Answered: Find the voltage across and the current…

Engineering

Electrical Engineering

Find the voltage across and the current through the capacitor both at = 20 µSec. 2m 5V 2n + 3~ Z ·lov 83~ مرئی 2 MF

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 4RQ: 4. In what form is the energy of a capacitor stored?

See similar textbooks

Related questions

Q: Figure 80 10½ m 1 of 1 202 40 Part B Use your recommended method of analysis to find the power…

Q: How can electrical engineers design and implement efficient and sustainable lighting systems for…

A: We need to explain how can electrical engineers design and implement efficient and sustainable…

Q: Consider the circuit shown in (Eigure 1). Suppose that is = 54 A Figure (x) <60 202 + Vo 21x 1 of 1…

A: In the Given circuit, is = 54 Amp To find the voltage Vo And total power supplied in the circuit…

Q: + US www R + Va R ww R M R ww R R www + Ub

A: The given problem is from circuits. The detailed solution is given in the next step

Q: 1.) сh сuLATE V₁, V₂, 10 & POWER ACRIS GERMANIUM

Q: this is incorrect. answer should be V=((E1/R1 +i1 - (I2R5)/(R4+R5)) / ((1/R1 + 1/R2) + 1/R4 +R5))…

Q: 3. a. Obtain the transfer function of a highpass filter with a passband gain of 10 and a cutoff…

A: Given: In this question, the given details are, To obtain the transfer function of a highpass filter…

Q: 5. u and us input waveforms are shown in Figure, V-0.7v. Sketch the waveform resulting at vo and…

A: Given: A diode network, with VD=0.7 V and input wave forms as, To find: Voltage V0.

Q: Example 7. Determine Vo and I for the series circuit of Figure 10. +12 Vo Si 本 ID red Figure 10. IR…

A: The given problem is from analysis of diode. The detailed solution is given in the next step

Q: Problem 1 + 240 V Find R so that Vo = 60 V. R ww 45 Ω 10 22 m 180 Ω 18 22 + Vo M 12 Q2 Verify that…

A: Given, 1) we need to find R so that Vo = 60 V Using Basic Circuit Laws 2) We need to Verify that…

Q: perfect, thank you so much but can you give pointers about how to re-draw the circuit as that is the…

A: It is given that:

Q: 4. A three-phase A-connected six-pole winding is installed in 36 slots on a stator. There are 150…

A: Introduction A three-phase delta-connected system is a type of electrical power distribution…

Q: In the figure the currents are I₁ =59mA and I2 =542m.A. The voltage V₁ = 6.8 V. Determine the…

A: The given circuit diagram is shown below, The current is I1=59 mA The current is I2=542 mA The…

Q: A coil having an area 2m² is placed in a magnetic field which changes from 1Wb/m² to 4Wb/m² in an…

A: Given data, Cross sectional area A=2 m2. Change in magnetic field △B=4-1=3 Wb/m2. Time interval dt=2…

Q: Design a circuit that has the following characteristic table. (Hint: Connect two D-latches in a…

Q: A 4 pole lap wound dc machine has 728 active conductors running at 1800 rpm. The flux per pole is…

Q: Problem 3.12: Using Nodal analysis, determine Vo in the following circuit. 40 V 20 Ω Μ Vi ↓IN 20 Ω…

Q: QUESTION 10 x(n)=ō(n)+u(n)+r(n)+1, what is the x(5)

A: Given, Signal is x(n) = δ(n) +u(n)+ r(n) +1 we need to find x(5)

Q: When connected to a 120-V (rms), 60-Hz power line, a load absorbs 5 kW at a lagging power factor of…

Q: The oscillation frequency ofthe oscillation circuit is usually determined by ( ) A.Magnification…

A: We need to select correct option for oscillation frequency of the oscillation circuit.

Q: Q1)etermine the Fourier Transform of x(t) = e-(t/2)u(t) and sketch (a) ∣X(?)∣ versus ? (b) ∠X(?)…

Q: Ex28: Calculate the current through (Rx) in the circuit below. 802 32V 6A 40 2422 Rx complimentem **…

A: We need to find out the current through given resistor for given circuit.

Q: 2. The following questions pertain to the circuit shown on the previous page. (a) If the current…

A: In this question We need to determine the voltage va and current ib as shown the circuit with…

Q: Task 1: Theoretical Calculations - Nodal Analysis a. Consider the complex DC circuit in Fig 1. The…

Q: (ii) Draw the schematic structure of P-channel E-MOSFET with appropriate labelling for the terminals…

A: MOSFET It is an integrated device. It is controlled by voltage source. MSOFET→metal oxide…

Q: E2.3 The power absorbed by G, in Fig. E2.3 is 50 mW. Find G₁. Figure E2.3 10 V (+

A: In this question We need to determine the value of G as shown the circuit. We know Power across…

Q: Find V₁ and V₂ in the circuit shown below. V₁ 1x √ 2052 802 16A V₂ 21x

A: The given problem is from circuits. The problem can be solved by using nodal analysis. The…

Q: 1.26. Consider a signal x (t). Show that a. If a (t) is even, then b. If x (t) is odd, then ₁x (1)…

Q: Solution please. Should correct Consider a first order system with a transfer function of G(s) = K /…

A: We need to find out steady error for given system for given input .

Q: Simplify the following block diagram as much as possible, using the algebra rules for block…

A: Given: A control system with block diagram as, To do: Simplify the above block diagram.

Q: This answer is completely wrong

Q: 6 differences in electrical engineering principles in theory from practice?

Q: A self-excited shunt generator supplies a load of 12.5kW at 125 V, the field resistance is 25 ohms…

Q: (2) Find the Thevenin equivalent circuit between terminals (a) and (b)

Q: 1. The voltage across a 1Henry coil is given. What is the sinusoidal expression of the current when…

A: Given data: inductance of coil L=1H Instantaneous voltage e= 100sin20t Asked to find a) current…

Q: QUESTION TWO: If * (t) + 4x(t) 1 with x(0) = 0 and x(0) = 0 find the inverse laplace function.

Q: Consider the following circuit: R If the waveform given below is fed in at Vins Vou 可 then the…

A: It is a ideal differentiator circuit

Q: Two resistors, 20 Ohms and 30 Ohms, are connected in parallel. A third resistor, 24 Ohms, is…

Q: 5 kn www 1mA (c) Calculate VAB +8V www 2 kn A 3 ΚΩ 5 kn www 3 ΚΩ B 3 ΚΩ +10v www (d) Total power…

A: In this question We need to determine the Thevenin equivalent circuit, voltage across terminal A and…

Q: (b) Figure Q.4(a) is a non-inverting summing amplifier. (i) Express V, in terms of the inputs VA, VB…

Q: 3.25. Deduce expression for the magnitudes of incident and reflected voltages at any point on a…

A: To derive the expressions for the magnitudes of the incident and reflected voltages at any point on…

Q: Problem-2 A motor drives four loads, two have rotational motion and two have translational motion.…

A: Problem 2 Given Data: A motor with Moment of Inertia Jo=1.2 kg-m2 Speed N=1000 rpm Loads of,…

Q: R₁ = 240 Q NC 120 V / 12 V D₂ D₁ D₂ Voltage range: From DA R₂ = 1 KQ Potentiometer C₁ C₁ 220 μF 0.1…

Q: 6) Consider the circuit in Figure #2 that was set as an example at the beginning. Use different…

Q: Exercise: Find i, using mesh analysis. 20 V 4Ω 6Ω www. 13 2 Ω 8 Ω Answer: i = -5A 12 1+ 10%。

A: The given circuit diagram is shown below,

Q: A toroid with a mean length of 20 cm, and cross section of 2 cm², and relative permeability of 6700.…

A: Given data: The length is L=20 cm=0.2 m The cross-section area is A=2 cm2=0.0002 m The number of…

Q: 1. Given the voltage v(t) = 120cos (314t+) V, determine the frequency of the voltage in Hertz and…

Q: . Given x₁(t) = u(t) — u(t – 4) and x₂(t) = e-¹tu(t — 2), compute the following convo- lutions and…

A: Given: x1t=ut-ut-4 and x2t=e-4tut-2 Required: a x1t*x2tb x2t*δt-1

Q: the answer should be S=( (5radical3)/6 + j5/6) ) which i think is different from the one given…

Q: Determine the Norton equivalent at terminals a-b for the circuit in Fig. 4.115. 2 A www 10i, 4Ω 2 Ω…

Question

Please typing answer please Asap for like..

Find the voltage across and the current through
the capacitor both at = 20 μSec.
2~
5V
2n
+
3~2
·lov
3~
2 MF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
4. In what form is the energy of a capacitor stored?
Fill in all the missing values. Refer to the formulas that follow. Resistance Capacitance Time constant Total time 150 k 100 F 350 k 35 s 350 pF 10 s 0.05 F 1.2 M 0.47 F 12F 0.05 s 86 k 1.5 s 120 k 470 pF 250 nF 100 ms 8 F 150 s 100 k 150 ms 33 k 4 F =RCR=CC=R Totaltime=5
You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?
Assume that the current flow through the resistor, IR, is 15 A; the current flow through the inductor, IL is 36 A; and the circuit has an apparent power of 10,803 VA. The frequency of the AC voltage is 60 Hz. ET ER EL IT IR15A IL36A Z R XL VA10,803 P VARSL PF L
What is the unit of measurement for the strength of a capacitor? microamp microtorque microfarad microwatt
An inductor has a current flow of 3 amperes when connected to a 240-volt, 60-Hz power line. The inductor has a wire resistance of 15 . What is the Q of the inductor?
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?