Answered: Explain the mentioned ph , DO and EC of…

Engineering

Civil Engineering

Explain the mentioned ph , DO and EC of Ground water ,river and Pond water by comparing it to their normal range.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: What is the maximum positive ordinate for the shear at B. a. 0.5454 c. 0.667 b. 0.4545 d. 0.333…

Q: QUESTION 4: Draw the three Mohr's circles that describe the following state of stress. Determine the…

A: Find: (a) Draw three Mohr circle that determine the state of stress (b) Principal stress (c)…

Q: 1. For the following schedule draw the node network, perform the CPM calculations, mark the critical…

Q: An engineer is laying out a design for a ceramic component whose volume is 30.3 mm. In the processes…

A: Weibull modulus = 9.5Characteristic strength = 628Volume of reference sample =5.3 mm3If the maximum…

Q: (BASE ON 100 M LONG) In m3 1. Void Forms (in m) 2. Grade Beam Forms (in m2) 3. Grade Beam concrete…

A: Void form: depth, h = 150 mm width, b = 250 mm Grade beam: depth, h = 500 mm width, b = 250 mm Grade…

Q: Prob. 1. The two aluminum rods support the vertical force of P-20 KN. Determine the requir diameter…

A: Determine the required diameter for each rod

Q: QA// In detector weight station the following data illustrate the weighting of 4- Axle Tractor…

A: SN =4 Terminal serviceability, pt=2.0 Axle load Number of Axle Single Axle (2.000-4,999) 20…

Q: Determine the force in each member of the loaded truss. The force is positive if in tension,…

Q: a) Write the mathematical expression for one-dimensional flux for advection and diffusion. Do not…

A: a) Write the mathematical expression for one-dimensional flux for advection and diffusion. Do not…

Q: d) What is the latitude and departure of course GH if the distance is 269.80 feet and it has a…

Q: - Prob.5. A new canal is excavated to a aepth of 5 m below ground level, through a soil having the…

A: Given data:- H= 5m Cu= 15kN/m² Φ= 15° e= 0.78 G= 2.72

Q: flat belt is wrapped around a Ø2.00-inch pulley for 220°.Calculate the belt wrap in radians.

A: An angle between the run-up and run-off of a belt on a pulley is referred to as the wrap angle. As…

Q: Aquifer area extent 100 km/sq is overlain by 4 strata as given below: Strata 1 (top): Thickness = 1,…

A: To estimate the recharge into the aquifer, we need to calculate the amount of water that infiltrates…

Q: اصلت عليه QA// In detector weight station the following data illustrate the weighting of 4- Axle…

A: SN =4 Terminal serviceability, pt=2.0 Axle load Number of Axle Single Axle (2.000-4,999) 20…

Q: Q2) The members of the truss structure shown below is plain concrete. The compressive strength of…

Q: The equation of the effective stress failure envelope for normally consolidated clayey soil is. a…

A: Confining pressure = 80 kN/m2 Angle of friction=25o

Q: In an unconfined aquifer, when the steady rate of pumping was 90 m³/hr, the following observations…

A: In an unconfined aquifer having, The steady rate of pumping, Q=90 m3hr=2160 m3day. h1=39 mh2=35…

Q: PLEASE WRITE THE COMPLETE SOLUTION NEATLY: A rectangular beam has b=350 mm and an effective depth…

A: Rectangular beam Width of beam, b = 350 mm Effective depth of beam, d = 525 mm Compressive…

Q: The angle of intersection of T.S and S.T is 70 degrees. The radius of the circular curve is 260 m…

A: Angle of intersection = 70 degrees Radius of circular curve = 260 m Spiral curve length = 110 m

Q: a) Explain fire hydrant system. (b) Give an overview of fire safety, risk and control.

A: The Fire Hydrant Protection System is an active fire safety device that is made to combat fires of…

Q: The moist unit weight and degrees of saturation table: 14.44 18.80 15.46 of a soil are given in the…

A: Given that, S.no. unit weight (Y) (kN/m³) degree Of saturation 1 16.64 0.5 2 17.73 0.75

Q: An open cylindrical tank, 2 m in diameter and 4 m high contains water to a depth of 3m. It is…

A: Cylinderical tank Diameter (D) = 2m High (H) = 4m Depth of water (h) = 3m Angular speed = 100 rpm…

Q: In a horizontally held injection syringe, the piston of 0.2 cm² cross-sectional area is pushed at a…

A: Calculate the force required

Q: Draw the shear and moment diagrams of the following beams by semi-graphical method. Write the shear…

Q: Figure 3 shows partly of a simply supported beam supports uniformly distributed characteristic dead…

Q: 17. Draw the shear and moment diagram 30 KN/m 2m 1m 90KN/m 3m 40KN

Q: An unconfined compression strength. test was conducted on a cohesive soil. The test specimen failed…

A: →Axial Stressσ1=78kPa→Unconfined Compression Strength test i.e σ2=σ3=0 (special case)To determine…

Q: The tank is filled with water and kerosene to the depths shown in (Figure 1). The tank has a width…

Q: Using Area Moment Method : Solve for the maximum deflection of a simple beam 5m long with an 18kN…

A: Determine the maximum deflection of the beam using Area-Moment Method.

Q: Determine the forces in members IC, CD and HE of the truss shown by method of section. 40 KN 30 KN A…

A: A truss is generally a structural member usually fabricated from straight pieces of metal or timber…

Q: Question 3 Find the common collapse load factor λ applied to the loads for the structure with IPE270…

A: Question 3 Section: IPE270 beam Steel S355 grade, fy = 355 MPa

Q: 4 An activated sludge system is to be used for secondary treatment of 10,000 m³/d of municipal…

Q: 15' 10' 6 kip/ft 15' 15' 8 klf

A: Given a statically determinate structure with 3 number of unknowns viz Ay, By and Bx. The reactions…

Q: Determine F=20N at all points. the moment of the force

A: TO FIND MOMENT AT ALL POINTS

Q: Using DIM & AMM: Solve for the maximum deflection of a simple beam 5m long with an 18kN concentrated…

A: EI = Constant

Q: Situation 9: Properly illustrate the shear and moment diagrams for the given beam. Determine the…

Q: A 30cm diameter well penetrates vertically through an aquifer to an impermeable stratum located 18.0…

A: We are given data related to an unconfined aquifer

Q: Problem 5. Determine the reactions at the supports for the structures shown.

A: Determination of Reactions at Supports of given structures by Using Equilibrium Equations because…

Q: A soil profile at a construction site consists of 5 m of compacted sandy clay followed by 5 m of…

Q: An unlined irrigation canal has been aligned parallel to a river, as shown (next page). This…

Q: Situation 4: Draw the shear and moment diagrams of the given beam. Take note that all of the…

A: Draw shear and moment diagram and Maximum shear force and moment.

Q: The cross section through a concrete dam spillway, including a cut-off sheet pile wall, is given…

A: Hi, thank you for the question. As per our Honor code, we are allowed to attempt first three sub…

Q: Design of Vertical Curve Given: PVI station=8+70 and elevation=140m g1=+3%, g2=-2% high point…

Q: t that will cause boiling fo 55, 0.7, and 0.8.

A: Given data- Specific gravity (G) = 2.66 Void ratios (e) = 0.35, 0.45,0.55,0.7,0.8

Q: . The shear diagram is shown in the figure, determine the moment and load diagrams. 90KN 2m -30KN 2m…

Q: Question 4 Calculate the discharge (m³/day) through an infiltration gallery placed at a depth of 4m…

A: Depth H = 4 m Drawdown in the well does not exceed 2.18 m. so, s=2.18 m Length of the gallery L =…

Q: What are the characteristics of deluge Fire system? Explain in deatil.

A: A form of fire prevention system called a deluge fire system makes use of water as the main…

Q: Using CBM: Solve for the maximum deflection and deflection at midspan of a 4m cantilever beam with a…

A: Span =4 m Type of beam =Cantilever UDL = 12 kN/m

Q: The storage existing in a river reach at a given time is 13 acre-ft, and at the same time, the…

A: Given information:- The storage reach in the river is 13 acre-ft. The inflow at that time is 450…

Q: A rectangular scow 10m wide, 5m high, and 12 m long has a draft of 3m. Its center of gravity is at…

A: Width, b=10 m Height, h=5 m Length, L=12 m

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

Don't provide irrelevant or wrong answer. Don't reject.

Question:

Explain the mentioned ph , DO and EC of Ground water ,river and Pond water by comparing it to their normal range.

Sample
Ground water
River
Pond water (2)
PH
7.68
7.19
7.29
DO (mg/l) at 24.5°C
8.99
1.31
4.71
EC (US)
334
1016
418

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Comparing the pH values of water from different source of water.

VIEW

Step 2: Comparing the dissolve oxygen (DO) values of water from different source of water.

VIEW

Step 3: Comparing the EC values of water from different sources of water.

VIEW

Solution

VIEW

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Compute the elevation of reservoir C. CHOICES: a.835.06, b. 538.06, c. 853.60, d. 583.60.
Water is flowing at a rate of 4.5m3/s in a trapezoidal channel whose bottom width is 2.4m and side slopes are 1 vertical to 2 horizontal. Compute for the channel depth if n = 0.012 and So = 0.0001
dynamics question m=20
B=9 Y=82 show complete sol
a = 41.60 kNb = 35.50 kN/mc = 19.00 kN/m
Convert 227 ft/min to meters/sec
a) 0.040 m b) 0.260 m c) 0.020 m d) 0.300 m
A surveying party layout a 100-meter boundary line AB of a certainproperty at 35 degrees Celsius. After the layout, it was observed thatthe 10-meter surveyor’s tape used has an actual length of 10.60meters. To reconfigure the layout, determine the correct length if thetape has a standard temperature of 25 degrees, and the instrumentand environmental errors happened at the same time with the basisof L = 10 meters. Hint: New length = corrected length due totemperature effect + corrected length due to tape defect.
5.30m^2/hour^3 to km^2/sec^3
Help ASAP! w: 435 N/m , a: 3.1 m, b: 1.6 m
Velocity Area Method. At certain section of a river, the left and right water edges are 3.0m and 23.0m respectively from an initial reference point. Verticals are located at distances 7.0m, 12.0m, 16.5m, 19.5m, and 23.0m, from the initial point. Depths of verticals are 1.8, 3.5, 4.6, 3.4, and 5.8m. Mean velocities in the verticals are 0.15, 0.30, 0.45, 0.50, and 0.48m. Sketch the cross section of the river using the data given and solve for the average velocity of the flow of the river.
Water flows in a rectangular concrete channel that is 12m wide at a depth of 2.5m. The channel slope is 0.0028. Find the water velocity in m/s. n=0.013 CHOICES: 9.95 5.95 9.55 5.59