the question as each part is…

Q: Q2/ Complete the following sentences: 1) If an A.C position is chosen of Input Coupling Selector in…

A: The oscilloscope is an instrument which can be used to monitor the electrical signals in a wire by…

Q: Determine the R2value for the summing amplifier given below so that the output voltage is – 3V. R2…

A:

Q: w.(2): Determine the cutoff frequency of the lowpass filter described by 4 H(@) = 2 + jw10 d the…

A:

Q: The ratio of the total charge on either plate to the potential difference between ? plates is known…

A:

Q: Q3:Calculate all currents flowing through resistors R1,R2 &R, by using Kirchhoff's Law. R1=32 R2 42…

A:

Q: Problem 2. We have the following circuit: P22 R. o Vout +15V opemp RI Vin o- Sud UI 15V R2 Find the…

A:

Q: 4. Which of the following statements accurately describes the difference between galvanic and…

A: Here are the few questions related to the basic understanding of galvanic cells and electrolytic…

Q: Using an AC voltmeter, the potential difference in the electrical line in a house is read to be 234…

A:

Q: A 400 – volt, three-phase, 50 Hz supply has three inductive coils each having resistance of 16 ohms…

A:

Q: R2 = 330 2 R, = 470 u R, = 820 2 R, = 680 2 R= 560 a R= 1202 %3D E, = 48 V R1 R 2 R 3 R4 R5 R6 TOTAL…

A: Complete the table of values for this circuit : To calculate the value in all resistance we have…

Q: 1. Determine the R2value for the summing amplifier given below so that the output voltage is – 3V. R…

A:

Q: what is the schematic diagram of TP4056 Micro USB battery lithium 18650

A: The lithium ion battery requires special complex circuitry to charge itself. Whereas the electrolyte…

Q: device that selects one of many inputs and links it to a single output. a Display of seven segments…

A: This is the question regarding digital circuits thete are basically two types of digital circuits…

Q: H.W: for the circuit shown in figure find: (a) the charge in each capacitor. (b) The energy in each…

A:

Q: Q2: Determine the stable range of the parameter (a) for the closed-loop unity feedback systems with…

A:

Q: Calculate the output offset voltage in mV for an op-amp specification listing with an input offset…

A:

Q: 2-A 33 kVA, 2200/220V, 50HZ single phase transformer has the following parameters. Primary winding…

A:

Q: RL 2. Vin is a 1kHz - 100 volt (peak- amplitude; 1 kHz) sine wave. The Triac X2 has the following…

A: In this circuit the operation & concepts of the given TRIAC circuit is discussed along with the…

Q: 1. Two wattmeters are used to measure power input to a 1.5 kV, 50 Hz, 3-phase motor running on…

A:

Q: Find the transfer function C3(s)/Vs(s) in the RCL circuit given below. s1. Aşağıda verilen RCL…

A: This problem can be solved by applying kcl

Q: 2. need another answer from different expert bcs first one is wrong

A: NOTE:- As per our company policy, experts are allowed to answer only 1 Question at a time, Still…

Q: Plot curve occ Field current(A) 1 2 4 7 8 O.C.C. Volts(V) 52.5 107.5 | 155 So tor the same tield…

A:

Q: Q2 For a 5 input resistive divider (0=0V, 1=10V) find The analog output voltage for a digital input…

A: This is a basic problem of ADC /DAC. The formula and calculation is shown in the next step

Q: Q2: Determine the stable range of the parameter (a) for the closed-loop unity feedback systems with…

A: closed loop is a automatic control system . In control system we use closed loop for feedback…

Q: Suppose that the variables 0x01 and Ox02 contain the values 0x82 and 0x83, respectively. What will…

A: A microprocessor is a type of tiny electronic device that comprises the arithmetic, logic, and…

Q: If V, is 9V, find the following values Vp, Vn, Vo. 50 k2 20 k2 Vo 10 k2 40 ka

A:

Q: A.) 1 example of DC analysis of darlington pair solved problem.

A: NOTE:- As per our company policy, experts are allowed to answer only 1 Question at a time, so only…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.