For a given one-lane approach of a signalized intersection, the base free flow speed is 40 mph, flow rate is 450 vphpl, saturation flow rate is 1,800 vphgpl, cycle length and red interval are 90 seconds and 30 seconds. Compute the following: The total time duration from the first vehicle in queue to the last queued vehicle being discharged per cycle The longest queue length and total number of vehicles in queue per cycle; Total vehicle-hours of delay and average delay per vehicle per cycle.

For a given one-lane approach of a signalized intersection, the base free flow speed is 40 mph, flow rate is 450 vphpl, saturation flow rate is 1,800 vphgpl, cycle length and red interval are 90 seconds and 30 seconds. Compute the following: The total time duration from the first vehicle in queue to the last queued vehicle being discharged per cycle The longest queue length and total number of vehicles in queue per cycle; Total vehicle-hours of delay and average delay per vehicle per cycle.

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter8: Intersection Control

Section: Chapter Questions

Problem 26P

See similar textbooks

Similar questions

TRANSPORTATION ENGINEERING-TRAFFIC SIGNALS" Recent analysis at an approach to pre-time signalized intersection indicate that the volume-to-capacity ratio (v/c) is 0.8, htat saturation flow rate (s) is 1600 vehicles/hour, and the effective green time is 50 seconds. If the average delay, assuming D/D/1 is 11.25 seconds per vehicle, determine the arrival flow rate (vehicles/hour) and the cycle length.
The southbound approach of a signalized intersection carries a flow of 1000 veh/h/ln at a velocity of 50 mi/h. The duration of the red signal indication for this approach is 15 sec. If the saturation flow is 2000 veh/h/ln with a density of 75 veh/ln, the jam density is 150 veh/mi, determine the following:a. The length of the queue at the end of the red phaseb. The maximum queue lengthc. The time it takes for the queue to dissipate after the end of the red indication. What do you understand by traffic engineering? Explain.
The southbound approach of a signalized intersection carries a flow of 1000 veh/h/ln at a velocity of 50 mi/h. The duration of the red signal indication for this approach is 15 sec. If the saturation flow is 2000 veh/h/ln with a density of 75 veh/ln, the jam density is 150 veh/mi, determine the following: a. The length of the queue at the end of the red phase b. The maximum queue length c. The time it takes for the queue to dissipate after the end of the red indication.
An approach to a signalized intersection has a saturation flow rate of 1800 veh/h. At the beginning of an effective red, there are six vehicles in the queue and vehicles arrive at 900 veh/h. The signal has a 60- second cycle with 25 seconds of effective red. What is the total vehicle delay after one cycle (assume D/D/1 queuing)?
Observation post reveals that 8 vehicles passed through at intervals of 4.6 s, 6.23 s, 5.9 s, 7.1 s, 4.9 s, 3.8 s, 12.6 s, and 13.0 s, respectively. If the total distance travelled by the vehicles is 200 meters, i. If the density of traffic is 20 vpk, compute the rate of flow of traffic in vph. ii. If the speed limit imposed along the roadway is 100 kph, determine the percentage of speed limit violators.
An approach to a pretimed signal has 32 seconds of effective green, a saturation flow rate of 1800 veh/h, and a volume-to-capacity ratio less than 1. If the cycle length is 115 seconds and the overall delay formula (Eq. 7.27) estimates an average delay that is 38 seconds greater than that estimated by using just the uniform delay formula, determine the vehicle arrival rate in veh/h. (Assume the signal is isolated and d_3 = 0.
A simple four legs intersection needs a fixed time signal and the traffic flow condition is shown as below. Determine (a) the critical flow in N-S and E-W directions. (b) Find out the saturation flow if saturation headway is 1.5s. (c) Determine the cycle length and distribution of green time (suppose the lost time per phase is 4.2 seconds)
The minimum cycle length for an intersection is determined to be 95 seconds. The critical lane group flow ratios were calculated as 0.235, 0.250, 0.170, and 0.125 for phases 1–4, respectively. What Xc was used in the determination of this cycle length, assuming a lost time of 5 seconds per phase?
An approach to a pre-timed signal has 40 sec of effective green in a 75-second cycle.The approach volume is 700 veh/h and the saturation flow rate is 1600 veh/h.Calculate the time to queue clearance after the start of the effective green, themaximum number of vehicles in the queue, the total vehicle delay per cycle andthe average delay per vehicle assuming D/D/1 queuing.
Cars have a long queue at a stop sign. If the total time delay queueing is one min., compute the traffic intensity if the service rate of the road is only 360 veh/ hr. Assume both arrival and departure rates are exponentially distributed.
Compute the average approach delay per cycle, given the saturation flow rate of 2400 veh/h and is allocated 24 seconds of effective green in an 80-second signal cycle. Flow at the approach is 500 veh/h. Assume the traffic flow accounts for the peak 15-min period and that there is no initial queue at the start of the analysis period.
Vehicles arrive at an intersection approach at 550 veh/h at the beginning of an effective red and 15 vehicles are left in the queue from the previous cycle (end of the effective green). Due to peak hour congestion, the arrival rate increases 50 veh/h/min. Therefore after 1 minute, the arrival rate will be 600 veh/h, after 2 minutes it is 650 veh/h. The saturation flow rate of the approach is 1800 veh/h, the cycle length is 65 seconds, and the effective green time is 30 seconds. Determine the total vehicle delay until complete queue clearance. (Assume D/D/1 queuing).