Find the equivalent mass (equation) if it were placed at point B.

Q: Body slides on a sloped plane with an angle a =50 Determine the velocity of the body after t =10 s…

A: Given:The angle of inclination, The time after which the velocity is to be determined, The…

Q: A spherical, stainless steel (AISI 302) canister is used to store reacting chemicals that provide…

A: Given:The constant heat flux, The initial temperature of the canister wall, The density of the…

Q: The relation between the flow rate through a pipeline of area A and the pressure drop Ap across an…

A: Pipe Diameter (D) = 1 mFlow Rate (Q) = 2 to 10 m3/minDensity of Water (ρ) = 998 kg/m3 (at 20…

Q: The values of a, C, and bare > and , respectively.

A:

Q: The figure above shows a shaft subjected to a force P = 20 kN and a moment Mv = 600 Nm. Other data:…

A: The force applied is The moment torque is The dimension are

Q: Assuming specific weight of air to be constant at 12 N/m3, what is the approximate height of a…

A:

Q: The first man who studied and partially understood the kinematics of a particle falling in the…

A: Draw the figure

Q: Question 2 (Type B) What are the tensions in each of the 4 cables supporting the lamp, if the lamp…

A: What are the tensions in each of the 4 cables supporting the lamp, if the lamp weighs 50 lbs and the…

Q: An L shaped bracket is supported by a frictionless pin at A and a cable between points B and D. DB…

A:

Q: 2.104 The massless, 4-ft-wide gate shown in Fig. P2.104 pivots about the frictionless hinge O. It is…

A:

Q: могог Worm Gear co Draw Free body diagran for this system? Recommed draw each Spur (tear…

A:

Q: Determine the x and y components of each of the force vectors below. Show your work. please

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: The developed velocity profile in a square duct can be given by the following equation Where a is…

A:

Q: Why does the water enter the condenser at the lowest point and leave from the highest point?

A: A water-cooled condenser is a heat exchanger that removes heat from refrigerant vapor and transfers…

Q: Problem 4: Draw the shear and moment diagrams for the beam. A -1.5 m- 6 kN/m -1.5 m- 3 kN B

A:

Q: 65 A particle can slide along a track with elevated ends and a flat central part, as shown in Fig.…

A:

Q: The sliding plate viscometer is used to measure fluid viscosity. The top plate (100 mm x 50 mm) is…

A:

Q: What to submit? 1. Set up a CFD simulation for the horizontal channel by Ansys Fluent. 2. Define the…

A: DefinitionCFD simulation:CFD simulation is a computer-aided engineering (CAE) technique that…

Q: 2. (20%) A rod of diameter, 22 mm is fixed into a wall as shown and subjected to a uniform axial…

A: The forces are The distributed load isThe length are The diameter is

Q: What are the Miller indices of the planes ABC, BCED and BFGH; and directions BC, AB and BH in the…

A:

Q: Determine the resulting torque in the following plane under the action of the force system, if it…

A:

Q: A solar pond power plant produced power output at 350 kW and thermal efficiency of 4%.Sketch the…

A:

Q: A brass rod is 3 m long at temperature of 15oC. Find the expansion of the rod, when the temperature…

A: Given:The length of the rod is The initial temperature is the final temperature is The coefficient…

Q: The 2-m wide gate ab depicted on the right retains water 3 m deep. Determine the horizontal and…

A:

Q: The uniform, thin slab in Fig. 9-48 weighs 0.25 lb/in. Given the coefficients of friction at the…

A:

Q: Determine the moment about point B of each of the three forces acting on the beam using the Scalar…

A: The objective of the question is to calculate the moment about point B for each of the three forces…

Q: a. T=400°C, p= 20 MPa. b. T=40°C, p= 20 MPa. c. T=40°C, p=2 MPa.

A: The amount of volume per unit weight is called specific volume.

Q: A 75-kg crate is attached to the trolley-beam system shown. Knowing that a =1.8 m, determine (a) the…

A: A 75-kg crate is attached to the trolley-beam system shown. Knowing that a =1.8 m,Determine-(a) the…

Q: Find the equilibrium positions of this system and linearize the system about two of its equilibrium…

A: DefinitionOne Degree of Freedom System:A system that can only move in one direction or rotate about…

Q: 2. A basketball with a radius of 12 cm is inflated with air at 21°C. If the pressure is 165 kPa,…

A:

Q: Starting at x = -18 m at time t = 0 s, an object takes 18 s to travel 46 m in the +x direction at a…

A:

Q: lculate the mobility of each of the items below and identify them as a mechanism, structure, or…

A:

Q: ISIN Food Ce 20kN/m 2 80 KN

A: overhanging beam is given as shown below

Q: The hoist consists of a single rope and an arrangement of frictionless pulleys as shown. If the…

A:

Q: change the flow from turbulent to laminar. How does the velocity profile and fanning friction factor…

A: is fluid density. is average flow velocity. is internal diameter of pipe. is fluid viscosity.

Q: Determine the value of P that initiates yielding of the column.

A: a is outer length of tube.t is thickness of tube.

Q: A column is constructed from high strength concrete reinforced with 8 A992 steel rods. The column…

A:

Q: It is required to cut screw threads of 2 mm pitch on a lathe. The lead screw has a pitch of 6 mm. If…

A: Need to determine the speed of lead screw.

Q: Solve the following log equations for x:

A:

Q: How did you determine that is F2 = -15cos30cos50i + 15cos30sin50j + 15sin30k? Why is it not…

A: For the solution refer below images.

Q: Replace the force system acting on the frame by an equivalent resultant force, and specify where the…

A: The objective of the question is to find the equivalent resultant force and its point of application…

Q: A crate weighs 640 lb and is hung by three ropes attached to parallel to the zy plane. Point A is…

A: The weight of crate is The dimension are

Q: Exercise 1 - stiffness matrix of a simple frame. Find the stiffness matrix for the problem on the…

A: The value of E is The value of A is The length is

Q: Answwer pls

A:

Q: Block A weighs 10 kg and Block B weighs 100 kg. They are mounted to frictionless pulleys When the…

A: Given-To Find-Determine the acceleration of Block ADetermine the acceleration of Block BDetermine…

Q: (ideal gas again) is initially containe time zero the partition is removed, a x. At the same time…

A: The mass of air in each box is-

Q: 3-18 3-19 For each of the stress states listed below, find all three principal normal and shear…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: 4) The acceleration of a particle is given by: a = -kv where k is a constant and v is the…

A: The acceleration is k is constant, v is instantaneous speed.

Q: 2.110 The closed vessel of Fig. P2.110 contains water with an air pressure of 10 psi at the water…

A:

Q: Example 1: Water flows through a 200-mm diameter watermain. Over a 500-m length, the hydraulic…

A: Given:The diameter of the water main, The length of the water main, The falling in the hydraulic…