Find the tensions in the ropes that hold a 100N box. The ropes are considered weightless and are at respective angles of 37° • and 60° with the horizontal,

Q: gate AB 4 ft long and 2 ft wide is held in position shown due to the spring whose constant is 96.0…

A: Given:length og gate, l=4 ftwidth of gate, w=2 ftk=96.0 lbf/inx=1.5 ft

Q: is a homogeneous ball of weight N 1000 resting on a smooth wall and resting on B8 an arm of length 5…

A:

Q: what is the vector reparesentation of the tension at J?

A:

Q: Q3 Find the resultant of force Y 390 Ib IMATHalino.com 12 30 X 300 lb 722 lb Figure P-265 5n

A:

Q: find the resultant force of following like parallel forces p1=20n ,p2=50n,p3=60n,p4=70n .take…

A: Assumption 1) Considering Coplanar forces

Q: Find the magnitude of all the elements and tell whether they are in tension or compression.

A:

Q: Find the tension in cable CE

A:

Q: This plate (with mass, m=500kg) is supported by 3 vertical perpendicular cables attached at the…

A: Solution:

Q: 3. GIVEN: ABC has weight of 150 lb. Member BD has weight 50 lb. Find: a) Component forces at point A…

A:

Q: two logs that has equal length (s) is attached to a wall with hinges, creating a equilateral…

A:

Q: Two men carry a weight of 2 kN by means of two ropes fixed to the weight. One rope is inclined at…

A: Hello, I think that one of the answers given with the problem is wrong. I have checked my solution…

Q: In the given picture, the weight of the bar AC is 300lb and the weight of the bar DB is 200lb(the…

A: Given data Weight of the bar AC is 300lb Weight of the bar DB is 200lb To determine the normal…

Q: Two identical rollers, each of weight W = 100 lbf, are supported by an inclined plane and vertical…

A: Given; W=100 lbf Angle θ=30° To Find, RA,RB and RC

Q: A vertical boom is supported by guy wires from A to B, C, and D. If the tensile load in AD is 252 N,…

A:

Q: Find the internal forces at point B. 200 N · m A B - 1m 1 m 2 m (а)

A:

Q: Find the internal forces at the point E, if the mass of the cylinder is 10kg and the force in the…

A: There are two types of forces that are acting on a circular surface. One type of force is Radial…

Q: Find the tension in string A and the force B exerted on the string by the beam in the figure.

A:

Q: Find the resultant force for the forces shown below. Assuming F1 = 150 N and F2 = 200 N.

A:

Q: Find the x-component a force, 100N, acting 60 degrees below the x-axis,

A:

Q: Two ropes are used to support a wooden pole momentarily to held it vertically upright as shown in…

A: Given data: Tension in the ropes 'DA' and 'DC' are: TDA=500 N , TDC=300 N Coordinates of the points…

Q: Find the forces in bars AB, CD, ID, HG, HD. Use P as 82 KN

A: Draw the free-body diagram of the beam. Apply force equilibrium in horizontal direction.…

Q: Two ladders, 4.00 m and 3.00 m long, are hinged at point A and tied together by a horizontal rope…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 4 3 ft 3 (1 -2 ft 2 ft 300 lb

A: So there is a truss given in the question with knife-edge support at end 3 and roller support at end…

Q: Two blocks are connected by a string. The smooth inclined surface makes an angle theta of 37 degrees…

A:

Q: B F: kN a kN 0,6 m D. -0.3 m-0.3 m-

A: Given data:-F1=20kN, F2=40kNSince, system is hinged at point C. Therefore, net moment about point C…

Q: Find the reactions at the support A and B in the system below.

A:

Q: A cylinder suspended by a rope rests against an inclined surface as shown. If the cylinder weighs…

A:

Q: The tube, shown below, is supported by two cables (AB) and (AC). A force F = 600 lb is applied in…

A: Write the position coordinates as follows.

Q: A ladder 12 m long leans against a vertical frictionless wall with its lower end 3 m from the wall.…

A: W = 40 N L = 12 m

Q: By the method of rectangular components, find the tension in the cables. 400 mm 300 mm 400 mm 400 mm…

A:

Q: Consider the weight suspended by two wires in each diagram. Find the magnitudes and components of…

A: Calculating the Angles      tan…

Q: Find the horizontal force , P required to turn the wheel weighing 500 over the block 10cm high if…

A:

Q: Find the y-component a force, 100N, acting 40 degrees below the x-axis, *

A:

Q: A 20kg mass is supported by two cables AB, AC, and a force F as shown in Fig.Q2. The tension in each…

A: Given that, Mass of the weight, m=20 kg, The coordinate of the points is, A≡0,y,8B≡5,4,0C≡-5,4,0…

Q: Calculate the tensions in cables AC and AB needed to hold the ball. Assume the ball mass is 45 kg,…

A:

Q: Find the forces at points A and B. C = 300 lb-ft R = 150 lb 4 ft. A 3 ft. B

A:

Q: For the figure shown if the tension in rope AD is 180 lb find the angle between AD and AB, and then…

A:

Q: Th lamp , mass = 10 Kg,  is suspended in the position shown. The undeformed length of spring AB is…

A:

Q: Consider the two boxes suspended from a combination of ropes in the figure to the right. (a) If the…

A: Ans(a)  Apply the condition of equilibrium  ∑Fx=0T1sin30°-T2sin50°=0T1=T2×1.532  ......(1)

Q: If a 200 N force F1 is applied to the piston with the 4 cm diameter, what is the magnitude of the…

A: Given                Force, F1 = 200 N     Specific gravity = 0.85

Q: If P is 8.571 kN, Find the force in CE

A:

Q: Q1) for the given gate find the force and it center of pressure, If H=3m and K=2m.

A: Given Data: The value of the H = 3 m and K =2 m. The height of the triangular gate is h = 1.5 m and…

Q: In the attached photo, the 3-wheeled cart weighs 120 lbs. If it is loaded as shown with a crate…

A: Total force:

Q: Determine the forces in membara CD and DF of the trues ahown in figure. 28 kN 18 kN D 4 m 4 m 4 m G…

A:

Q: The tension force at cable 2 is

A: for solution refer below images.

Q: Three concurrent forces are acting on a ring, shown as a point. If the forces are in equilibrium and…

A:

Q: e cable forces acting on

A:

Q: Calculate the tension T in the cable which supports the 1000-lb load with the pulley arrangement…

A:

Q: A rectangular gate (6m x 4m) is e hinged at A and supported by a stopper as shown. Find the reaction…

A: Given: The area of gate, A = 24 m2 The centre of pressure measured from A, yp = 3+0.4641 = 3.4641 m…

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.