Find (a) io, (b) i1, and (c) iz in the circuit in Fig. P2.35. Figure P2.35 8 ΚΩ + 12 Δ Σ9 kΩ Σ3 ΚΩ {9 200 V ΟΔΟ 200 d 12 ΚΩ Συγ ΚΟΥ ΤΟ io αρχές της ΤΟΥ προς το πα +

Q: A // water treatment plant is used to process 30000 m²/d. The rapid mixing tank is to have a…

A: Given data, The Volume of the tank is 30000 m3/d  Detention time is 1 min The value of the G is…

Q: (2) An 12 bit successive approximation analog to digital converter has full scale reading of 5 V and…

A:

Q: Q4. In a CE germanium transistor amplifier circuit shown in (fig. 5). Determine the 0.985. operating…

A: We need to find out the Q point coordinate for given circuit and we need to draw load line .

Q: Q5. Calculate the maximum and minimum collector curr (fig. 6) and find Icsat. and VCEsat. RB = 250…

A: Given circuit is shown below. I=IC+IB Apply KVL at input side 15=IRC+IBRB+0.714.3=IC+IBRC+IBRB

Q: 4 Given the following T-Flip flops a) Plot the signals of Qo and Q1 with respect to the clk signal.…

A: Given: T-flip flops.

Q: For the Circuit shown in fig iT = I1 Sin (100+ +10²) + [3 (Sin 300++20) + I α sin (yoot +36)A if L +…

A: Inductive reactance directly proportional to frequency  Capacitive reactance inversely proportional…

Q: 20K0 www For the circuit below find V ref of . (741) comparator +16 V Vo 741 470 92

A:

Q: Let voltage across a load be v(t) = 20 + 40 cos(100t) volt and current through the load by i(t) =…

A: For the above given question we need to calculate the value of average power dissipated in the load…

Q: A single phase transformer is given: SN 100 KVA, V₁ = 10 kV, t = 25. = 1N The short circuit…

A: Given information about a single phase transformer is written below. SN=100 kVA. V1N=10 kV. t=25.…

Q: Q/ using Thevenin's theorem, find the current passing in the resistance 3 ohm ? 652 20V 452 2 A IA…

A: Steps to find Thevenin circuit  To find the thevenin resistance, find the resistance across target…

Q: Explain why NRZ coding is not attractive for signal transmission applications?! Short answer please

A: NRZ coding : NRZ coding is known as non return to zero encoding this coding is used where speed of…

Q: Question 1 For the circuit given, what is the current? ww 1000 208V 400Hz 79.6mH O 1.99A O 693mA O…

A:

Q: Digital Signals and Systems Given the following linear systems, find which one is time invariant. a.…

A: Steps to check time invariant and variant of system  Pass the input to the system first and then…

Q: The shaft torque of a diesel motor driving a 100V dc shunt-wound generator is 25Nm. The armature…

A: It is given that: T1=25NmV=100VIa=18Aϕ2=0.85ϕ1T2=35Nm

Q: power

A:

Q: The primary benefit of PAL is having a programmable AND array and fixed OR array, that it was…

A: For the above given statement we need to justify whether it is true or false. By using the concept…

Q: An antenna has 40 2 antenna resistance and 60 Q radiation resistance. The efficiency of the antenna…

A: Given: Radiation resistance, Rr=60 Ω Antenna resistance, Ra=40 Ω

Q: * Include memory elements and combinational circuit Sequential network Integrated circuit O…

A: Includes memory element and combination circuit

Q: The parallel-plate capacitor of Figure shown below is quarter-filled with mica (Er = 6). Find the…

A:

Q: 2 (4) ( Q: For the circuit shown in fig.(2), the current and voltage sources are given in a form of…

A: Problem is done using superposition theorem.considering one frequency at a time.  At first impedance…

Q: Consider the circuit below in which the dependent current source depends on the current it, the…

A:

Q: The following AC power source connected to two impedances and one resistive load. Analyze the…

A: The Given circuit is To analyze the circuit reactive components and reactive power developed…

Q: Q2:.For the four pole filter, determine the capacitive values required to produce a critical…

A: Filters are circuits that allow signals of varying frequencies to pass through.  The cutoff…

Q: Q6/ (Practical part) 1- Write the steps to solve the thevenin circuit with suitable diagrams and…

A:

Q: R1 ww m degree V R2 sine Let R1 = 4 ohm, R2 = 2 ohm, reactance of the capacitor -j3 ohm and…

A:

Q: Construct the magnitude and phase plot for the following transfer functions 100(s +20) H(s) = s(s+…

A: By observing se can se that the system is single input single output. The order of the system can be…

Q: sisting of a coil of inductance 0.1 H and resistance 8ohms and a capacitor of 120uF nected to a…

A:

Q: Calcuate the o/p voltage for the Circuit shown in fig 1, if Rf = lok2, R₁ = R₂ = 312-22² ✓ R3= R₁4 =…

A:

Q: Q. A straight binary sequence is applied to a 4-bit DAC, and the output in figure below is observed.…

A: In the above figure the binary sequence step is applied to the 4-bit DAC. DAC is used to convert…

Q: +41mV +15 mV Calculate Vo for the circuit shown below 600 k www 15kQ2 www 30 k www 30 ks2 www 15KQ2…

A:

Q: Question 4 The function Fimplemented by the multiplexer chip shown in the figures 0 1 0 1 10 1₁ 1₁…

A:

Q: A 3-phase, Y-connected syn. generator supplies current of 10 A having phase angle of 20° lagging at…

A:

Q: Chapter #1 Programmable Logic Devices HW# 07 Q. Use the below PAL device to realize the logic…

A: The truth table is shown below, INPUT OUTPUT x y z f1 f2 0 0 0 0 1 0 0 1 1 1 0 1 0 1 0…

Q: What are the W/L ratios for the transistors based on Fig. below ?of a three-input NAND gate +2.5 V Q…

A: Given: Consider the following figure: To find: What are the W/L ratios for the transistors based on…

Q: The magnetic field intensity is given in square region 0.5<x< 1 y = 0,1C2CIS by H = 2 ax + x²³ ay +…

A:

Q: Q4) Find the voltage across the capacitors in the circuit of Figure shown below under de conditions.…

A:

Q: C t V sine R2 Let R1 = 4 ohm, R2 = 2 ohm, reactance of the capacitor -j3 ohm and reactance of the…

A: In this question , we will find voltage across Inductor and current through capacitor....

Q: Q3/ Find E at the point P placed at (0,3,4) in Cartesian coordinates due to a point charge Q = 0.5…

A:

Q: Determine the unknown voltages using Kirchhoff's voltage law V₂ www R₂ = 5.6 k 10 V 6 V 24 V- V₁ R₁…

A:

Q: 14. The operational amplifier circuit shown in the following figure includes a thermistor. V+ 100 (2…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: Q2/Explan the method to compensation of bias current, offset voltage,Offset current and maximum…

A: Q2. Offset voltage will usually introduce minor faults in any op-amp circuit. Unlike the advantages…

Q: amount. Example 10.4 A direct-FM transmitter has a varactor modulator with k+ = 2 kHz/V and a…

A: "Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: serial adder is an example of Sequential network combinational circuit grated circuit coded outputs…

A: In this question we will write about decoder and sequential circuit.....

Q: EX2: infinite line along the z-axis with 20 nc/m. Calculate the capacitance between p=10 and p=4 for…

A:

Q: What will be the equivalent resistance between the terminal a & b for the below given electrical…

A: Given circuit,

Q: c) For the circiut shown in fig.(2), the swit find ix(t) for t>0, let R₁ R₂=1k2, R3-2k2, a. Fig.(2)

A: In this question we will find current through resistor R1 ....

Q: True or false: sources of electrical energy contribute zero emissions and have no waste products…

A:

Q: A 2 pole, 3 phase, 50 Hz induction motor is running on no load with the slip 4%. Calculate (i) the…

A: Induction motor is also called a asynchronous motor this motor like a transformer because the stator…

Q: How is a current of 10A shared by three circuits in parallel, the impedance of which are 2-j5),…

A:

Q: (A+B+C+D)(A+B+C+D)(A+B+C+D)(A+B+C+D)(A+B+C+D)(A+B+C+D)(A+B+C+D)(A+B+C+D) (A+B+C+D)(A+B+C+D)

A: The OR gate Simulates the Adding operation of the inputs and results the SUM The AND gate Simulates…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.