following formula: Fall 2022 The power of an electrical device can be calculated using the P = V² R' where P is the power measured in watts, V is the electric potential ('voltage') measured in volts, and R is the resistance measured in ohms. Part (a): Calculate the power of a hair dryer that has a resistance of 14 ohms and operates at 120. volts. Show your work, and ensure that each numeric value has the appropriate units. You do not have to show which digits are significant in your intermediate calculations, but your final answer should be rounded to the appropriate number of significant digits.

following formula: Fall 2022 The power of an electrical device can be calculated using the P = V² R' where P is the power measured in watts, V is the electric potential ('voltage') measured in volts, and R is the resistance measured in ohms. Part (a): Calculate the power of a hair dryer that has a resistance of 14 ohms and operates at 120. volts. Show your work, and ensure that each numeric value has the appropriate units. You do not have to show which digits are significant in your intermediate calculations, but your final answer should be rounded to the appropriate number of significant digits.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 250 ft long span separates a dc power supply from a lamp which draws 25 Aof current. If 14 AWG wire is used (note that two wires are needed for a totalof 500 ft), calculate the amount of power wasted in the wire
I need very QUICK answers, PLEASE. A coal-fired thermal power plant produces 1100MW of power annually with an efficiency of 44%. The annual operating rate of the plant is 70%. It is desired to establish a Solar Power Plant instead of this power plant. Calculate the required Solar Cell area since the power density of the solar cells used in the power plant to be established is 100W/m^(2).
Four cubic meters of water is to be heated by means of four 1.5kw, 230V immersion heating elements. Assuming the efficiency of the heater as 90%, determine the time required to boil the water if the initial temperature is 20 degree celcius and if all elements are connected in parallel.
6.) A room measures 4mx7mx5m and the air in it has to be always kept 20 degree celciuslower than that of theincoming air. The air inside has to be renewed every 30 minutes. Assuming 75% efficiency, calculatethe HP rating of an air-conditioning unit suitable for this purpose. Take specific heat of air as 0.24 andits density as 1.27 kg/m^3.
Solve the following problems below. Show complete solution. 1. A CFL or compact fluorescent lamp uses less energy that its equivalent incandescentbulb. How much will a person save of he uses a 30 W CFL instead of 100 W incandescentlamp for 7 hr in 30 days? Electricity is priced at 9.55 php / kW.hr
Heat energy is often measured in calories and 1 calorie = 4.184 Joule. It is desired to design a heating element to boil a certain amount of water in 2 min requiring 40-kcal heat energy. If the heater is to operate at 110-V, calculate its current and power ratings.
You have a cabin in the Colorado wilderness far away from civilization and wantto install a small hydro generator to provide electricity. A stream runs down a hill behind your cabin where you can construct a simple run-of-river hydro installation. You calculate that the effective head of the installation is 25 feet and that water would flow through the system at a rate of 50 cubic feet per minute. The simple inexpensive hydro turbo-generator (turbine mated with electric generator) that you intend to buy has a working efficiency of 60%. Answer the following (show your work):a.How much power can you generate with this system?(1.06 kW)b.How many 100 watt light bulbs can you power with this hydro setup?(10 bulbs)c.What type of turbine would you expect to find in your turbo-generator? Why?
Design a 25V solar PV panel system that can power a home that requires two 30-Watt lamps and four 15-Watt fans for 6 hours daily if the factors for the solar panel generation and the total energy losses respectively are2.92 and 1.3. Take the rating of the available solar PV cell as 5V, 5W
A house has the following electrical appliance usage: - One 32 Watt fluorescent lamp with electronic ballast used 6 hours per day. - One 75 Watt fan used for 3 hours per day. - One 100 Watt refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours. - The system will be powered by 12 Vdc, 110 Wp PV module. e) What is the Total Ampere-hours required for the battery in Ah for 3-day autonomy? (Round off your answer to three decimal places. Do not put comma in numerals)
A certain appliance requires 225 watts when it is switched on. How much would it cost to run for m minutes, at a cost of d dollars per kilowatt-hour? Express your answer algebraically.
A 500 W heating coil, designed to operate at 110V, it is made of 0.500mm diameter nichrome wire. a) If the resistivity of nichrome remains constant at 20.0 ° C, determine the length of the wire used. b) What will be the power given to the coil from part (a) when heated to 1200 ° C? c) If the electric company charges B/0.16 per kW-h, how much you will have to pay to keep the heating coil working at this temperature for 45 minutes?
An office space measures 50ft x 90ft with 16ft high walls. A 1.25 air changes per hours is desired for this space. Find the heat loss (in btuh) when the indoor temperature is 70°F and the outdoor temperature is 36°F. Select one: a. Q = 56,100 btuh b. Q = 44,880 btuh c. Q = 37,736 btuh d. Q = 75,900 btuh e. Q = 64,350 btuh