Find the tension in the diagonal cable and the magnitude and direction of the force on the strut by the pivot. The weight of the crate is 2500 N. The strut is uniform and 3.0 m and its weight is 6000N. The angles are a=40 and ß=50 degrees. Draw all the forces acting in the system. Use 2 significant figures in your answer. Write units in calculations. B la

Find the tension in the diagonal cable and the magnitude and direction of the force on the strut by the pivot. The weight of the crate is 2500 N. The strut is uniform and 3.0 m and its weight is 6000N. The angles are a=40 and ß=50 degrees. Draw all the forces acting in the system. Use 2 significant figures in your answer. Write units in calculations. B la

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.97P: The figure shows a wire cutter. Determine the cutting force on the wire at A when the 75-N forces...

See similar textbooks

Similar questions

Find the internal force systems acting on sections 1 and 2.
Find the internal force system acting on section 3 for the pin-connected frame.
Calculate all forces acting on the bar AB described in Prob. 5.1.
The homogeneous bar AB weighs 25 lb. Determine the magnitudes of the forces acting on the bar at A and B. Neglect friction.
Find the forces in the three cable segments and the angles 1,2, and 3.
The bent rod of negligible weight is supported by the ball-and-socket joint at B and the cables attached to points A and C. Find the forces in the cables and the magnitude of the reaction at B. Dimensions Figure P.5.39
The figure shows a wire cutter. Determine the cutting force on the wire at A when the 75-N forces are applied to the handgrips. (Hint: The horizontal components of pin forces at B and D are zero due to symmetry.)
The cable AOB weighs 5.2 N/m. When the horizontal 30-N force is applied to the roller support at B, the sag in the cable is 5 m. Find the span L of the cable.
The figure shows a control bar, subjected to a force of 90N. Since the length of the bar is 225 mm and the moment of the clockwise force on B is 13.5 N.m, determine the value of α. Solve the problem using scalar notation and explain your result.
#1: A moment Macts on the brake drum shown. The radius of the drum is 150 mm. If mu = 0.35 between the drum and belt, calculate the larger tensile force exerted by the belt. Also, determine the magnitude of the braking moment M due to the vertical force P = 120 N.
find the forces in each point of the figure shown
Using the image below replace the distributed loading with an equivalent resultant force, and specify its location on the beam measured from point A. Let the length be: L1 = 9 ft. Let the loads be: W1 = 70 lb/ft, W2 = 420 lb/ft. Note you must determine the coefficients a and b based on the given intensities of the loads W1 and W2, respectively.