Find the current 1, and the voltage V₂ for the network of figure beside: E 12V IF Ry R₁40 A 30 R₁6 Ron

Q: A 2 mH, a 3.3 mH, and a 0.2 mH inductor are connected in series. The total inductance is A. 55 mH B.…

A: Given data: L1=2 mHL2=3.3 mHL3=0.2 mH

Q: If 400 J of work is done in carrying a charge of 5 C from a place where the potential is -12 V to…

A:

Q: If main power on submarines operates at 600 Hz and a submarine is 380 feet long, can circuit theory…

A: The component of the power system known as the distribution system is responsible for distributing…

Q: 39А 130 ли 31 The circuit above is in DC steady state. What is the value of i, in amps? 9Н

A: Given data, Circuit diagram is given as,

Q: A thyristor in a 3-phase fully-controlled converter that supplies 660 A to a D.C. load is mounted on…

A: Given data: Mass of Al =0.6 kg Junction to a case to heat sink thermal resistor QJC+QCS=0.12° C/W…

Q: A class B push-pull amplifier has an efficiency of 60% and each transistor has a rating of 2.5W.…

A: We have a class-B Push-pull amplifier which has, Efficiency (η) = 60 % = 0.6 each transistor rating…

Q: Find the values of R and the power supplied by the source. F 202 B Vs 792 www. RQ IA A 8 392 TIA…

A:

Q: Using only 2-input totem-pole gates and as few inverters as possible, complete the logic to allow…

A: Given data: Inputs, Two LEFT systems, R1 & R2' One temperature sensor, H Output, Two RIGHT…

Q: d) What is the power of the signal below? x(t) = 5 cos(10t + π/2) + 3 cos(20t + π/3) TIP: use the…

A: Given, xt=5cos10t+π2+3cos20t+π3 To find:  (d) The power of the signal. (e) Power of a sum of…

Q: peak current through the resistor is A. 15 MA B. 1.5 mA 10 mA

A: Given data:- Vrms = 16 V   R   = 15 kohmIPeak =?

Q: Q1) For the two-port network shown in Figure (1) below, obtain the Y-Parameters and state whether…

A: Given:

Q: Following are the results of a test carried out on a 230/600 V single phase, 7.5 kVA transformer.…

A: Solution: Given data; single phase transformer, KVA = 7.5 , V1=230 V , V2=600 V In short circuit…

Q: T lines are designed for Digital data how they can be used for Analog Transmission?

A: Digital Transmission of analog information is possible if a minimum level of signal to noise is…

Q: IN THE PULL UP PHASE OF NARROW GRIP PULL UP EXERCISE :  Look for excessive joint torques produced…

A: Step:1 Muscles, bones, and joints of arms exert some forces during exercises. Muscles exert far…

Q: The speed control of an AC motor can be achieved by using 2 common types of drive circuit, namely…

A:

Q: Find current l₁ in the figure. R₁ 100 Ω www +0 100 mA 4 A. 60 B. 68 MA C. 50 mA D. 32 MA 4₁ www R₂…

A: Given:- Where, IT=100 mAR1=100 ΩR2=47 Ω We have to find current I1.

Q: A single phase transformer has turns ratio of 4. The resistance and reactance of the primary winding…

A:

Q: Find Ck for the sequence x(n) shown below px (n) 327 -2

A: Given: A discrete time sequence, To find: Complex Fourier series coefficient Ck

Q: Q5/Find the solution of the following operation for binary numbers 11010.101-100101.010…

A: In a digital computer, signed numbers are represented using two's complement. Simply invert the…

Q: A series R-L-C circuit having resistance 50 2, inductive reactance 0.2 H and capacitance 10uF is…

A:

Q: (d) Calculate the speed of a 60-cycle, 14-pole motor if the slip s is 0.05.

A: Given: Frequency, f=60 Hz. Poles, P=14. Slip, s=0.05.

Q: Given the difference equation: y(n) = 0.2y(n-1) + 0.2y(n − 2) + 0.1u(n-1) 1-Find the discrete…

A: Given the difference equation, yn=0.2yn-1+0.2yn-2+0.1un-1 To find:  1) Find the discrete transfer…

Q: (i) Find the value of resistance R in the figure below if the voltmeter reads 12 V and ammeter reads…

A: Given- Case-(i), Voltmeter reading=12 V, Ammeter reading=0.100 A. To Find- The value of resistance…

Q: 5. Does the common source amplifier produce a phase shift at the load? How does this compare with…

A: Yes, the common source amplifier produce a phase shift of 180 degree at the load. The common source…

Q: A class B push-pull amplifier with transformer coupled load uses two transistors rated 10 W each.…

A: We have a class-B push pull amplifier with transformer coupled load uses two transistors .   We need…

Q: (a) What type is the active filter shown in the following figure? (b) Determine the roll-off rate.…

A: Given, Damping factor DF=1.414 Cut-off frequency fc=15KHz Resistors R2=10KΩ, RA=10KΩ Here, we have…

Q: Find I₁, I2, Va, and V, in the following circuit. Use diode constant voltage drop (CVD) model with…

A: Given data: The circuit parameters are, VD∘=0.5 VV1=20V2=-10IS=2R1=100 Ω The given circuit is shown…

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A:

Q: R₁ = 60 om W 1 R₂=80 R=40 M R₂=B53 ww M R₂=40 R₁=100 Rg=652 W R8=662 M ww R7=80 R₁0=20

A:

Q: Two resistors have a total resistance of 50Ω when connected in parallel and a total resistance of…

A:

Q: 4. Determine the total circuit resistance, total current through R1, in the circuit below: E = 12V…

A: The given circuit is, Where E=12 V, R1=1000 Ω and R2=200 Ω.

Q: Example 15.39. A 3-phase motor load has a p.f. of 0.397 lagging. Two wattmeters connected to measure…

A: Given a 3-phase motor load has, Power factor, cosϕ=0.397 lagging. Two wattmeters connected shown…

Q: Consider that the phase shift of an RC coupled CE amplifier is 260°. Find the low frequency gain…

A: As per the question, it is given that Phase shift = 260° Voltage gain = -150 We have to find out the…

Q: design using JK-flip flops a logic circuit that detects the nonoverlapped sequence [10011]

A:

Q: Calculate the value of the current I needed to setup a flux of 0.1 mwb in the airgap. The magnetic…

A: The magnetic circuit diagram is shown below, Here,Flux, ϕ=0.1 mwbIron factor, IF=0.92.μr=1000.Cross…

Q: 1-14. (a) Write the Voi expression by inspection and solve for Vol using a voltage divider. Write…

A: Given circuit,

Q: How does the shape of wires carrying current affect the shape of the magnetic field created?

A: Magnetic field: The expression field of force connected to shifting electric fields, such as when…

Q: A 3-ph, 50 Hz, 150 km line has resistance, inductive reactance and capacitive admittance of 0.1, 0.5…

A:

Q: 1. Given a system with input x(t) and impulse response h(t) given by: x(t) = u(t), h(t) = u(t). Let…

A: Given, Input x(t)=u(t), Impulse response h(t)=u(t) Here, we have to find: PART (a): output of a…

Q: Example 2.7: Fig. 2.6 shows a motor and load combination. The motor is a permanent magnet DC motor.…

A: The given figure is shown below. This is a DC armature controlled permanent magnet motor. We need…

Q: Which object converts electricity to light?   A) Solar panels B) Battery C) Bulb D) All the…

A:

Q: A ramp input applied to an unity feedback system results in 5% steady state error. The type number…

A:

Q: Q3) a) What is the power of the signal below? x(t) = 5 cos(10t + π/2) TIP: use the trigonometric…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: When compliance. you are required to complete an assessment of safety and environmenta Hiring…

A: Safety: The condition of being protected from unfamiliar and unlikely danger, risk and injury.…

Q: Question: The capacitance C₁ of a diaphragm pressure sensor increases as the measured pressure…

A: Given: An AC bridge with diaphragm capacitance.  Vin = 24 Vrms, R2 = 145Ω, R3 = 15 Ω, C1 = 3 mF…

Q: For the capacitor circuit in Figure 1 a. Determine the time constant of the circuit. b. Write the…

A:

Q: A strain gauge with gauge factor 7 has a resistance of 240 when unstrained. If the strain gauge…

A:

Q: A star-connected, 3-phase, 15 MVA, 3.3 kV alternator is protected by Merz Price circulating-current…

A: Given,For a 3-ϕ star connected alternator,S=15 MVAVL=3.3 kVR=8 ΩImin = 0.5 ACT ratio=10005

Q: A single-phase, half-bridge inverter feeds a resistive load, R = 10 Ohms. If the source voltage is…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1;, = 2.75 mA A- Figure 6-9 ΙΚΩ | 5.2 ΚΩ Ο 4.7 ΚΩ Ο 6.4 ΚΩ Ο 520 Ω 1.5 Κ Ω Μ 3.9 Κ Ω Tout Β Given…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.