Answered: Find the value of the resonance…

Find the value of the resonance frequency for the circuit (Hz) L= 0.25 H, and C = 0.125 µF. O a. 1500 O b. 500 C. 900 d. None e. 250

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 23. Plot the phase angle Vs frequency curve on a logarithmic scale.G(S)=10/(S(1+0.1S)(1+0.5S))…

A: According to question: Phase angle expression in terms of frequency is written as Phase angle plot…

Q: 25-23. A 520-µF capacitor in parallel with a 240-nH inductor have a quality factor of 7 at…

A: Given, In a parallel LC resonant circuit, L=240 nHC=520 μFQ=7

Q: 7. Given the following particulars: R_ = 40 N, Rc= 20 N, L = 0.254 H, C = 40 µF. Calculate: %3D a.…

Q: 4. A circuit consisting of a coil of resistance 122 and inductance 0.15 H in series with a capacitor…

A: Given, A series LC circuit with Resistance of coil, R=12 Ω Inductance, L=0.15 H Capacitance, C=12 μF…

Q: Sketch the magnitude and phase spectrum of the signal x(t) = e-Blt, b>0 9

Q: Determine the fundamental frequency of the given signal and state it's Nyquist rate: x(t) =…

Q: Sketch the asymptotic Bode plots of the magnitude and phase for 80s H(s) S = jw (s + 10)(s + 20)(s +…

Q: 5. Derive an equation for the resonant frequency and find its value for the equivalent RF circuit…

A: The solution is as follows.

Q: An RLC series resonance circuit has a capacitance value is 22µF, resistor value is 12002 and…

Q: A carrier wave of 30 V amplitude and 6 KHz frequency is modulated by an information signal…

A: A simple problem on communication system. Look below for solution:-

Q: a. Resonant frequency expressed as o (rad/s) and f(Hz). b. Total impedance at resonance. c. Current…

Q: amplitude plot rises as the frequency increases

A: NOTE- “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: In the parallel resonance circuit, R = 250 W, L = 2 mH, and C = 20 mF. The circuit is driven by a…

Q: Compute the frequency response H¿(jw) = Vo/Is 2mH ll Is s (1) 1KN 4KN; v. 1ΚΩ

A: The solution is given below

Q: What is the voltage across a series the LC component if the frequency is at resonant frequency?…

A: In this question, What is the voltage across a series the LC component if the frequency is at…

Q: Complete the table below and draw the magnitude response (bode plot) of the circuit below L₁ m 2 V₁…

A: For the given circuit the corresponding output voltage is calculated for the given frequency and the…

Q: b) Determine the value of the capacitor and inductor of a series resonance circuit exhibiting the…

Q: QUESTION6 What is the bandwidth of this filter? + Vourlt) 10H スと Vinlt) InF A. 316 rad/s B. 300…

Q: * Let Vs = 20 cos(wt) V. The value of the resonance frequency is..kHz 12 k2 45 k2 1 µF 60 mH none of…

A: Given C = 1 uf, L = 60 mH To find Fr = ?

Q: At resonance, the impedance of the AC circuit is maximum. Select one: True False

A: In the phenomenon of resonance the impedance of the circuit is equal to the resistance of the…

Q: A parallel resonance network consisting of R-602, C=120µf and L=200mH is connected across a…

A: Resonance: Resonance is the frequency response of a circuit when it’s operating at its natural…

Q: 0.1 A ac current source operating at the circuit's resonance frequency wo. The value of the reactive…

Q: Problem3 For the circuit shown. For E-200V R=125KN, RL=162 L=ImH C-0.001µF )Find the value of VC at…

Q: 18 The resonance frequency wo of the circuit shown below is. rad/s: 10 mH 05 mF : 20 2 V cos ot

Q: If resonant frequency, wo = 1100 rad/s, find the following: a) L in mH; b) Quality factor Q; c)…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Calculate Resonance Frequency, Cutoff Frequencies, Bandwidth, and Quality Factor for the RLC…

Q: resonance frequency if Rw = 4ohms, V = 10, L = 50mH, C = 10micro farad and frequency is 60Hz

A: To determine the resonance frequency in RLC circuit. Given: R = 4 ohms L = 50 mH C = 10 micro-farad…

Q: H(jo) ja (0.01/a+1X/1)

A: The given transfer function is, H(jω)=jω1+0.01jω1+jω The corner frequencies are, ωc1=10.01=100…

Q: Eight different students tuned in the circuit for resonance and the values of resonant frequency in…

Q: The bandwidth of a composite signal is the difference between the highest and a. zero frequency b.…

A: Correct option is b) lowest frequencies The bandwidth of a composite signal is the difference…

Q: Draw the magnitude plot and phase plot for the following transfer function jw + 10 iw(iw + 5)2 H(w)…

Q: 11 Let Vs = 20 cos(wt) V. The value of the resonance frequency is..kHz* 12 k2 Vs 45 k2 1 μF 60 mH…

Q: For a series RLC circuit at resonance, the value of phase difference (p) 50° 900 O450 O

A: Given: Series RLC circuit at resonance.

Q: Problem 3 - Resonance in AC networks [8] The parameters of a series RLC circuit are R = 1 kQ, L = 8…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 21. A parallel circuit has the following parameters: R= 20; L= 1mH; C = 0.4µF. What the resonance…

Q: ec. Eng. Department Dr.Eng. Ammar All Sahrab Sheet of Questions A series RLC circuit with two…

Q: 1. For each of the driven RLC circuits specified below, do the following: i. Determine resonance…

A: Part (a) For the series RLC circuit, the given values are,

Q: Calculate the value of C for the circuit to be in resonance. C 702 3 cos 21 V (+ 3Ω Ո 3H

A: In parallel circuits find the admittance of the network The imaginary part of the admittance should…

Q: Determine the resonance frequency (kHz) for the circuit shown below: 10UF 0.5mH Vs

Q: 1. Find the frequency spectra of the signals shown in Figure below 20 10 10 30 t (ms) -30 -20 -10 20

A: Let given figure be x(t) It can be represented as a sum of two rectangular pulses. And the frequency…

Q: For the circuit below, find the resonant frequency: R1 150 L1 10uH C1 1n

A: At resonance impedance Seen from the source is purely resistive . First find total impedance seen by…

Q: Consider a system with the shown Bode Plot. If the input signal is x(t) = 4 sin (10,000 t), find the…

A: Here we have to find out magnitude of system and phase of system and output of system for a…

Q: Plot bode diagram of amplitude of H(o)= jw(1+0.01jw) (1+/0.26)(1+j0.05w) with respect to frequency.

Q: A series resonance circuit if R=2kQ, C = 1 µF, L=1µH the resonance : frequency is 1 Mrad/sec O 10^5…

A: In series resonance circuit, if two reactance's which are opposite, to cancel each other then the…

Q: If resonant frequency, wo = 1100 rad/s, find the following: a) L in mH; b) Quality factor Q; c)…

A: In this question parallel RLC resonance is given...We have to find out L, Q factor , bandwidth…

Q: 1. What is the resonance frequency of ac circuit? a) 1/VLC b) v(L/C) c) VLC d) LC

A: we need to find out resonance frequency.

Q: The upper and lower cutoff frequencies of a resonant circuit are found to be 8.05 and 7.95 MHz. What…

A: fH=8.05M fL=7.95M

Q: find out the resonance frequency & plot the resonance frequency behaviour as a function of the…

A: It is given that: L=10 nHC=1 pF

Question

I My courses / EE213-1-21-2-242130 / General / Quiz 2
RL
of
Vs
Find the value of the resonance frequency for the circuit (Hz)
L= 0.25 H, and C = 0.125 µF.
a.
1500
O b.
500
OC.
900
d.
None
e.
250
f.
1200

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For an FM modulator with modulation index m = 2, modulating signal Vm (t) = 5 sin (2000pit) and unmodulated carrier Vc (t) = 4 sin (200x10-3pit): a) Draw the frequency spectrum, indicating the amplitudes of the side frequencies. (b) Calculate the bandwidth per table of Bessel functions. (c) Calculate the bandwidth by Carson's Rule
Consider the angle modulated signal: v(t) = 10 cos [2πx108t + 3 cos(2πx103t)] Assume that the signal is PM. Find the bandwidth using Carson’s rule of the PM signal when themessage frequency is (a) doubled, (b) halved, but all else remains constant.
An FM signal has a maximum frequency deviation of 1500h and a modulating frequency of 500h, its total power is 6500w, applied to a resistive load of 1ohm, the carrier frequency is 400Mhz. Determine the voltage of the carrier frequency and the first three sidebands
Vm(t)=Vmsin(2pi*1000t) and an unmodulated carrier Vc(t)=15sin(2pi*500t),determine number of set of sideband frequencies, Amplitude, Draw the frequency spectrum showing their relative amplitude and explain
A certain non - resistive inductor of L = 150mH is connected across a lossless capacitor of C = 450microfarad. If the combination is connected across a 230V variable frequency supply, determine the resonance frequency
Assume in a certain frequency range that the ratioof output amplitude to input amplitude is proportionalto 1/ω3. What is the slope of the Bode plot in thisfrequency range, expressed in decibels per decade?
A 10.0-Ω resistor, 10.0-mH inductor, and 100-μF capacitor are connected in series to a 50.0-V (rms) source having variable frequency. If the operating frequency is twice the resonance frequency, find the energy delivered to the circuit during one period.
The equation of angle modulated voltage is v = 10 sin ( 108t+ 3 sin 104t). What form of angle modulation is this? Calculate the carrier and modulating frequencies, modulation index and deviation. Power dissipated in 100 Ω resistor.
An angle modulated signal with carrier frequency ωc = (2π*106 ) is described by the equation Φ(t) = 5 cos (ωct + 20 sin 1000 πt + 10 sin 2000 πt) (i) Find power in modulated signal(ii) Find frequency deviation Δf(iii) Find phase deviation Δφ(iv) Estimate bandwidth of Φ(t)
An angle modulated signal with carrier frequency ωc = (2π*106 ) is described by the equation, Φ(t) = 10 cos (ωc t + 0.1 sin 2000 πt) (a) Find power in modulated signal (b) Find frequency deviation Δf (c) Find phase deviation Δφ (d) Estimate bandwidth of Φ(t)
The carrier signal of amplitude 10V is frequency modulated (K=2kHz/V) by a signal with frequency spectrum shown: a. Determine the approximate bandwidth of the FM signal (Bessel approximation).b. Determine the approximate bandwidth of the FM signal (Carson approximation).c. The power dissipated by the FM signal in a 75-ohm antenna.Answers a) 24 kHzb) 16 kHzc) 0.667 W
A series circuit contains an inductance of 0.1062 mH, a capacitance of 106 pF and aresistance. At resonance, the impedance is 10 Ω. Determine the Q-factor and thebandwidth at resonance. ANSWER ASAP