Five engineers measure the thickness of a slab using a meter stick and a vernier caliper. One engineer got a thickness of 4.3 cm ± 0.1 cm using a meter stick, the other four engineers measured a thickness of (a) 4.32 cm ± 0.01 cm, (b) 4.31 cm ± 0.01 cm, (c) 4.24 cm ± 0.01 cm, and (d) 4.43 cm ± 0.01 cm respectively using the caliper. Which of these four measurements made by the four engineers agree with the measurement obtained by the engineer that used a meter stick? Only a (b) and (c) (c) and (d) (a), (b), and (c) none of these

Five engineers measure the thickness of a slab using a meter stick and a vernier caliper. One engineer got a thickness of 4.3 cm ± 0.1 cm using a meter stick, the other four engineers measured a thickness of (a) 4.32 cm ± 0.01 cm, (b) 4.31 cm ± 0.01 cm, (c) 4.24 cm ± 0.01 cm, and (d) 4.43 cm ± 0.01 cm respectively using the caliper. Which of these four measurements made by the four engineers agree with the measurement obtained by the engineer that used a meter stick? Only a (b) and (c) (c) and (d) (a), (b), and (c) none of these

Welding: Principles and Applications (MindTap Course List)

8th Edition

ISBN:9781305494695

Author:Larry Jeffus

Publisher:Larry Jeffus

Chapter24: Welding Codes And Standards

Section: Chapter Questions

Problem 2R: What are codes and standards?

See similar textbooks

Similar questions

What is the need for calibration of instruments? Write the steps followed in industries for calibration
What is the size obtained in the manufacture of parts and which is measured with an acceptable accuracy? 1) limit 2) actual 3) nominal
State the frameworks of the International Standards, Primary Standards and Secondary Standards of measurement.
What are codes and standards?
1. What is a vernier scale? A vernier caliper? A micrometer caliper? 2. Explain briefly the essential vernier caliper principle. 3. Give the advantage of a micrometer caliper over a ruler in the measurement. 4. Give the advantage of a vernier over a ruler in the measurement of length. 5. Explain briefly the essential micrometer caliper principle.
identify and explain the main differences between Euro 5 and Euro 6 standards?
Research and identify one type of geometric tolerances (besides obvious specs like length, distance, diameter, etc.) that can be called out on a technical drawing. Explain how this tolerance is defined
Explain at least three reasons why hardness testing is generally used for product quality control in industrial sites.
With appropriate precision (significant digits), what is 2 + 2.1?.
The following information is available for Edgar Corporation’s Material X. Annual Usage 12,600 units Working days per year 360 days Normal lead time 20 days The units of Material X are required evenly throughout the year. What is the reorder points? Assuming that occasionally, the company experiences delay in the delivery of Material X, such that the lead time reaches a maximum of 30 days, how many units of safety stocks should the company maintain and what is the reorder point? Show computation.
1. On the drawing attached, before any geometric controls are applied, what is the coaxility tolerance that is implied between the diameters?
The length of a iron bar is measured by a number of different observers and the following set of 12measurements are recorded (units mm)302,304,303,305,307,309,310,311,312,301,303,302. Find the values of mean, median, variance andstandard deviation.