Find VO in the figure shown by mesh equations. 4 k2 4 kN 6 kn 2 kn 2 kQ Vo 12 V

Q: Problem#4: Obtain the equivalent resistance at the terminals a-b for each of the circuits (a and b)…

A:

Q: Find the current flowing through the R N by simulation and verify the same using Norton's theorem.…

A: A simple problem on netwrok analysis. Look below for solution.

Q: Q: For the network of figure below : a. Determine re. b. Calculate Zi and Zo. c. Find Av. Vcc = 16 V…

A:

Q: Find I, in the circuit in the figure using mesh analysis. 4 V (+ 2 kN 4 kN 1 mA 2 kN 6 kN 1 mA 2 kN…

A:

Q: The following system of equations was generated by applying the mesh current law to the circuit in…

A:

Q: 3 kn 4 kn 2 kN 2 mA 12 V 6 kN + 3 kn 10 V 6 KNŽV 8V W-

A: we need to find out V0 value using NORTON theorem.

Q: The following system of equations was generated by applying the mesh current law to the circuit in…

A:

Q: In the following circuit find v-(t) and i,(t) given; v, (1) = 240 V , v,(1) = 120 V ,L =1 H , C = -F…

A: For question 4: Following steps to be followed for solving: Firstly mark positions of switch as (A)…

Q: Q4: For the network shown in figure (4), find Vab voltage indicated in the network and power factor…

A: PRESENCE OF SOURCE: In the presence of sources all the passive elements which are R, L and C always…

Q: Find the current supplied by the source, if R1 = 6 Q, R2 = 6 N, R3 = 4 S, R4 = 14 N and R5 = 14 Q R4…

A: R3 R2 R1 is short circuit

Q: super-node equation between V, & V2 in the circuit below is: 2 mA 4k/, V2 2 kn 1, V3 33 kn 36 kn 31…

A: According to question: The circuit is drawn as

Q: Use Norton's theorem to find Vo in the circuit of the figure. Take R= 4 kN. 12 k2 2 k2 10 k2 www ww…

A: Norton's theorem

Q: For the circuit shown, find the Mesh currents. R1 1Ω R5 3Ω E 7 V Vi + 6 V 2Ω R2

A:

Q: H.W. 2.18: If Req 50 Q in the circuit in Figure below, find R. Solution:R= 106 2 10 2 30 2 Reg 12 2…

A:

Q: Q.3) By using Thevenin method find the current that pass in R2. 80 0 R R, 50 2 R, 75 Q R, 75 O V. R.…

A:

Q: Solve the value of v and i in the circuit of Figure Q2(b). X=10 402 50Ω + v - XV 202 ΧΩ 10Ω 702…

A:

Q: In the network shown, Vo = 6 V. Find IS. 8 k2 4 k2 2 k2 Vo 4 kQ Is Select one: O a. None of them O…

A: To find the current Is , if Vo = 6 volts

Q: HW2 HW2: Apply Thevenin's theorem to find v, in the circuit of Figure below 4Ω 5Ω 3 A 162 10Ω E 12 V…

A: Explanation:

Q: 1) FIND THE THEVENIN EQUIVALENT Vx 1 kN 2 kN 1 kN A + + 2Vx 1 kN 2 kN В

A: In this question,   We need to determine the Thevenin equivalent circuit across the terminal A and…

Q: Find Vo in the circuit shown 6 k2 24 mA 8 k2 8 k2 6 k2 Select one: O a. 12 O b.4 Oc.38 O d.36 Oe.…

A: Find the voltage Vo  We are solving this problem using serie parallel combination and voltage…

Q: 3 kn 4 k 2 knŽ 2 mA 3 12 V 6 kN 3 kN 10 V 6 knV,

A: Redraw the circuit below.

Q: Q/ For the circuit shown below, use Mesh analysis (format approach) to find the current through the…

A:

Q: III Use Gauss-Jordan Method

A:

Q: The following system of equations was generated by applying the mesh current law to the circuit in…

A:

Q: R1=1 kN R3=1 kN Vs=9 V R2=1 kN Y

A:

Q: Find V, in the circuit shown in the figure below using Thevenin's theorem. 2 mA 6 kfl 2 kit 8 MA 382…

A:

Q: In the following circuit if Vs1=0 v , V2=6 v, Is1=6 A, and Is2=12 A for the two cases of a) R=0 Q…

A: In the circuit,  Find the current IBA  and voltage VAC  ?  If resistance R= 0 ohm R= 10000 ohm Where…

Q: For the below circuit, find v, and v2. 90 Ω 60 Ω 150 23 750 3 V v v{ 30 N 40 2

A: Voltage division is used.

Q: Find the equivalent resistance and solve for the current supplied by the d.c. source in the circuit.…

A:

Q: Find V, in the circuit below using the super position method. 12 V 6V 6 kn ww 4 k2 6 mA 6 kn V ww ww

A: We have to find the output voltage Vo of the given circuit using superposition theorem

Q: Q2. The mesh currents are labeled in the circuit shown in the figure. Determine the value of the…

A: Given,

Q: 4 ko 10 ka 6 kn 8 kn 2 kQ Vo 6 V FIGURE 2

A: Find Vo using Thevenin theorem and Milliman's Theorem ?

Q: In the following circuit, find Vo. 2Vx 1 kn Vo 1 kn 2 mA 1 kn Vx31 kn (1)2 mA +) 4 V

A: Consider the given circuit,

Q: Find Vo in the circuit shown 6 kQ 8 kQ 8 k2 24 mA 6 kN Vo

A:

Q: Q2: Find Vo using Thevenin's theorem 30 20 a 12 V (+ 6Ω; Vo 2 A

A:

Q: Q.3) By using Thevenin method find the current that pass in R2. 80 R, R, 50 Q R 75 Q Rs 50 Q Ve…

A:

Q: Find l, in the circuit below using superposition. 12 V 32 kN 6 mA 4 kN 4 kN 2 kn +1

A: By superposition theorm 1) consider 12 v is present and replace 6 mA by open circuit and consider…

Q: Use mesh equations to find for Vo in the figure shown. 3 kn 2 kQ 6 kQ )2 mA Vo 12 V

A: Given circuit,

Q: H.W// Obtain the equivalent resistance at the termi shown. 30 2 ww- 25 2 ww 202 102 ww a o ww 50 bo

A:

Q: Find l, using Superposition Theorem. 12 kn 4 mA I, 12 kn 12 kn 6v(+ 12 kn ww

A: First we will find out the current due to both source then we will find out total current.

Q: In the circuit shown, I 4 mA. Find VS. 2 k2 5 k2 Vs 6 k2 3 k2 Select one: O a. 4 O b. 38 O C. None…

A: In this question , we will find source voltage...

Q: Q1: Find the power of the 10-V voltage source? Is it supplying energy to the circuit or absorbing…

A:

Q: For the circuit shown below: (a) Find vo in terms of vs. (b) Find io for Vs = 1 V. Repeat for vs =…

A: Given data: R1=10 kΩR2=150 kΩR3=10 kΩR4=150 kΩVCC=±18 V

Q: Use the step-by-step method to find io(50 ms) in the network in the figure below. 6 kN 6 kN 6 kN 12…

A:

Q: H.W. 1.Find the equivalent resistance between points A and B in the circuit shown below. [102| 10 2…

A: Series Connection of Resistors: When n no. of resistors are connected in series, their equivalent…

Q: For the circuit shown in the figure below. Find the value of (W/L)2 (M2 size) so that l =29 uA.…

A:

Q: Find VO in the figure shown by mesh equations. 4 k2 4 kN 6 ko 2 kn 2 kQ Vo 12 V

A: Given

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.