Find the currents in the circuit byusing kirchhoff's law12 vbI,a10Ld.20 2Iz6 vإجابتك

In this question , we will find currents I 1, I2 ,I3 using KCL.

Answered: Find the currents in the circuit by…

Engineering

Electrical Engineering

Find the currents in the circuit by using kirchhoff's law 12 v 552 a I, 102 d. 20 2 Iz 6 v إجابتك

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.8MCQ: The units of admittance, conductance, and susceptance are siemens. (a) True (b) False

See similar textbooks

Related questions

Q: A wind turbine has the following data: Downstream wind velocity = 12 m/s Upstream wind velocity =34…

A: wind efficiencyη =PoutPIn×100Rotor power output is 0.5MWbut output power is also given…

Q: A- Using Kirchhoff's current law, determine the unknown currents for the below network. 5 mA 3 35 mA…

Q: Determine the resistance equavlent by delta to wye method. ? handwriting 3 kn 5 kn 4 kn 3 mA 10 kng…

Q: 1) Which of the following is not the transmission voltage in Jordan? 66 kV (B32kV O 220 kA TD) 400…

A: In Jordan,the transmission voltage generally used are 132 KV, 400 KV and 220 KV. 66 KV is not used…

Q: 2. Determine the total resistance using delta to wye transformation. * 22 RT 82 20s

A: In this question, We need to determine the total resistance using the Delta to star transformation.…

Q: ↑ ↑ 2 ohm 3 ohm 3 ohm I1 12 13 6 V 6 V 3 V

Q: Seatwork 2 Solve for the branch currents and show actual current directions. 1. vel 후 15V loov 32…

A: In this question, Solve for the branch currents and show actual current directions. Use Mesh…

Q: ) Solve the currents as indicated. 330 2 560 2 11 = 560 2 12 = 13 = 1.5 v 1.5 v

Q: For the figure shown below: a) Use repeated source transformations to find the value of v̟ b)…

A: Given circuit,

Q: Q.1. Determine the current i. 12.5 2 10 2 52 ww- 120 V 30 2 15 2 20 2 ww ww ww

A: Given,

Q: Problem 2: Find branch currents 10 2 15 10V ww

A: We use mesh current analysis to solve this problem. The solution is as follows.

Q: f(t) X2 (t) y Hiokgh que WISONS WIN T 2 Ns/ml

A: Given mechanical system shown

Q: I |(1) (2) (3) 10 2 52 V = 100 -<45° ( ww

A: By the complex power analysis

Q: Set up a system of linear equations (but do not solve) for the following electrical network. 12 12 5…

A: The explanation is as follows for the given circuit using KVL and KCL.

Q: 12 416) 24, 22 1 A 42 12 42 10 V www ww ww

Q: Find I @ 62 ov 土)N (using maxwell mesh)

A: Let the voltage at the mid node is V. Apply KCL at node V,…

Q: Don't handwritten please

A: Let us consider The current flowing in mesh (01) is I1 and current flowing in mesh (02) is I2 So,…

Q: Q.1) By using Nodal theorem find (i,) and the power in 4 OHM resistor. 42 ww 80 ww 21 3A ww

Q: Suppose 85 kW is to be transmitted over two 0.120 Ω lines. 1) Estimate how much power is saved if…

A: Given: Pout=85 kWVout=220VRlines=2×0.120ΩEfficiency=99%

Q: Using Thévenin's or Norton's theorem, calculate the value of the current source IX such that the…

Q: The voltages at the two ends of a line are 130 kV and its resistance is 30 ohms. The real power of…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: ww 多122 12 60 V Lo° 952 122 3 32 8 32

Q: If the voltage V, = 800 mv, then the current flowing in the load Is is: %3D 1:8 -j20n ell

Q: Example 1.12: Find the currents and voltages in the circuit shown below using Kirchhoff's law 8Ω 30…

A: Kirchoff's voltage law is an important method to solve big and complex circuits. According to KCL,…

Q: For the power system shown below, find the short circuit level and short circuit current at F. Take…

A: In this question we need to find a short circuit level and short circuit current.

Q: For the circuit shown, Use Norton's Theorem 1) Calculate the current in the load connected across…

A: Given 1)

Q: By Thevenin's Theorem, calculate the arrent through the Galvanometer,having a sistance of 20 ohms,…

Q: Q/Find the Power supplied by all Sources. "by using Loop analysis 2) 1222 m. зл 25 100 V 3;x +1 M ix…

Q: Question 1: (3 Marks) If the complex power delivered by the voltage source is S=18 + j9 VA. Find…

Q: Water from a reservoir flows at 2 m3/s down a smooth and vertical penstock pipe of length a turbine…

A: According to the question we have to find the value of the maximum power generated.

Q: Calculate all the voltages, currents, and total power in this balanced Y – A system: Load Source +…

Q: A 440 V, 3 phase A.C. Motor has a power input 13.5 kW, 0.6 lagging and with efficiency of 80 percent…

A: Power input to 3 phase motor =(root 3)×Line voltage ×Line current ×power factor. Given, power input…

Q: In Fig. 2, at what value of Road, it can draw maximum power? Calculate the power drawn by Rioad- 32…

Q: 1 2002 5602 V. Ve 460 (0) Find R. I Pug () () using veltage didider rule, Find Vc

A: In the circuit, capacitance resistance and inductance are consist. Find the total impedance and…

Q: Q1:- Use Superposition theorem to find I12, V34 in the cct below, ( draw the cct in each step and…

Q: URGENT PLSS 15 MINUTES Thevenin Theorem Determine the equivalent th and the power dissipated by a…

Q: In a delta connected load, the line voltage across the load is measured as 370 20° Volts and line…

Q: Using any method, find for the currents 11, 12 and 13. 10 V (+) 62 ww 1 A 13 2Ω 4 A 4Ω 12 2 I2 (+) 8…

A: Given circuit shown

Q: Find the power absorbed by the dependent voltage source in the circuit belov 4 kN 10 kN (+- 60 V 20…

A: Kirchoff's voltage law is an important method to solve big and complex circuits. According to KVL,…

Q: 4-ohm resistor is W.

Q: 7. The voltage across the short is? 12 ohm 135 V a) 135V b) Infinity C) Zero d) 11.25V

A: we need to determine voltage across short.

Q: 8 12 120V 24 18 R(Load) = 30 %3D

Q: =0,54 A. a. Write the nodal equation and solve for V. b. Calculate the voltage across the current…

Q: Find the load resistance for 10 ww maximum power transfer. 4/0V ZL

A: For dc source the maximum power transfer states that maximum power is abstract by load resistance if…

Q: Determine the currents I, h, and Ipm for the network 3.3k Si 14 E= 20 V 5.6 kQ

Q: Use Kirchhoff's laws to determine the value of the current i 60 2s Pa ЗА

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A- Using Kirchhoff's current law, determine the unknown currents for the below network. 5 mA 3.5 mA…

A: Given, We have a network. We have to find the unknown Currents. Please find the below attachments…

Q: Using MESH ANALYSIS or Maxwell Method, find the power consumed by each of resistances and determine…

A: Draw the mesh current in the given circuit as shown below. It is asked to determine power consumed…

Question

Find the currents in the circuit by
using kirchhoff's law
12 v
b
I,
a
10L
d.
20 2
Iz
6 v
إجابتك

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The units of admittance, conductance, and susceptance are siemens. (a) True (b) False
Complete the table using Kirchhoff's Laws Compose the voltage equations based on the variables given.Retain the signs generated by the tracing directions. Multiply with the least common factor to remove any fractions. KVL @ loop A: k11Vx + Z12Ix + Z13Iy = Source1 KVL @ loop B: k21Vx + Z22Ix + Z23Iy = Source2 KVL @ loop C: k31Vx + Z32Ix + Z33Iy = Source3
Calculate the Thevenin impedance at each bus given the impedances below: Z_line1to2 = 1.5507m + j0.0212 Ω Z_line2to3 = 5.2917m + j0.0722 Ω Z_G1 = 0.75Ω Z_G2 = 0.0184Ω Z_G3 = 0.0348Ω Z_T1 = 0.25Ω Z_T2 = 0.125Ω Z_T3 = 0.25Ω
A Y-connected load has 20 Ω in each branch. The load is supplied with a line voltage of 220 V. With the base values Ub = 220 V and Sb = 10 kVA, calculate per unit values of current and apparent power that the load draws.
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
Suppose an AC generator with V(t) = (150V)sin(100t) is connected to a series LCR circuit with R = 40 Ohm, L= 80 mH, and C = 500 microFarad, as shown in the figure. Calculate the maximum voltage across the resistor (VR0)? A. 11.52 V B. 6.12 V C. 6.31 V D. 4.12 V
Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal Methodb) Maxwell’sMethod
FINAL ANSWER IN 2 DECIMAL PLACES. ASAP. For magnetically coupled circuit below, find the 1. Thevenin impedance (express in rectangular form)2. Thevenin voltage ( express in polar form)
Use Kirchhoff's rules to calculate currents I, I1, I2, I3, I4, and I5, and compare them with the experimental results in tabular form.
Use Kirchhoff’s Law to determine currents i1, i2, i3, iA, and iB.
an R-L circuit takes a current of 7amp that lags behind the 231-volt source by 35elec deg. calculate the power factor, power, impedance, resistance, and inductive reactance of the circuit.
Given the circuit shown below, if Zx = 100<0degrees determine the current in each branch using NODAL METHOD