For a causal discrete-time LTI system, it is observed that the input signal x[n] = >"u[n] produces the output yln] = >"u[n] + >"u[n]. %3D a) Find the transfer function H(z) of the LTI system. b) What is the difference equation characterizing the LTI system? c) What is the frequency response H(jN) characterizing the LTI system?

For a causal discrete-time LTI system, it is observed that the input signal x[n] = >"u[n] produces the output yln] = >"u[n] + >"u[n]. %3D a) Find the transfer function H(z) of the LTI system. b) What is the difference equation characterizing the LTI system? c) What is the frequency response H(jN) characterizing the LTI system?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Evaluate the discrete-time convolution sums given below. Also, obtain the same result usingDTFT(i.e., DTFT and then inverse DTFT) for both cases. a)y[n]=u[n+3]∗u[n−3] b)x[n]=u[n]−u[n−2], h[n]=(0.5)nu[n] this is a signal systems question
a) Given a transfer function of a linear time invariant discrete system as?(?)=?3+?2?3−1.7?2+0.8?−0.1.i) Determine the impulse response of the LTID system.ii) Determine the difference-equation representation of the system.iii) Determine the output of the system if the input signals?[?]=(2)??[?−1].b) Assume a filter with a transfer function of ?(?)=?3−1.7?2+0.8?−0.1, implement cascade form of flow graph of the filter system.
For the discrete time system whose Z transfer function is given by, G(Z) =y(Z)/x(Z)= (Z+4)/(Z^3+3Z+2) Determine the state model in controllable canonical form.
A robotic system with transfer function ?(?) =(100)/(s(0.1s+1)(0.1s +1)) is controlled with gain K as shown in the figure. A)To analyze the frequency response of this system, draw the Nyquist graph. B)Apply the Nyquist stability criterion. C)Verify the stability analysis you made in part (b) by plotting root locus plots for the positive and negative values of the K gain. D)Calculate the gain value that makes this system borderline stable and show it on Nyquist and Root locus graphs. E)Calculate the gain margin, phase margin, gain crossover frequency and phase crossover frequency values. F)Explain whether the system is stable over the gain margin and phase margin values. WE NEED TO SOLVE THE PROBLEM IMMEDIATELY. PLEASE HELP.
Given the signal flow graph, apply Mason’s Rule to acquire the single transfer function, G(s). Express your transfer function in a form where the coefficient of the highest exponent of s in the denominator is equal to 1. If there is a numerical answer that is nonterminating, it should be expressed up to three (3) decimal places only.
A process has the third-order transfer function (time con-stant in minutes),Gₚ(s)=2/(0.5s+1)³Also,Gᵥ=0.1 and Gₘ=10. For a proportional controller,evaluate the stability of the closed-loop control systemusing the Bode stability criterion and three values of K꜀:1,4, and 20.
Classify the transfer function to proper and improper. Plot the s-plane and find the system stability.
Determine the z-domain transfer function for each of the following LTI systems. The impulse response for these expressions is denoted by h[n], the input signal by x[n], and the output signal by y[n]. Provide your response as the ratio of two finite-order z polynomials or as a z polynomial of finite order. Assume that the input signal starts at n = 0 or later in every scenario. For n < 0, further suppose that y[n] = 0. Indicate if the system is IIR or FIR.
The speech signal xa(t) is bandlimited to |F| < 8kHz. It is desired to filter the analog signal with a bandpass filter that will pass all frequencies between 200 Hz and 6kHz. This is done by the set up in the image where h[n] is a discrete time filter. A) What is the Nyquist rate for the input signal? B) Sketch the necessary H(w) if the sampling rate Fs is equal to the Nyquist rate. C) For this problem, it's possible to sample below the Nyquist rate and still produce the desired output ya(t). What is the lowest sampling rate Fs that makes this possible and what is the corresponding H(w)?
A digital communication link carries binary-coded words representing samples of an input signal, xa(t)=3cos⁡(600πt)+2cos⁡(1800πt)The link is operated at 1,000 samples/s. (a) What is the folding frequency? (b) What is the Nyquist rate for the signal xa(t)? (c) What are the frequencies in the resulting discrete-time signal x(n)? (d) Will there be any aliasing here? (e) Which frequency will alias to what frequency
For each of the transfer functions given below, align the zeros and poles of the system in the s-plane. By showing the transient response expected to give the unit step input of the system, it starts from the poles of the system.Draw approx.
Consider a DT LTI system with impulse response h[n] = 2e0.2n , for n = 0, 1, 2,.... What isits output y[n] excited by the input u[n]? Compute y[n] for n = 0 : 3 if u[n] = 1/(n + 1) forn = 0, 1, 2,...