Find the voltage across 30µF capacitor. * 40 μF 60 μF + v1 - + v3 - + 90 V (+ + 30 µF v2 20 µF v4 45V none of the choices 30V O 60V O 15V
Q: B2
A: To answer: (a) (i) most probable configuration for A (ii) least probable for A (b) (i) most probable...
Q: Assume Fizeau’s wheel has 360 teeth and rotates at 55.0 rev/s when a pulse of light passing through ...
A: Fizeau's experiment: C=2LNn- - -1 where, C is the speed of light L is the distance to the mirror N ...
Q: A thin glass rod is a semicircle of radius R (figure below). A charge is non-uniformly distributed a...
A: Given: The line charge density is given as λ = λ0 sinθ The value λ0 = 1 μC/m The radius of the semic...
Q: A 700-pF capacitor is connected across an ac sourcewith a voltage amplitude of 160 V and a frequency...
A: To answer: (a) the capacitive reactance of the capacitor and the amplitude of the output current of ...
Q: . Give your own example of a non-epistemic risk factor
A: To answer: example of a non-epistemic risk factor
Q: Advanced Physics Question
A: Given, Charge of capacitor, say Q, distance between plate increasing, All are calculated at initia...
Q: A seismic wave is described by the equation y(x,t) = (7.00cm)cos[(6.00 πrad/cm)x+(20.0πrad/s)t]. The...
A: Given: y(x,t) = (7.00cm)cos[(6.00 πrad/cm)x+(20.0πrad/s)t] Formula used: λ=2πkf=ω2π
Q: What is the magnitude of the rpm (revolution per minute) of a speck of clay on the edge of a potter’...
A: Given that, velocity = 1.56 m/s angular acceleration a R=4.8 m/s 2 . Let, the radius of the wheel...
Q: By using Beta function, the integral tan(0) d0 is equal to
A: The beta function has the following identity
Q: B9
A: As we all that if electric current or charge is flowing in a circuit it will generate a magnetic fie...
Q: HELLOOO, HELP WITH (NUMBER 5 LETTER D) PLEASE, 4 DECIMAL PLACES. COMPLETE SOLUTION, THANK YOUU!
A:
Q: The voltage across a 5- microFarad capacitor is: v(t)=5cos10oot V. Calculate the current through it ...
A: We have to first calculate charge on the plates of the capacitor, and we know rate of change of char...
Q: Find the resistance(in the unit of Ohm) of a Nichrome rod of diameter d=10 mm and has a length L=7 m...
A: Given:d=10 mmL=7 mρ=1.8×10-9 Ωm
Q: A conducting loop is dropped so that it passes from a field-free region into a region of uniform mag...
A: Lenz's law says that induced current in a loop is due to the change in magnetic field in the loop, a...
Q: A parallel-plate capacitor has a plate separation d=20 mm. A potential difference V=1129 volts exist...
A: Given that:d=20 mmV=1129 Ve=1.6×10-19 C
Q: Please answer Part B only, thanks.
A: For the case when the eta meson is at rest with respect to the laboratory frame of reference, it dec...
Q: Find the current (magnitude and direction) through each of the four resistors in the circuit. (Use r...
A: R1 = 5 Ω R2 = 5 Ω R3 = 10 Ω R4 = 10 Ω Let V1 = 5 V V2 = 10 V
Q: An important concern in the study of heat transfer is to determine the steady- state temperature dis...
A: Solution: As per the given data,
Q: Which of the following is true at the conductor surface? O The answer can be found on more than one ...
A: The electric field inside the conductor surface is zero and the surface of the conductor is equipote...
Q: Three capacitors of capacitances 2 pF, 3 pF and 4 pF are connected in parallel. (a) What is the tota...
A: We have given three capacitance connected in parallel as shown below-C1=2 pFC2=3 pFC3=4 pF
Q: A disk of radius R and mass M is on a horizontal plane with friction. While at rest you will applies...
A: Angular Momentum: Angular momentum of a particle about a point O is given by, l→ = r→ × p→ - - - (1)...
Q: An incandescent lamp filament has area 40 mm and operates at a temperature of 1127°C.Assume that all...
A: Given Surface area (A) = 40 mm2 Temperature (T) = 1127°C Filament's emis...
Q: Advanced Physics Question
A: Gaussian surface in Cylindrical form from above figure, We can write ∮E→·ds→=...
Q: - . Use the plot of B2(T) vs T given below and the information below to show that the inversion temp...
A: Solution. At inversion temperature, T=TiμJT=01CPT∂B2T∂TP-B2TTi=0Ti∂B2T∂TP=B2TTi=B2T∂B2T∂TP
Q: just part (e)
A: e) Given, Customer's acceleration is, a→customer=-1.52gj^=-1.52×9.8m/s2j^=-14.896m/s2j^ {negative s...
Q: Please answer Part A only, thanks.
A: According to the conservation of energy the total energy of the universe is conserved. Energy can't ...
Q: A copper transmission cable 100 km long and 10.0 cm in diameter carries a current of 125 A. How much...
A: Given that length of cable, l=100 Km diameter of cable, d=10.0 cm current, I=125 A The resistivity ...
Q: B5
A: Resistance is the amount of resist in the flow of current in the circuit. When resistances are in se...
Q: Suppose that in a laboratory experiment on inhalation, the average flow rate (Q) was measured which ...
A: (a) The average speed in ms-1. (b)The Reynolds number for the air flow in the trachea during inhalat...
Q: Only parts c&d
A: Given, fundamental frequency f = 311.13 Hz person is moving away from the chair at a speed of Vp = ...
Q: B1
A: To answer: The aperture efficiency of a rectangular aperture loaded on an x-y plane.
Q: Calculate the radius of the first Bohr orbit from given data and hence find radius of 3rd Bohr orbit...
A: Given Data : m=9×10-31 kg e=1.6×10-19 C h=6.63×10-34 Js, ε0=8.85×10-12 C2/Nm2
Q: In both inspiration and expiration, a pressure difference of 0.4 cmH2O causes a flow of 0.15 L/s. De...
A: The volume of air output per unit of time is measured by flow. The force applied to an area is measu...
Q: Two small orifices A and B of diameters 1 cm and 2 cm, respectively, are placed on the sides of a ta...
A: Discharge through orifice is given by, Q=Cd×a2gh
Q: None
A: Given, kinetic energy E= 8.4 MeV Binding energy of alpha particle =∆mc2Alpha particle has 2 proton a...
Q: A 220 Ω resistor, a 0.850 H inductor, and a 5.00 μF capacitor are connected in series across a volta...
A: Solution; The impedance of the LCR circuit is given by, Z=R2+XL-XC2 =R2+ωL-1ωC2 =2202+270×0.850-...
Q: A metal sphere of radius 20 cm is charged with 12.56 µC situated in air. Find the surface density of...
A: Given data- R= 20 cm=0.20 mQ=12.56 μC=12.56×10-6 Cr=?σ=?
Q: a.3 A 30 km long optical fibre has an attenuation of 0.8 dB/km at 1300 nm. Find the optical power la...
A: As a signal is transmitted through an optical fibre, signal losses occur due to attenuation of these...
Q: Please answer Part B only, thanks.
A: In this question, we use the space interval (△s)2=(c△t)2-(△x)2 between the events where the proton e...
Q: An object is 5.0 cm high and is placed 20.0 cm from a converging lens of a focal length 15.0 cm. (a)...
A:
Q: A 2600 kg car traveling to the north is slowed down uniformly from an initial velocity of 30.5 m/s b...
A: Given that,The mass of car (m) = 2600 (kg)The initial velocity of the car (vi) =30.5 (m/sec)The brea...
Q: The specific volume of a certain gas is 0.7 m3/kg. Determine its specific weight and mass density.
A: We have, Specific volume = 0.7 m3/kg We have to determine : Mass density ρ and Specif...
Q: Derive an expression of conservation of moment in differential form.
A: This principle is based on the law of conservation of momentum which states, the net ...
Q: An oil of density 917 kg/m is being pumped in a 15 cm diameter pipe. The discharge is measured as 85...
A: Given : 1) Pressure drop, p1-p2=∆p=95×103 N/m 2) Diameter of pipe, D = 15 cm =0.15 m 3) Length of pi...
Q: A refrigerator has a coefficient of performance of 2.10. In each cycle, it absorbs 3.10 * 104 J of h...
A: Given that,Coefficient of performance, k=2.10Heat from the cold reservoir, Qc=3.14×104JWe know that,...
Q: From the figure below, determine Ry * F = 300 N F = 450 N F3 = 600 N 45°
A:
Q: A truck moving at a rate of 50 m/s sounds itshorn with a frequency of 8000 Hz. Find thefrequency hea...
A: Given that:- The speed of the truck is vs=50m/s The original frequency is fs=8000 Hz The temperature...
Q: 1. Consider a closed loop of wire of two semi-circles of different radii (R and 2R) centered on a co...
A: Given, Semicircle wires with different radii carying current i
Q: D3
A: Solution D3: (a). The graph of polynomial P (x) has been given in the statement. The zeros of the po...
Q: Q6/ If the average time between collisions is 0.9 ps, calculate the laser bandwidth and the line sha...
A: Given: τc=0.9×10-9s The laser bandwidth due to collisional broadening is : B.W.=2τc=20.9×109B.W.=2....
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
