F= 20 N , p-15N; H= 6N; K= 3N FIND IN COMPONENTS OF EACH FORCE Fx t Fy s THEN ZFx? ZFy? FIND THE KECULTANT FORCE ND DIRECTION. K s0o 60° IL

Q: 4 kN Draw F.B.D then find reactions at supports A and B take beam AB wieght 20K g Ax B Rgsin30 30°…

A: Given that: FBD of a beam as shown:

Q: 5.01f the built-up beam is subjected to an internal moment of M 75 kNm, determine the amount of this…

A:

Q: and moment. 60 kN 12 kN/m 200 kN - m B C A Esm– -10 m-

A:

Q: Determine the bar force member CD. All interior angles are 60 degrees. 1.5 kN 3 KN ... 2 kN F 1.5 m…

A:

Q: Draw (FBD) and calculate the support reactions in the simply support beam ABCD below 3kN Ko 5kN 60⁰…

A: Given: Simply supported beam with dimensions. Loading  To find : Support reactions  Free body…

Q: 5m 8 kn/m 3m 50 kn 5m Com 75kn 2.5m

A: Given:- To find:- Axial, shear force and moment diagram

Q: 96 If the resultant of the loads shown passes through point B, determine the equivalent force-couple…

A: In the object, every set of force and moment has the equivalent force couple.  This is the single…

Q: 4m C. L000 N 3m DE 3m F

A:

Q: 2.15 Determine the moment M, at the base of the but- tress due to the applied thrust force F. Use…

A:

Q: Determine the shear (in kN) in member AB using Portal Method. Input the magnitude only. P=50kN A C…

A: Given data in question  Dimensions  Horizontal point load To find out  Shear force in beam AB

Q: Draw the shear and moment curves label the maximum values of shear and moment. Blank 1 MN kips B↓…

A:

Q: e/ Drew Shear and bending moment dygram? be KN 20KN 3 m 2m

A: Calculation of reactions -RA+RB=12×3×60+20×4+20RA+RB=190      eq 1

Q: 10 k F 5k 16 ft D 10 k E 16 ft A C B 12 ft 12 ft Determine the Horizontal Reaction at C. 15 kinc…

A:

Q: For the given concurrent forces, determine the value of Force F3 and Angle 0 if the resultant is…

A: Given data in question  Point forces Angle Resultant force  To find out  F3 Angle of inclination

Q: The resultant of the four belt tensions and a couple C = 450 N-m CCW and a force R = 700 Nacting…

A: Resultant force is given, which can be find out by summing up the horizontal forces to be equal to…

Q: The speed of water eter section of the p

A:

Q: Why is the force Fd pointing downwards? By force equilibrium, shouldnt  it be 3 + Fd = 9 Fd =…

A: yes, you are  right by equalibrium condition 3+Fd=9 we calculate reactions using the equailibrium…

Q: Determine the bar force member CD. All interior angles are 60 degrees. 1.5 kN 3 kN 2 kN F 1.5 m 60°…

A:

Q: The steel beam is subjected to a concentrated load of P= 31 kips. The beam is supported at Cby rod…

A: The elongation in the rod is equal to the net elongation at point C due to the applied load on the…

Q: Q9: For the quarter circular gate AB in Figure below find the horizontal force Fx, vertical force…

A: Given data  Quarter circle  Depth of emersion Radius To find out Horizontal force Vertical force

Q: 20 950 N Resultant: 350 N F

A:

Q: Determine the projection of the force F = 40 N perpendicular to line BC. G uD = - 4/5 j + 3/5 k, u-c…

A: F=40N

Q: A 1-m wide curved gate supports water as shown. The gate is from a sector with radius 6 m and…

A: Width of gate (w) = 1 m area of sector = 60 ° radius of sector (R) = 6 m compute: a. vertical force…

Q: H.W Replace the loading equivalent resultant force and specify its location on the beam, measured…

A: Consider the given beam. The resultant force will be equal to the algebraic sum of all the forces.

Q: force P is applied at h = 1.5 meters to the Pokémon Stonjourner as below. If w = 2.5 meters…

A:

Q: A F 0.3 m mathino,com D 0.3 m B Figure P-226 Given that F-1000Kn and P-1434. Determine the…

A:

Q: Find the force in member BC. 20 kN 10 KN 4.0000 20 KN *. D0OD

A:

Q: 50 k 2 k/ft 10 ft 3 k/ft 24 ft 12 ft -12 ft- 8. The vertical support reaction at hinge is b. 61.28k…

A:

Q: Calculate V(x) and M(x) between x = 2ft and x = 7ft (measured from the left end) of the beam below…

A:

Q: Construct influence lines for the axial forces in member CD and DE respectively of the truss shown.…

A:

Q: Q2/ Determine the resultant moment of the force about point C F =400N 100 N D 30 A 45° 0.3m B C.…

A: Let solve this problem by taking section to right of point C and resolve forces in free body diagram…

Q: Mc= 2400 Nm E C = ujung bebas B = rol 2 m 2 m 2 m 2 m tan a = 0.75 = sendi

A: gbdfdfgffggggfdfd hbnnnnnnnnnnnhthhssytyfty hthysyst hhhfghfghghbgggry44ghhfdhh h ffhfhgh  ggfdgfg…

Q: 50 k 2 k/ft 10 ft 3 k/ft 24 ft 12 ft -12 ft- 8. The vertical support reaction at hinge is b. 61.28k…

A:

Q: Determine the magnitude and coordinate directionangles of the resultant force, and sketch this…

A: Given : - Three forces F1 , F2 , F3 is given  Magnitude of F1 = 90 N  Magnitude of F2 = 150 N…

Q: 5.The following force system is. . A. Concurrent coplanar force system 120N 100N B. Non concurrent…

A: Option D is correct  Non concurrent coplanar force system

Q: Determine the bar force member CD. All interior angles are 60 degrees. 1.5 kN 3 kN 2 kN E TD F 1.5 m…

A:

Q: Find the Resultant Force when (Ry = 190 N) .A 13.78N .B 36100N .C 190N 19N

A: To find out the resultant force when Ry is 190 N

Q: Determine the magnitude of the horizontal force P (Ib) so that xg = 6 %3D ft.

A:

Q: Determine the horizontal ( F) and vertical ( Fy) of the force of the water on the gate. Also…

A: Given Data: Gate radius is R=2 m. Depth b=2 m. Height of water H=5 m.

Q: Compute the value of El at the right end support. Wo = 14 kN/m, P =5 kN, L1 = 1.1m, L2 = 2.1m, L3 =…

A:

Q: The 16-ft-long cord is attached to the pin at C and passes over the tw The pulley at A is attached…

A:

Q: Using the method of sections, solve the axial force in members AB, AC, AND CE as shown below. 80 kN…

A:

Q: 6OKG Considering all Surfaces friction is 0.3, Determine the Maximum Value of force P without…

A: This question is related to Mechanics from Civil Engineering. In this question we calculate the…

Q: 1.5 kN 3 kN 2 kN ET F 1.5 m B - 1.5 m 1.5 m

A:

Q: Replace the 4.4-kN force by an equivalent force-couple system at (a) point O and (b) point B. Give…

A:

Q: Draw shear and moment diagram P=12kN W=5kN/m B 4m 1.5m A

A: We will find reactions first and then write shear and bending equation.

Q: Problem 5: (a) Replace the loading acting on the beam by an equivalent resultant force FR and couple…

A: From varignon's theorem can replace the the loading of beam into single force

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.