Fluid mecchanics Dr. Bassssim Al-Zaidi Find the ratio of the liquids densities. Both legs are open to the atmosphere. Ра Fluid A 40 Fluid B 22 20 10
Q: contains a fl gravity of 110 kN/ m² oil of specific der 1.30 anc pressure 170
A:
Q: A 10cm diameter solid cylinder of height 10cm weighing 0.40kg is immersed in a liquid kg. (800)…
A: Given data Diameter of solid cylinder (d) = 10cm Height of solid cylinder(H) = 10cm Weight of…
Q: Please answer all questions. I will rate. Oil of specific gravity 0.80 and dynamic viscosity of 0.05…
A:
Q: There are four liquids that are to be poured in a single vessel that is located in an atmosphere…
A: The liquids will be arranged in such a way that the heavier liquid will be at bottom and lighter one…
Q: yilndrical container with liquid. The total mass of the liquid inside the container is 35slugs.…
A: Diameter =2m Height of liquid filled in container (H) = (20/2) H=10ft =3.048 m
Q: weight of water is 9810 Nm' Gasoline line is connected to a pressure gage through a double-U…
A: Given data : Acceleration due to gravity (g)=9.81…
Q: Oil flows through a 200 mm diameter pipe A at 2 m/s and through a 250 mm diameter pipe B at 1 m/s…
A: Given Diameter of pipe A =200 mm
Q: 5. The container is partially filled with oil. Water and air as shown. Determine the Air 1.25 m Oil…
A:
Q: A 10 cm diameter solid cylinder of height 10 cm weighing 0.40 kg is immersed in a liquid (800…
A: At what level from the bottom will the solid cylinder float?
Q: A fuel (S=0.87) flows through a 200mm diameter pipe at a velocity of 2.0 m/s. Determine the…
A:
Q: The tank contains a liquid having a density of 2.52 slugs/ft^3 10 in 5 ft 10 ft 7 ft Pliquid = 2.52…
A: GIVEN Density of liquid = 2.52 slugs/ft3 L = 10 ft B = 5 ft H = 7 - 10/12 = 6.167 ft Glycerine, SG…
Q: What is the pressure 1.5 m below the liquid surface?
A:
Q: - In a mano meter shown, the fluid from A to B is mercury (s-g. 13.0) and from e to C, the flud is…
A: Given data in question Specific gravity of mercury Spacific gravity of oil Pressure at point C…
Q: = 1-25 Pa.s.) fills the space of (Smm) Q,; A liquid of (N shown in figure below. Calculate the…
A: Step 1
Q: 3. Calculate the pressure due to a column of 0.4 m of (a) water, (b) an oil of sp. gr. 0.9, and (c)…
A:
Q: QI/ A tank is initially filled with ( 250 gal) in which 50 lb of salt are dissolved. salt Fresh…
A:
Q: Oil sg = 0.75 is flowing through a pipe with 6 in diameter under a pressure 15 psi. The total energy…
A:
Q: What volume flow rate in gallons per minute of oil (sg3D0.90) is in the system ? 75-mm inside…
A:
Q: Determine the mean effective pressure in kPa of a certain air -standard Diesel cycle which has a…
A:
Q: (b) Neglecting any viscous resistance from the bottom of the cylinders, what is the value of 4, when…
A: Considering the given data a=0.2 mmR1=50 mmh=80 mmM=0.0245 N.mmΩ=1.2
Q: A circular vessel 2 m in diameter and 3 m high is filled with three liquids standing 1 m high each.…
A: Given data in question Diameter and height of vessel Relative densities Area of orifice Constant…
Q: An illegal connection was observed on a 300 mm diameter horizontal pipe. Upstream from the…
A: Given, D = 300 mm ∆Pu/s = 140 kPa ∆Pd/s = 116 kPa
Q: The funnel is filled with water and oil to levels shwon. Determine the depth of oil h' that must be…
A: Given data Density of water = 1000 kg/m3 Density of oil = 900 kg/m3 Density of mercury = 13550…
Q: The average speed (in feet/second) of blood that flows in the needle if the piston being vithdrawn…
A:
Q: A CYLINDRICAL TANK HAS 2 DIFFERENT FLUIDS OF EQUAL PARTS. THE WEIGHT OF THE TANK ALONE IS 0.5kN, sg…
A: Pressure is defined as the force exerted per unit area. The pressure exerted by the fluid at its…
Q: e second is kerosene (ρ=1.591 slugs/ft3), the third is castor oil (SG=0.959), and the last liquid is…
A:
Q: If the Patm = is 101.3KPa and the Pabs at the bottom of the tank is 231.3 kPa. y of H28 = 9.79kN/M^3…
A:
Q: I Date No. An open manometer, shown in the right figuve, is in stalled to measure pressure in a pipe…
A: Open tube manometer: An open u tube manometer is the instrument that is used to measure pressure.…
Q: QI: If the air pressure in the tank B is 20Kpa, find the height h, for the oil ( s.g.= 0.8). Air Air…
A: Given PB=20KPa S.g.=0.8
Q: The elevation at point A in the tank below is 32m. Calculate the pressure (in Pa) at the surface of…
A:
Q: Choose the correct answer 1- If the dynamic viscosity of a fluid is 0.5 poise and specific gravity…
A: Since the question number to be solved is not specified, the solution for Question 01 is as follows:…
Q: Let P and T be the pressure and temperature of the super-heated vapor and Psat be the saturation…
A:
Q: H.W.6/ In Fig. the tank contains water and immiscible oil at 20°C (density of water is 998 kg/m').…
A: Given data: density of water= 998 kg/m3density of oil =898 kg/m3
Q: H.W/If we have a tank contains (1000 gal) of water in which initially (100lb) of salt is dissolved…
A: Quantity of water=1000gal Quantity of salt=100lb Rate of brine=10gal/min
Q: A large fuel tank is in the shape of a cylinder. The material for the top and bottom of the cylinder…
A: We have to determine the value of dimensions of the most economical cylinder as per the given data…
Q: Determine the height h to which liquid should be poured into the cup so that it contacts half the…
A: The expression for the surface area by Pappus-Guldinus theorem is given by, Here, is the angle of…
Q: A gas is contained in a vertical cylinder with a heavy piston. The mass of the piston is 85 kg and…
A: Given data in question Mass of piston Area Acceleration due to gravity To find out Inside…
Q: Heavy fuel oil flows at Q = 10 gallons per minute (gpm) in a horizontal steel pipe that connects two…
A: Given data Discharge Diameter Height of oil Specific gravity Specific weight Kinematic…
Q: tank contains ail sp. gr. 0.80, gasoline sp. gr. 0.90 and seawater sp. gr. 1.03. If the depths of…
A:
Q: the overall mass transfer coefficient (1/sec) for an air stripping column removing chloroform…
A: Given:- water flow = 170 gal/mincolumn diameter = 3 ftcolumn packing iincluding rashig rings =…
Q: B) Chlorine usage in the treatment of 30 MLD of water is 10 kg/day. The residual after 10 minutes…
A: To find out the dosage and chloride demand of water.
Q: Q2/ Calculate the gas flow rate in sef/day for a natural gas is following in porous media at…
A: Given :
Q: 75-mm inside diameter Flow 0.25 m 200- inside 0.60 m diameter Water
A:
Q: A flowing air has a kinematic viscosity of 1.79 x 10^-5 m2/s. It flows at a velocity of 12 m/s in a…
A: This question is related to the Fluid Mechanics. There is Option (C) is correct answer.
Q: 5-64. A thin rubber tube of 25 mm inside diameter is used to siphon water from the large tank of…
A:
Q: your solutions neatly and properly. 3 kg of steam with quality of 30% has a pressure of 12.056 bar.…
A: Vg=14.1889cm3/sec Vf=1.5289cm3/s
Q: Figure 1 represent two large tanks with an orifice in the dividing partition. The orifice has a…
A:
Q: Open Орen Water 5.5 in. 4.9 in. 3.3 in. Unknown fluld 1.4 in. For the configuration shown in the…
A: Let's start from the right of the limb:
Q: A fluid will be tested for viscosity using a Couette Viscometer. If the fluid following the Ostwald…
A: Brief concept introduction- Couette Viscometer- The Couette viscometer is a well-known device for…
Step by step
Solved in 2 steps with 2 images
- The saturated liquid of water at T=300C has total volume (v) of 0.05m3,quality(x) of 75%,vf=1.4036×10-3m3/kg,vg=0.02167m3/kg A.find the specific volume v in m/kg of two phase mixture B.find the mass (m) of water in kg C.find the mass(mg) of the satured vapor in kg D.find the mass(mf) of the satured liquid in kgA spherical tank is filled until halfway with ethyl alcohol Specific G = 0.789. The dia of the tank is 8 ft. Compute the absolute pressure in /psia/ at the bottom of the tank.An assistant pumps all the soccer ball for a tournament to 8.5 psi in the hot locker room before bringing them outside in the cold to be used. Which of the follow would happen? The soccer balls will be within regulation pressure since temperature plays no role in the pressure. The soccer balls will explode from increased pressure The soccer balls will deflate from decreased pressure
- Glycerin (sg = 1.26) t 40°C flows in the portion of the duct outside the square tubes as shown in the figure. Calculate the Reynolds number for the flow rate of 0.10 m3/s and dynamic viscosity is 0.30 Pa-s.a) determine the unit weight of the liquid when it is at the level shown b) determine the weight of the liquid express your answer in appropriate ENGILISH unitA U-tube with both ends open to the atmosphere contains glycerol in the lower portion. In one leg, water stands 0.76m above the surface of the glycerol; in the other leg, oil (sp gr=.80) stands 0.46m above the surface of the glycerol. What is the difference in elevation between the surface of the oil and water columns draw figure
- An open cylindrical tank 6m in diam and 12m high is filled with 6m of oil (sp. gr. = 0.80) and 6m of water. An orifice 75mm in diam is located at the bottom. If Cv = 0.98 and Cc = 0.65 for the orifice;a.) Find the time for the liquid in the tank to be at a depth of 4m.b) Find the time to empty the container from its original content.A 7.5 cm diameter orifice (Cv= 0.95, Cc= 0.65) is under ahead of oil (s=0.72). Determine the pressure of the air on the oil surface so that the available power in the issuing jet of oil is 6kW. Include a diagram in your solution. a.86 kPa b.76 kPa c.56 kPa d.66 kPaThe unit weight of water at 50°F is 62.4 pcf. If the volume of the vessel that contains water is 3.50ft³. A. What will the be the change volume when it is heated to 160°F ( unit weight of water is 61 pcf 160°F) B. Compute the percentage change of volume C. What weight of water must be removed to maintain the original volume (Our Subject is FLUID MECHANIC)
- The pipe is 25mm with friction factor of 0.022. The second tank is vented. H1=1.4m H2=4.5m H3=1.0m X1=14.9m X2=2.7m Calculate the pressure(kPa) above the gasoline in the first tank that will result in a flowrate of 400 liters/min.Find the volumetric flow rate of the oil in m3/s thank you!!Kerosene is placed inside a glass capillary tube having a radius of 0.5 mm. The kerosene inside the tube is measured to have a standing height of 59mm. Determine the true static height of the kerosene using a surface tension value of 0.035 N/m and Sg=0.8.