Find the drift velocity varift of conduction electrons in a gold wire of diameter 2.98 mm when a current of 0.175 A flows in it. The density of conduction electrons in gold is 5.90 x 1028 m-3, O 15.8 x 10-6 m/s O 17.8 x 10 6 m/s O 4.32 x 10 6 m/s O 2.66 x 106 m/s

Find the drift velocity varift of conduction electrons in a gold wire of diameter 2.98 mm when a current of 0.175 A flows in it. The density of conduction electrons in gold is 5.90 x 1028 m-3, O 15.8 x 10-6 m/s O 17.8 x 10 6 m/s O 4.32 x 10 6 m/s O 2.66 x 106 m/s

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter10: Using Wire Tables And Determining Conductor Sizes

Section: Chapter Questions

Problem 10PP: Determine the ohms-per-mil-foot of an aluminum conductor located in an area with a temperature of...

See similar textbooks

Related questions

Q: 1. Calculate the component values necessary to give the design of a Class B common emitter amplifier...

Q: A copper wire of radius a = 0.172 mm has an aluminum jacket of outer radius b = 0.231 mm. There is a...

A: Data Given , Inner Radius of the wire ( a ) = 0.172 mm = 0.172 × 10-3 m Outer Radius of wire ( b ) ...

Q: Please use f=60 hz then solve Vrms and Vaverage. Always wrong answer pleasw help

A: In this question Sinusoidal waveform is given. So determine the rms and average value of the given ...

Q: E=14V R1=471 ohm R2=363 ohm R3=450 ohm Calculate ID2

A: In this question, If E=14V, R1=471ohm , R2=363 ohm, R3=450 ohm Calculate diode current in the dio...

Q: 196 G (s) = s (s + 8) Find the frequency domain specifications for the system

Q: Is it not important to match lamps to ballast because no harm will occur if they are mismatched

A: The ballast is used with the lamp specifically with the fluorescent lamp. The ballast is used to pro...

Q: Determine the terminal voltage of a 4-pole, 3-phase alternator that is running at 50 hz. The alterna...

A: Per phase induced emf = 4.44×f×flux×per phase turns× winding factor.

Q: 13- Find the Thevenin and Norton equivalent circuits between ab. 2 A b a 4Ω 6Ω 18 V 3 A 10 V Zoom 14

Q: Find current I, in the following circuit using the phasor approach, if Z1= 40 0, Zz= j30 0, Zg= 40 0...

Q: 10 V a 30 V 8 V

Q: Why are transformers more efficient than rotating electrical machines? *Cite your reference* Subject...

Q: A unity feedback system has been operated for 5 years and need to be evaluated. It has an open loop ...

A: Solution- Gs =Ks(s+1) (s+3) a) for 4.32% overshoot , e-πξ/1...

Q: 12 0 20 0 40 V 25 0 5A 40 0 Q#2. Find voltage V across the 40 O resistance using Superposition Metho...

Q: A six-pole three-phase wound-rotor motor is to be used as an induction frequency converter. The stat...

A: The solution is given below

Q: QUESTION 13 Save Answer A 4 unit apartment complex has a 150-ampere panel in each unit. What ampere ...

A: Given, A 4 unit apartment has a 150-ampere panel in each unit. Number of unit, n = 4 Each unit has c...

Q: A load of 1500 KW is connected at the receiving end of a 3 phase transmission line 80 km long. The p...

A: Given Transmission line Length L=80 kmLoad PL=1500 kwReceiving end voltage VL=21 kvPower factor PF...

Q: Q2/ For the current shown in the figure below, find the charge waveform and then find the value of c...

A: The solution is given below

Q: The three-phase balanced load in the figure below has impedance per phase of Zy =6 + 8j ohm. If the ...

A: Given, ZY=6+8j ΩVL=220 V

Q: Consider the circuit in Figure 2 below, with transistor parameters ß = ∞, V,

Q: 1. For the circuit shown below, a. determine the current I, by the nodal analysis. 12 0 ww 24 V 623 ...

A: Given circuit,

Q: Consider the signal x(t) whose Fourier transform is { 1, w| w. X(jw)

A: We have,fXω=∫-∞∞eipxXxdx=∫-∞-WeipxXxdx+∫-WWeipxXxdx+∫W∞eipxdx =∫-∞-Weipx0dx+∫-WWeipxXxd...

Q: Answer fast please Voltage is 60 volts and current is 4 amps.Find Resistance and power?

A: The solution is given below

Q: For the armature controlled DC motor shown, find the transfer function. Assume the following numeric...

A: Solution

Q: Find the wave impedance for the dominant mode in an air filled rectangular waveguide of dimension 8 ...

A: Given, Air filled rectangular wave-guide with dimensions a=8 cm=0.08 mb=5 cm=0.05 m Operating freque...

Q: Q2/ For the current shown in the figure below, find the charge waveform and then find the value of c...

A: The solution is given below

Q: Determine the exponential Fourier series for the impulse train shown below. x(t) 1 -2T -T 0 T 2т. 3п...

A: The solution is given below

Q: Q7: For the circuit in Fig 7, find i, iy, and the power dissipated by (absorbed by) the 3 S resistor...

A: In this question We need to determine the currents ix and iy as shown in the circuit. Power absorb ...

Q: polar coordinates are used mostly for drawing

A: 1)ANSWER IS ANGULAR LINES WE USE POLAR COORDINATES FOR ANGULAR LINES IN AUTOCAD FOR ELLIPSE AND CIRC...

Q: A circuit is operated at its resonant frequency, which is designed to be 240 Hz. The circuit contain...

Q: 3. Determine V, and V2. 1 + Vi lov( + V2_

A: Given circuit:

Q: HoW: Find xcn) if: +る Bns: xcn)-- 80 (t)^+ 80 (+)"-52n (t) +12n* (b)"

Q: A three-phase converter has a d-c rating of 120kw and 600volts. Assuming an efficiency of 94 percent...

Q: R1 XMM1 1k0 t01 R3: 5000 R2: 1kQ V1 12V

Q: What is the smallest number of poles that can be used in two synchronous machines if it is desired t...

Q: Use Kirchhoff's current law to determine the magnitudes and directions of the indicated currents in ...

A: This question belongs to electrical circuit theory . It is based on the concept of kirchhoff's curre...

Q: A 400V, 25hp, 601 4 pole, Y-connec induction motor I the following

A: Given that 400V,25hp,60Hz,4pole Y-coonected induction motorR1=0.641ΩRF=11.080ΩXl=1.106ΩXF=6.68ΩPr+W=...

Q: Three Impedances each of (9 - j18)N are connected in mesh across a three-phase 415V ac supply. Deter...

Q: 2 Efud inductoniee pes km per phace.

Q: 4.41 Find the Thevenin and Norton equivalents at terminals a-b of the circuit shown in Fig. 4.108. 1...

Q: A Karnaugh Map is shown below. Which function is the correct minimum sum derived from the Karnaugh M...

A: Given Karnaugh map,

Q: V2 R1 (+ 1 1000 0.7 V1 V 12 .OP +) (+)

Q: A short shunt compound generator has an armature,shunt field and series field resistances of 0.02 oh...

Q: Write the voltage as a function of the transformer turns ratio for the following circuits respecting...

A: This question belongs to electrical machine . It is based on the concept of relation between transfo...

Q: a) Design a saturated load inverter shown in the figure below with VDD = 3.3 V and VL = 0.25 V. Assu...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: What size branch circuit THW conductors would you need (bare minimum) for an AC 3 phase 40 horse pow...

Q: 3- In a High Pass Filter, the filter response curve has a slop of 6dB/ octave with a cut of frequenc...

Q: Three identical capacitors are connected in delta to a 408 V, 50HZ, 3-phase supply. If the line curr...

A: Given data, Connection is delta, Line voltage VL=408 V For delta connection VL=VP=408 V Line curren...

Q: Voltage Peak value RMS value Average value Peak-to- peak value O V Time VT = Vmsinwt

A: Given, The wave form is sinusoidal. Please find the below attachment for the clear explanation.

Q: Q3. A discrete time LTI system described by y[n] + 0.5y[n – 2] – 0.3y[n – 3] = x[n] – 2x[n – 2]. Det...

A: Givenyn+0.5yn-2-0.3yn-3=xn-2xn-2

Q: Determine the operating power factor of a 6.6kV Y-connected synchronous motor has a synchronous reac...

A: Givenlet δ be the excitation angleThen excitation voltage Ef=6.6∠δ°KvInduced voltage V=5.16Kv/ph

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A circular coil has a mean diameter of 100 cm having an electron density of 3.34 x 1024 e/m3 with a cross sectionalarea of 10 square cm. How many electrons will pass through the conductor?
A certain conductor has a free electron density of 2 x 10 30 electrons per cubic feet. Its circular cross- sectional area is 150,000 square mils and 120 meters long. Its resistivity at 30 degrees Celsius is 0.9 x 10 – 8 ohm-meter. If a current of 3 A passes thru this conductor, find the drift velocity in mm per second.
A cylindrical conducting wire which is 4658.98cm long, 83.02mm thick and resistivity of 8.92 ohm per meter has how much resistance
Neglecting losses and fringing effects and assuming the substrate of a stripline to have a thickness of 0.42 (mm) and a dielectric constant of 2.83, determine the required width (in mm) of the metal strip in order for the stripline to have characteristics resistance of 78 Ohms. No need for a solution. Just write your numeric answer in the space provided. Round off your answer to 2 decimal places.
A lead conductor is 5 cm in length and 8 sq. cm in cross sectional area. The terminals to be joined by this conductor is 8 cm long. Assuming that the resulting conductor has uniform cross-sectional area, determine the resistance. ρ lead = 1.77 x 10-8 Ω-m α lead = 0.00422 Ω/C˚
A specimen of copper conductor has a resistivity of 1.6x10-8 Ω -m at 0 C and it mean temperature coefficient is 0.00428/o Find the resistivity at 60o C (oK = 273.5 + oC). The resistance of a cylindrical brass conductor 0.5 cm diameter and 3 m long are 0.0108 Ω. Determine resistance of a cylindrical conductor of the same material at the same temperature and having a diameter of 0.25 cm and a length of 8 m.
An 18-gauge copper wire with a diameter of 4-mm carries a constant current of 1-A. The charge concentration in the wire is 8.5 x 1028 per cubic meter. Determine the drift velocity in um2/s. Use q = 1.602 x 10-19.
To the right of the infinite sheet with a surface charge density of a= 5.0nC/m², there is an infinitely sized conductive sheet with a thickness of 20.0 cm at a distance of 3.0m. If the position of the leaf is taken as X=0, (you can get k=9x109 ) a) Electric field at X=-1.0m b) Electric field at X= 4.0mc) What is the electric field at X= 3.10m?
A certain conductor bar of rectangular cross section 0.02 by 0.08 m and length 2.0 m has a voltage of 50 mV. If its conductivity is 5.8 x 107 S/m and its mobility is 3.20 x 10-3 m2/V-s, find its volume charge density in giga-C/m3.
Q6-Assuming that all of the valence electrons contribute to current flow, (a) calculate the mobility of an electron in copper and (b) calculate the average drift velocity for electrons in a 100 cm copper wire when 10 V are applied. Given( The lattice parameter of copper is 3.6151 10", copper is FCC, a = 5.89 x 105)
Determine E at the origin due to a uniform line charge distribution with ρL = 3.30 nC/m located at x = 3m, and y = 4 m.
If there are three infinite uniform sheets in x=-2, y=-2 and 2=-2 respectively infersect with each other to formulates three infinite uniform line charges with a linear charge of -10 n C/m each. Determines the Electric Flux Intensity at the origin?