Explain the issue with the cird shown beloW: R1 100 Ohms +. +9V LOAD 12V 1K

Q: Determine , -> 4m A 20k e 5K

A: In this circuit,  Find the current i1  Here we are solved this problem using the  current source to…

Q: Vm220 v - 50 Hz R=10KN NNp=1/5 C=50mf

A:

Q: 8 Q 8 clear load up clk Figure QI

A: It is 8 bit up counter

Q: whe Q1 2. Qi find the Q1 collector current

A:

Q: +20 V Ro-2 kn Ip = 6 mA RG 100 Mn Rs=1 kn

A:

Q: :Deduce the function of the following diagram (2) Jaba 7809 6800 220V, 5OHZ Dridge PCB for regulated…

A: Given, diagram

Q: For the network shown in Figure B22 , assume E = 17V,Diode D1, D2 as Germanium Ri-2ΚΩ and R2-3KΩ.…

A: For the given circuit we will assume that both diodes are ON simultaneously and find the voltage…

Q: 4) Solue for the pauer delivered to the 1on oifr in the clf.chaa). ensq 12 easei (1. even +2V eldi

A:

Q: Using the linearity property assuming lo = 1 mA, find the true value of the current Io.

A: In the circuit,  Find the current in the 2k ohm using the current division method and node analysis.…

Q: Vhich of the following is not a factor which affects solar panel efficiency. O a. Temperature O b.…

A: Given To find which parameter does not effect solar panel efficiency.

Q: The current through a 10-ohm lamp energized by two series-opposing ideal batteries is measured to…

A:

Q: Find the color of the FF. resistance value. C. 25KΩ

A: Given: The resistance value is R=25 kΩ

Q: oper wire of certain length and ance is drawn out to three times gth without change in volume, w…

A:

Q: = 1 mA, Bn = 100, and B, = 40. Calculate Icopy for the circuit below left. Assume Iref Vc 9AE 5AE I…

A: Since reverse saturation current is directly proportional to the emitter junction area(AE)

Q: Plot the forward and reversed zener current and zener voltage based on the measured values from…

A: According to the question, we need to plot the graph based on the following data as shown below

Q: Explain C-rate? Indicate the difference in 0.5 C and 0.375 C in terms of battery discharge…

A: C rate: The current discharge of a battery is expressed in terms of C rate. It is the rate at which…

Q: or the circuit shown in Figure 2(c), determine the range of the load resistance and load current. […

A:

Q: can you create a diagram of this circuit? resistance:220 ohm diode 1N4007 BC548B Transıstor 1.5…

A: Given data: Resistance = 220 Ω Diode : IN4007 Transistor: BC548B Coil Battery : 1.5 V Capacitor =…

Q: Rs e = 10 Vrms MA Rsh=S00 Rm=5002 Each diod has an average forwerd resistance of 50e and is…

A: Full frequency converter- A full frequency converter is defined as a type of converter that converts…

Q: i100 100 k2 25 kN 10 V -10 V Va

A:

Q: 5.4 What is the value of Vdc and Vac developed across the load in the circuit shown in Figure 5.1…

A:

Q: Silicon R₁ = 1000 24Vp Analyze the circuit using any circuit analysis method to compute for the…

A: Given: Supply AC=24Vp(peak) at 60Hz  Diodes=Silicon  Load Resistance=1000Ω

Q: Given the information in circuit below, determine a) Ic. 27 ka b) VE. 10.6 V 20A c) Vcc. V =100 d)…

A: In the BJT circuit.  Beta = 100 Base current = 20uA We know Ic= beta IB Then find the IC  VCC VE VB…

Q: What does PVC stand for? O A. Polyvinyl Chloride O B. Perovinyl Chloride O C. Pure Vinyl Compound O…

A: The PVC stand for Polyvinyl Chloride, which is produced by polymerization of the vinyl chloride…

Q: نقطة واحدة The efficiency for 5-unit string of insulators for the value of K= 0.069, Vt=25V is. If…

A: Given: Five unit string of insulator K=0.069Vt=25 VV1=3.7 VV2=4.09 VV3=4.06 VV4=5.5 VV5=6.9 V

Q: For the circuit shown in Figure 2(c), determine the range of the load resistance and load current. […

A: In this question,  We need to calculate the range of load resistance and load current?  Power…

Q: Please send the answer by typing only. I don't want handwritten.  The subject is ( Electronic…

A: JFET MOSFET 1.junction field effect transistor  1. Metal oxide semiconductor field effect…

Q: Determine the DC currents (Ig, Ic and lĘ) and dc junction voltages (VBE, VCE and VCB) IB=Blank 1 mA,…

A:

Q: When resistors with higher wattage ratings are require resistors are generally used to dissipate the…

A:

Q: IV analyzer-XIV1 Components: Diode D2 Current range (A) Log Lin IN4001GP F: 1.258 kA I: -114.398 A…

A: Analyzer- A device which is used to analyze the data and to show the values on screen.

Q: Given the circuit below with Vs = 15V, Rs = 1k2, RL = 4K2, and Vz = 10V: Rs + VR - |Iz + IL IR Vs Vz…

A:

Q: Resistance of 800 2 has a conductance of O125 millisiemens O 1.25 millisiemens O 12.5 millisiemens…

A: In this question we need to choose a correct option.

Q: CHARGE CONTROLLER 6VDC 6VDC 6VDC 6VDC 350AH 350AH 350AH 350AH BATTERY STORAGE

A:

Q: (a) Refer to the circuit in figure 1 below: R= 5 kN ww V = 10 V Y VD Figure 1 i. Determine and draw…

A: we need to determine and draw load line and calculate the VD for the 3.5 mAmp and power dissipated…

Q: Explain why we have impedance in the transmission lines when we draw a typical equivalent 3phase…

A: Impedance in transmission lines, also known as the surge impedance, is the result of a line with…

Q: Determine current Vo1 in volts, when E=18V, R1=1417 ohms, R2 = 2940 ohms.

A:

Q: Calculate the diode power in (mw) as shown in the circuit below Si 6 kohm www 18 V 4 kohm 2 kohm

A: The cut-in voltage of silicon diode is 0.7 volts.

Q: How can I make a regulated power supply with 1N4750A zener diode and 2N3904 transistor using this…

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used…

Q: 3. Calculate the current through the Zener diode for the given values of load resistance in this…

A:

Q: nichrome ribbon resistor elements each has a resistance of 1 ohm. the element is made from sheet of…

A: Given that  Resistance of nichrome ribbon resistor elements  is 1 ohm Thickness of nichrome…

Q: Q 3. For the fixed bias configuration shown in the figure B below, determine the following…

A: Given data: IB=20 μAVCE=7.2 VIE=4 mA a) The expression for the collector current is given as,…

Q: H. w 252 un ?? 50V 5H PL %3D

A:

Q: The efficiency for 5-unit string of insulators for the value of K= 0.069, Vt=25V is. If the test…

A: The solution can be achieved as follows.

Q: Design a bias stable circuit in the form of figure 2 to operate at Ico =D0.8 mA, VCEQ = 4 V, and VR.…

A: We need to find out the resistance value for given circuit .

Q: low voltage systems An AG 1 heater has 230 V and 10 kW on its label. So which of the following…

A: This is a good question based on electrical appliances chapter and the subject is electrical…

Q: ra FET, graph is drawn by taking voltage VGs in X axis and drain current in Y s, if the value of X…

A:

Q: 102 IT AAN In the current olrant Cdelta to wye connection) for , tal current Clt) and Compute the to…

A: Delta to wye Connection R1=RbRcRa+Rb+RcR2=RcRaRa+Rb+RcR3=RaRbRa+Rb+Rc

Q: Set the DC supply (E) to the values appearing and measure both Vz and VR. Calculate the Zener…

A: PART-A The given circuit is shown below, Applying KVL in the above circuit, 3V-I2*1k-V2=0The zener…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.