Explain what a switch does with a frame received on an access port assigned to one VLAN before placing the frame on a trunk link for all VLANs.

Q: Which layers of the OSI protocol are used by the HART digital transmission?

A: Despite the fact that it only has three layers: Application, data link, and physical, the HART…

Q: Both Layer-2 Switch and Router are used to forward network traffic from one interface to another.…

A: Both Layer-2 switch and Router how they are different in terms of functionality Switches permits…

Q: A 1500 byte packet is sent from your home to a server. It is first sent over a 6 Mbps cable link.…

A: Details provided are:- Packet size = 1500 byte First send on 8 Mbps cable link    -------------- PD…

Q: What do we mean by bit time while computing Ethernet (CSMA/CD) backoff time?

A: Given: What do we mean by bit time while computing Ethernet (CSMA/CD) backoff time?

Q: ing protocols can detect and correct link fai

A: below the following protocols can detect and correct link failures in milliseconds

Q: Ethernet is a LAN so it is placed in the second layer of the OSI reference model.True or False.

A: the answer is given below:

Q: a) What advantage does a circuit-switched network have over a packet-switched network? What…

A: Answer to the given question: Answer(1): Advantage of circuit switch network over a packet switched…

Q: Both Layer-2 Switch and Router are used to forward network traffic from one interface to another.…

A: (B) Layer-2 switch and Router how they are different in terms of functionality switches allow…

Q: provides grouping of the information for transmissi In a bus topology, all LAN data traffic is…

A: Note As per bartleby guidelines we have to solve only one question please post the remaining…

Q: Assume you're sending a packet via the OSI Network Model. Explain how a router, gateway, and switch…

A:

Q: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

A: Use a diagram to illustrate the four-way handshake protocol for channel reservation in IEEE 802.11…

Q: An Ethernet MAC sublayer receives 1510 bytes of data from the upper layer. Can the data be…

A: The MAC sublayer is the second sublayer of the data link layer (DLL) in the Open Standard…

Q: Explain how the network layer in the OSI model provides a virtual circuit interface to a…

A: Network layer: No matter what kind of network the two systems are connected to or how those two…

Q: Demonstrate how a packet will be handled at an ACL-enabled router.

A:

Q: ______________ Frame Check Sequence (FCS) is what Ethernet implements through an algorithm called…

A: Frame Check Sequence The frames usually contain a number which allows the receiving device to check…

Q: You have successfully followed the cabling procedures for a new network connection at a primary…

A: According to the information given:- We have to find the correct cable connection to satisfy the…

Q: What is the shortest possible size for a valid Ethernet frame?

A: Answer:

Q: How does the NAT router differentiate two simultaneous connections which are initiated from PC1 to…

A: The question has been answered in step2

Q: 99. A three-layer switch is a kind of ________. a. repeater b. bridge c. router d. none of the above

A: I have provided solution in step2

Q: Gigabit Ethernet access methods include _______ mode. a. half-duplex b. full-duplex c. both…

A: Gigabit Ethernet access methods include half- duplex using traditional CSMA/CD (not common), carrier…

Q: what is the other common name for the Network Layer Switch?

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: 1.A network interface card (NIC) is found A. In every network data terminal equipment (host) B. In…

A: A. In every network data terminal equipment(host) Option A is the correct option.

Q: How would you bring the total number of bytes up to 46 if the data file is 30 bytes in an Ethernet…

A: Whenever ethernet packet data is less than required, padding is performed.

Q: What kinds of messages pass via northbound and southbound SDN controllers? Who receives these…

A: Messages flow from the following SDN controllers:

Q: 2. Select the correct RJ45 pin-to-signal assignment for a 4-wire ethernet LAN cable. Choices are on…

A: Solution:   Given, Select the correct RJ45 pin-to-signal assignment for a 4-wire ethernet LAN…

Q: What is the smallest acceptable ethernet frame size?

A: Ethernet is the popular technology which are used for connecting device using wire in a local area…

Q: Explain the components and modes of operation of a WLAN along with power management features of IEEE…

A: Wireless LAN 's components is similar to Ethernet wired LAN. The main difference in between the…

Q: Describe five factors that ACLs employ to allow or prevent traffic on a router.

A: Answer 1. Standard and extended access lists can't share the same names. 2. We are unable to remove…

Q: When it comes to Ethernet LANs, what is the maximum transmission rate?

A: A LAN is a network of computers and other electronic devices that covers a small area such as a…

Q: Explain in detail about vty in cisco router.

A: VTY : Vty is a virtual port and its stands for Virtual Teletype. It is for providing inbound…

Q: What is the maximum size of payload field in Ethernet frame

A: payload field is the data part which is transferred between source and destination

Q: The kind of cable used to link the switch and the router must be determined. What piece of hardware…

A: The kind of cable used to link the switch and the router must be determined Straight-through Cables.…

Q: What would happen to a circuit-switched connection, if one of the transit nodes that is part of the…

A: Circuit switched connection is connection oriented technique which establishes connection between…

Q: Which VLAN on a switch is responsible for managing untagged frames?

A: INTRODUCTION: It is possible to create a virtual local area network (VLAN) to link devices that are…

Q: Question 2 The majority of the functions of the link-layer controller's functionality is mplemented…

A: The function of the link-layer controller's  controller located is

Q: A CSMA/CD LAN has minimum frame size 100 bytes and is running at 100 Mbps. The signal speed in the…

A:

Q: Is there a limit to how many VLANS traffic one access port may carry?

A: An access port can be denoted as type of connection on a switch that is used to connect a guest…

Q: Discuss why each input port in a high-speed router stores a shadow copy of the forwarding table.

A: Routing in Networks: Routing is the process of forwarding packets from source machine to destination…

Q: In an outbound PDU packet, what does source port: 80 and destination port: 1027 means?

A: The Outbound PDU Details tab shows similar information for outgoing packets. This tab only applies…

Q: Calculate the delay x bandwidth product for the following links. Use one-way delay, measured from…

A: calculate delay * bandwidth product for the following links:

Q: QUESTION 3 In an SDN-controlled network, the routing function is? Centralized within the SDN…

A: SDN stands for Software Defined Networking. It is a network architecture which virtualizes the…

Q: Router works in which layer of OSI mo

A: The option d Is correct.

Q: Which VLAN technology assigns addresses to physical ports ?

A: VLAN stands for Virtual Local Area Network, it is similar to LAN but with advanced feature, in this…

Fundamentals of WAN

A collection of networks and/or local area networks (LAN) which communicate with each other is called a wide area network (WAN). A telecommunication network is extended over the geographical area for the basic computer network purpose (by connecting all smaller networks). From any part of the world, WAN allows communication and sharing the data between devices.