Find the pressure at depth of 2 m from free surface of water
Q: aced on a rough inclined plane of inclination 45°. The coefficient of friction ock B and inclined…
A: given:inclination =450seperation between two blocks 2mg=10m/s2
Q: dvantages and disadvantages of fixed wing and rotary wings
A: Advantages and Disadvantages of Fixed wing and Rotary wings Advantages of fixed-wing Increased…
Q: The slotted arm OA rotates about a fixed axis through O. At the instant under consideration, 0 =…
A: Given:m=0.6 Kgθ=34°
Q: ) Based on the vibration signal shown in Figure determine the damping ratio, natural frequency and…
A:
Q: Figure Q2(a) shows a Watt flyball governor system. i. Very briefly describe how the following…
A: Given figure shows a Watt flyball governor system: We have to answer the following questions.
Q: Sketch two more stress-strain diagrams, again one for a ductile material and one for a brittle…
A: Stress and strain: Stress is defined as the internal resisting force per unit area; it represents…
Q: Determine the force in each member of the loaded truss. The force is positive if in tension,…
A:
Q: Calculate the acceleration produced by a force of 200 N exerted on an object of mass 20 kg.
A: Given data: F=200 Nm=20 kg Need to determine the acceleration of the mass.
Q: Calculate the forces in members BC, BE, and EF. Solve for each force from an equilibrium equation…
A:
Q: What will be the season below, will a gasoline powered car engine will work most efficiently? a.…
A: Correct answer: (a) winter
Q: Calculate the force in member BG using a freebody diagram of the rigid member ABC. The force is…
A:
Q: Compute strain Stress-40 MPa Modulus of elasticity=100 MPa
A:
Q: The hoisting system shown is used to easily raise kayaks for overhead storage. Determine the…
A:
Q: How to find H available and H required? Using what formula? Briefly explain the calculation part.
A: Havailable=Ho-aQ2Ho=24.4a=0.0678 m/Lpm2
Q: what would be the order of operation to make this part on a virtical mill and what would be the…
A: Note: As you have posted multiple question, i will be answering first question. Please resubmit the…
Q: The particle of mass m = 2.5 kg is attached to the light rigid rod of length L = 1.27 m, and the…
A:
Q: Water is flowing upwards through the venture meter shown in the figure. The water volumetric flow…
A: Givenρw=1ρhg=13.54Q=0.54 m3/s
Q: The crank OA of the mechanism shown in Figure 1 rotates uniformly at 180 r.p.m n clockwise…
A: NAO=180r.p.m., or ωAO=2π×180/60= 18.85 rad/s OA = 150 mm = 0.15 m A B = 450 mm = 0.45 m PB = 240…
Q: Saturated vapor is condensed to saturated liquid in a condenser. The heat capacity ratio is The…
A:
Q: Write the given data. Type of bolt=SAE grade 2F=20000 lbn= 50=0.750proof Calculate the load on each…
A:
Q: Determine the force in member EF of the loaded symmetrical truss. Assume no horizontal reactions at…
A:
Q: Compute the potential energy stored in raising object to height of 6.55 m having mass 10 kg
A:
Q: In an auditorium a temperature should not exceed 23 deg C and 55% relative humidity, total occupancy…
A: Given: The auditorium temperature, T1 = 23 C The relative humidity, RH = 55% The number of people, N…
Q: I need help solving 4 hrough 10
A: As per Bartleby guidelines, we will provide 3 sub parts for you.
Q: Draw the shear and moment diagrams for the beam below. Show all calculations and sketches. Draw the…
A: Draw the free-body diagram of the left part from point C. Apply force equilibrium in horizontal…
Q: DO first case, Rex, = 5 × 10³, while in the second case the flow is tripped to a tu e the thermal…
A: V = 1.5 m/sT∞ =45°CTs = 20°CRex,c = 5 × 105x = 0m To-Determine:- x = ____mqlam'' = ____ W/m2qturb''…
Q: A bar is attached to the spring at the point C. The left end of the bar is pin supported and can…
A:
Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…
A:
Q: 2. For the structure shown, determine the weight (W) that can be suspended for the system to be in…
A: (a) Draw the free-body diagram except ABC link. Apply moment equilibrium about joint B.…
Q: From the given table below Task A B C D E F G Immediate follower B E D E F G T 1) Draw precedence…
A: As per our company's guidelines, we are allowed to answer only the first three subparts. Kindly…
Q: Calculate the force in member BG using a freebody diagram of the rigid member ABC. The force is…
A:
Q: Determine the magnitude of the pin force at A. Assume W = 810 lb, a = 4.6 ft, b = 3.2 ft, r = 9 in.…
A: Given: The weight, W = 810 lb The length of BC and AB, a = 4.6 ft The distance between A and D, b =…
Q: a) Calculate the make up rate of the water by doing a material balance between the water stream and…
A: For set 1 , Mass flow rate of makeup water (m 1 makeup water) = m1 dry air *(ω1 B-ω1 A ) =…
Q: A 100-kg box is towed to move horizontally from rest by a constant force P=200 N. The kinetic…
A: Given:m=100 KgP=200 Nμk=0.1θ=30°g=9.81m/s2
Q: Find the equation of motion of a spring mass system by using Langrargian method and obtain it's time…
A: given; solving equation of motion for spring mass system through Lagrangian method and time period.…
Q: The water jet -13.5 cm in the figure strikes normal to a fixed plate. The velocity of the jet is -8…
A: Write the given data. Dj=13.5 cmVj=8 m/s
Q: (b) An airplane is flying at 1000 km/h through a still air having a pressure and temperature of 78.5…
A: Given data: V=1000 km/h=277.77 m/sP0=78.5 kN/m2T0=-8°C=265 KR=287 J/kg.Kγ=1.4 Need to determine the…
Q: Compute the kinetic energy stored in car of mass 49 kg moving with velocity 34 m/s
A: Given data : Mass m=49 kg Velocity V=34 m/s Required : Kinetic energy
Q: The electric motor exerts a 500-N·m torque on the aluminum shaft ABCD when it is rotating at a…
A: Given data: TBC=200 N.mLBC=a=1.4 mG=27 GPa Need to determine the angle of twist between B and C.
Q: Find the velocity of car Kinetic energy=888 J Mass of car-70 kg
A: Given:Kinetic energy, KE=888 JMass of car, m=70 Kg
Q: The initial cost of a pickup truck is $10,048 and will have a salvage value of $4,400 after five…
A:
Q: The 160-lb exerciser is beginning to execute a bicep curl. When in the position shown with his right…
A:
Q: what would you do if it was a through hole that went all the way through the 6 inch shaft?
A: Given question: what would you do if it was a through hole that went all the way through the 6…
Q: gure 20 m/ 1 of 1 1.5m/ shown Express the coefficients using three significant figures. 197] ΑΣΦ | Η…
A:
Q: A gas in a cylinder expands from a volume of 0.110 m³ to 0.320 m³. Heat flows into the gas just…
A: Given:V1=0.110m3V2=0.320m3P=1.65*105 PaQ=1.15*105J
Q: Compute the final velocity off car U=6 m/s a=9.55 m/s2 t=4 s
A: Given data : Time=t Acceleration=a Initial velocity=U Required : Final velocity
Q: The case of a piston-cylinder device provided with stops is presented. Initially, the water supports…
A:
Q: The force P is applied to the 41-kg block when it is at rest. Determine the magnitude and direction…
A:
Q: A rigid horizontal bar ABC is supported by three vertical rods as shown. The stress free before the…
A: Given dataChange in temperature, ∆T=110°FApplied Load, P=45 kNFor Rod 1E1=105 GPa , α1=22×10-6/°C,…
Q: The specimen shown has been cut from a 5-mm-thick sheet of vinyl (E = 3.10 GPa) and is subjected to…
A: Given data: t=5 mmE=3.1 GPaF=1.5 knl=54 mm Need to determine the total deformation of the specimen.
Step by step
Solved in 2 steps
- The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.Determine the volume of the concrete arch dam.ii. If the surface tension of the drop be 42.27x103 N/m, find the pressure difference of the drop
- a rectangular plane 1.2 m by 1.8 m is submerged in water and makes an angle of 30 with the horizontal. the 1.2 m sides being horizontal. What is the minimum pressure acting on the plane in kPa? What is the maximum pressure acting on the plane in kPa?If the tank is held so that the top is 3.0 m below the surface of water, what is theforce on the inside top of the tank?An open storage vessel has 3 m of oil (SG = 0.82) and 6 m of water. Find the pressure at the bottom of the tank.
- Find the pressure in kPa at the bottom of an 8m column of waterA 2x2 m tank with vertical sides contains oil with adensity of 900 kg/m3 to a depth of 0.8m floating on water with adepth of 1.2m. Calculate the pressure at 0.8 m from the top andthe pressure at the bottom.An inverted CONICAL tank (D = 0.5 m, H = 1 m) is full of water. Find the pressure at the bottom of the tank if it is moving downward at 2 m/s^2.
- Answer Part A; Also, calculate the location from the bottom of the pool to the center of pressure of the water on wall ABFind the vlaue of Pressure if the manometer reads 0.01 mm. use the density of Hg from standard book at normal condition.An open storage vessel has 3 m of oil SG = 0.82 and 6 m of water.The pressure at the bottom is: