EXERCISES Exercise-1: Design a PLC program and prepare a typical I/O connection diagram and ladder logic program for the following motor control: ▪ A motor must be started and stopped from any one of three start/stop pushbutton stations. . Each start/stop station contains one NO start pushbutton and one NC stop pushbutton. Motor OL contacts are to be hardwired.

EXERCISES Exercise-1: Design a PLC program and prepare a typical I/O connection diagram and ladder logic program for the following motor control: ▪ A motor must be started and stopped from any one of three start/stop pushbutton stations. . Each start/stop station contains one NO start pushbutton and one NC stop pushbutton. Motor OL contacts are to be hardwired.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter6: Ground-fault Circuit Interrupters, Arc-fault Circuit Interrupters, Surge Protective Devices, Immersion Detection Circuit Interrupters, And Appliance Leakage Current Interrupters

Section: Chapter Questions

Problem 24R: Briefly explain the operation of an immersion detection circuit interrupter (IDCI)....

See similar textbooks

Similar questions

Industrial Motor Controls, 1.a. Where should the shield for the wire between the D/A module and the motor speed controller beconnected?A. At the D/A moduleB. At the PLCC. At the motor speed controllerD. At the auxiliary power supply1.b. If the battery backup fails on a PLC, what will occur?A. The PLC will shut down due to loss of memory as soon as battery voltage drops below a certain level.B. The PLC will illuminate the battery LED and extinguish the RUN LED.C. The PLC will operate normally; however, if power is lost, memory will be lost.D. The PLC may have logic solving errors until the battery is replaced.
write the truth table for PLC and discuss your answer
A) What is a PLC? B) What is the difference between a SCADA, DCS and PLC? In your answer state where you would likely see each system deploy and why those areas are appropriate. C) Describe the operation of a SCADA D) Write a simple PLC program to control a pump in a water distribution plant
Draw the functional diagram of a Programmable Logic Controller (PLC) and explain the role ofeach module. What measures are taken for fail-safe operation of PLCs?
4.a. What is the name of the nonprogrammable timer that is used to check the internal operation of the PLC?A. HousekeepingB. ScanC. WatchdogD. System4.b. Which one of the following terms is used to define the identifying letters placed above an input contact inladder logic?A. SurnameB. TitleC. StatementD. Locator
Describe DCS and PLC control systems.
Finally assume that the electrical circuit will be working through a PLC unit, state and justify how it will improve the circuit and makes it more reliable.
Identify/describe two functions of the Programmable Interrupt Controller (PIC) Finish the sentence by adding more detail: i) Masks off interrupt lines...
17)This Multiple choice questions from electronics lab course &just write for me final answer ,It easy for you.
draw flowchart and explanation of plc solar panel measurement system for this block diagram ?
Explain what is mean by "Programming device" in PLC, for what purpose it is used.
What does the Arduino instruction pinmode do in the Traffic Light program?