Follow the standard energy balance steps to determine the water condensed and the heat removed from a humid air stream. The feed stream contains 12 wt% water (balance is air), has a temperature of 250°C and a pressure of 1 atm. The exit gas stream is at 1 atm and 25°C. The exit vapor composition should be determined from the psychrometric chart (saturated). The heat of vaporization of water at 25°C is 44.0 kJ/mol. a. Draw a picture and label appropriately (Basis: 1 kg/s feed). b. Perform a degree of freedom analysis. c. Write appropriate equations. d. Complete all material balances. e. Specify reference states.

Q: A rigid tank is divided into two rooms, both containing water, separated by a membrane. Room A…

A: Given that For romm APA =200 KPav =1 m3For room B PB =0.5 MPaT =400 CTs =100 Cmb = 3.5 kg ma   =2 kg

Q: 1. You have 14.7 mol of a mixture that is 32mol % methanol, 29mol% water and 39mol % methyl acetate.…

A: Given, The moles  of the mixture, n = 14.7 mol The mole fraction of methanol, x1 = 0.32 The mole…

Q: Question C2: Plug-flow reactor The following irreversible, first-order, gas phase reaction occurs at…

A: Given thatn=1PFRv=2 m3k=0.69 min-1x =99 %

Q: 33. Viscous flow in a plunger-M. A tube of diameter D = 2.0 cm and length L = 100 cm is initially…

A: Given data: Diameter of tube = 2 cm Length = 100 cm Density of the fluid = 1 g/cm3 Viscosity of the…

Q: Problem 3 A heat engines operates between a lake's surface water at a temperature of 300 K and water…

A: Given, The surface temperature, T1 = 300 K The temperature of the water, T2 = 285 K The power…

Q: Problem: Methanol is produced by reacting carbon monoxide and hydrogen. A fresh feed stream…

A: Methanol is synthesized by the reaction of CO and H2.

Q: Question) Draw the following by the Chemdraw and write the Molar Mass?

A: 3-nitro-2,4,6-trimethylaniline = molar mass = 135.21 g/mol

Q: An organic solution is to be concentrated from 15 wt.% to 65 wt.% in a single-effect evaporator. The…

A: Given that- Feed concentration, xf=15 % = 0.15 Product concentration, xP=65% =0.65 Inlet steam…

Q: Consider this reaction: A + B products The following data was obtained at a certain temperature. 1…

A: given details: the reaction, A+B→products the data is given, we need to determine the order of the…

Q: A tube with outer diameter of 2 cm is maintained at uniform temperature and is covered with an…

A: Given  Tube outer diameter D1 = 2 cm Radius R1 = 1 cm k = 0.18 W/m .K h = 12 w/m2 .K

Q: 7-Air, at 100 °C, flows through a thin-walled steel tube with an inside diameter 25 mm. The wall…

A:

Q: 1. The mixture containing 40% Benzene by Weight - 60% Toluene shall be distilled in a continuously…

A: given information, the feed contains benzene(B) and toluene(T) and it is at its boiling point or its…

Q: 67. The temperature of a 3kg oxygen occupying 0.31m³ is 26°C, while the pressure remains constant at…

A: 67 . Given Data : Mass of oxygen, m= 3 kg Initial volume, V1 = 0.31 m3 Initial temperature, T1=…

Q: QUESTION 4 Pure water vapor pressure reaches 760 Torr at 100°C, and the vaporization enthalpy is…

A:

Q: What do you mean by an excess of the reactant?

A: we need to define the term Excess of reactant.

Q: 8 cm thick in 10-What is the maximum temperature is aplane wall which that is generated uniformally…

A: Write the expression for the one dimensional heat conduction as follows: d2Tdx2 + q˙k = 0ddxdTdx +…

Q: If the reaction 2H₂S(g) 2H₂(g) + S2(g) is carried out at 1065°C, Kp = 0.0120. Starting from pure H₂S…

A: Given that T=1065 CKP =0.0120.30 atm of H2

Q: Temperature Profile in a Packed Tube Distance from the entrance of reactor (m) 0.0000 0.0938 0.1875…

A: In the case of a packed tube, we know the maximum temperature gradient that occurs during the…

Q: Methanol (CH3OH) and acetic acid (CH3COOH) react in the gas phase at a temperature of 170°C to form…

A: Given data: Equilibrium constant = 3.87 Initial number of moles of methanol = 92 mol Moles of…

Q: A gas that behaves ideally has a density of 1.92 g dm^3 assuming air behaves as an ideal gas,…

A: Given data: Density of gas = 1.92 g/dm3

Q: Select which of the following standard enthalpy of formation values is not zero at 25 °C: Check all…

A: The standard enthalpy of formation of elemental form any atom is equal to zero.

Q: A power plant needs to evaporate 3000 kg/min of water at 50 C at a constant 1 bar of pressure.…

A: Water is evaporated with the help of superheated steam in a power plant.

Q: Agas mixture as shown in table bei ous. Calculate total Specific grivity and Compressib Factor at…

A:

Q: 4. For every 1000 feet deep in the ocean, the temperature falls 4.5°F. If the temperature at sea…

A: Given details: for every 1000 ft , temperature fall,∆T=4.50F temperature at sea level,Ts=900F we…

Q: Consider a reaction where A is converting to B. A B The reaction is known to be of first order and…

A: Write the reaction as follow: A→ B   The molar flow rate of A, FA0 = 0.4 mol/s

Q: Sulphur can be recovered from underground elemental deposits via the Frasch process. In this…

A: Given thatT =165 CP = 2.5 MPaPT  = 6 atmρl  =1.811 gml =1.811 x 106  gm3ρs  =2.050 gml =2.05 x 106…

Q: An absorption tower is fed with an aqueous stream containing 3 wt% propane. Countercurrently,…

A: Given data are as follows: Propane percent in aqueous stream = 3 wt% Propane percent in gaseous…

Q: Enlist different production processes for the product Vinyl Acetate, and select the suitable…

A: Dear User ! As per our authoring guidelines, we have solved the first of the three independent…

Q: X(s)- G₁(s) G₂ (s) G3(s) G4(s) G5(s) Ge(s) Y(s)

A: Given block diagram is

Q: The rate constant for the second-order reaction: 2NOBr(g) 2NO(g) + Br₂ (g) is 0.80 at 10.0 °C.…

A:

Q: Question) Draw the following by Chemdraw and write the Molar Mass?

A: 1) 4-chlorobenzaldehyde molar mass = 140.57 g/mol 2) 2-Pyrrolecarboxaldehyde molar mass = 109.13…

Q: 7.18. The compressed-air-driven water rocket shown in Fig. 7.26 is ejecting water vertically…

A:

Q: Draw The Structures?

A: 1) Z-Butenedioic acid 2) 2,5-dimethyl benzoic acid

Q: by the deadline. Solutions must be uploaded in pdf form. 4. A stainless-steel vessel with a volume…

A:

Q: How did you get 1/9 and the (4x+3)^2/(x-1)^2

A:

Q: Find the pressure of a mixture of CH4 (0.25 kmol) + n-C4H10 (0.25 kmol) at T=250 C and V = 0.241 m3…

A:

Q: Enlist different production processes for the product Vinyl Acetate, and select the suitable…

A:

Q: 6. (Kittel 6.12) Ideal gas in two dimensions. (a) Find the chemical potential of an ideal monatomic…

A: Given monoatomic ideal gas in two dimensions. Number of atoms confined in area A = N

Q: Calculate the AHO for the reaction: Fe³+ (aq) + 3OH(aq) Round your answer to 3 significant digits.…

A: following reaction is given in the question Fe3+ aq  +  3OH-aq    → FeOH3 s

Q: 1. A certain fractional-distillation apparatus contains a 24-cm Vigreux column stacked on top of a…

A:

Q: Consider a following reactive system. Calculate the ratio of N₂ to C₂H4 in the feed? 350 mol C₂H.…

A: Given that2C2H4  →C4H8350 mol is given in the reactor

Q: Start a HAZOP for the Feed Heater of a Hydrodealkylation (HDA) Process

A: Introduction HAZOP (Hazard and Operability Study) is a systematic way to identify possible hazards…

Q: The following data was obtained for the phenol-o-oresol system based on the assumption that the…

A:

Q: Can you reword this for me to have a better understanding: Plastic items like bottles and bags are…

A: To reword the given text for a clearer understanding to the user

Q: X (s) Gy(s) G₂ (s) G₂(s) G5(s) Gg(s) G₂ (s)

A:

Q: In a pipe 15 meters long (L) and which is also saturated with nitrogen, a stream of oxygen diffuses…

A: Given data: Length of the pipe = 15 m Temperature = 0 0C Pressure on the left side = 20 kg/m3…

Q: What mass of gallium oxide, Ga₂O3, can be prepared from 29.0g of gallium metal? Use the equation:…

A: Mass of gallium = 29 gram Mole of gallium = 29/69.72                            = 0.4159495123

Q: e velocity profile Expression for the flow rate

A:

Q: 1. Discuss the different types of viscosity, units used to express viscosity, and types of viscosity…

A: NOTE:-“Since you have asked multiple questions, we will solve the first question for you. If youwant…

Q: 2. You need to design a heater to preheat a gas flowing into a chemical reactor. The inlet…

A: a) Inlet of the heater  temperature is 300K and the pressure is 50 bar hence Z is The outlet of the…